it's a little bit of a squeeze. better to undo the rubber intake pipe and remove it (hose clamps on each end use a flat head screwdriver or 8mm socket). there are only two clip you can undo by hand on the filter housing. the half of the housing that comes off is the side towards the engine. you have to lift it up slightly because it has tabs at the bottom that fit into the other half. usually you can slide the filter out from the gap you've created.
This is difficult. It is located on the driver's side, in the engine compartment inside the black box. It has two latches, which you undo and then you pry it apart and slide the old one out and the new one in. It is a pain in the behind to do, but if you're up for a little adventure...
I need to replace the oxygen sensor (both) and I don't know where they are located. do you have a...
(More)
I need to replace the oxygen sensor (both) and I don't know where they are located. do you have a diagram that can show me were tthey are?
2003 Mazda MPV hard start every morning. Starts / runs fine all day. When the vehicle sits overnight...
(More)
2003 Mazda MPV hard start every morning. Starts / runs fine all day. When the vehicle sits overnight and temperature drops to under 55 degrees, it often takes several tries to get it started. Ran diagnostic with codes: P0102 (MAF), P0113 (IAT), P0335 (Crankshaft Position), P0421 (Warm Up Catalyst), & P0306 (Cylinder Misfire).Need your advise. Thanks.
While driving my 2000 MPV V6 bucks, almost like it is going to stall, we replaced the computer with...
(More)
While driving my 2000 MPV V6 bucks, almost like it is going to stall, we replaced the computer with aused one and that helped for a while
I have a mazda mpv and the cooling fan control unit and fan assembly needs replaced as the cooling...
(More)
I have a mazda mpv and the cooling fan control unit and fan assembly needs replaced as the cooling fan runs constantly. Is there an engine diagram for this this vehicle so i can see what sort of work is involved