Flashing trasmission gear panel - 2004 Audi A4

If the OD light is flashing then you have faults, it maybe the scan tool can't read the Trans control module codes.

The computer put the trasmission in limp mode it sees a internal problem in the trany get the car pass on a scanner to find out the code or go to a trasmission shop

check gear box oil level if there is not enough oil in system it doesent go into gears properly

Sounds like your alternator stopped working....

Sounds like the clearances are mis-adjusted or a friction plate is mis alligned ......before taking it some where i would deff. check fluid level first

hi mate , sounds like the SPIGOT bearing its a little bearing that allows the gearbox to be at a different seed than the engine flywheel and if this is in bad condition it will take the gearbox front shaft to a higher speed than comfortable for gearshift , in the meantime when you go for 1st or reverse gear just engage a gear like 4th without taking your foot off the clutch and then go for 1st or reverse, this will stop the gearbox spining long enough for a smooth shif, oNLY USE THIS METHOD WHILE STaTIONARY and see a professional when you get time.

you didn't make clear you have a automatic trasmission or manual?
if is a manual trasmission you have to look the clutch and to valves that is puting the trasmision oil pressure to move the clutch one at the end near the gear box and the second after the clutch pedal outside of the cabin imediatley after the pedal. you have to look to the oil level in the rezervoir, if you dont have the problem to bay some oil and to change completely the oil first maybe the right solution to begin with oil change first , may be is freeze from the dirties finded in the oil pipes and valves.
if you have the automatic trasmission sorry i dont know, because the problems there are more complex.

is it when the car is in 3rd gear automatique trasmission and change to lock up mode if its what you call that its lock up selenoid its on the driver side of trasmission on the side cover its call lock up switch too please dont forget to rate this if its a fixya its better for me thank you advance

one of 2 things. 1 the reverse gear is out on transmission or 2, the trasmissions on chrysler are bad about computer module in transmission going bad. either way you are looking at a transmission rebuild. i use to have alot of plymouths and dodge taxi cars and a rebuild was usually 1500.00 you can get a good low mileage trasmission from a auto salvage for alot less.

you got to get the car on a scanner trasmission problem if you whant disconnect the battery for a few minute and reinstall check it out pierre