Question about 1996 Plymouth Voyager

2 Answers

The Engine Light stays on

My 1996 Plymouth Voyager 3.3L recently displayed a illuminated engine light warning.
We have checked the gas cap, spark plugs, changed the air filter, and the oil and filter...running out of solutions.
Could it be the fuel filter?
Thanks so much for your help!

Posted by on

  • Mike Butler
    Mike Butler May 11, 2010

    Not 100% sure where cut off date was for those but you may be able to cycle key, on, off, on, off, on . If check engine light starts to flash count them. Flash, flash, pause, flash,flash, is code 22. Flash, pause ,flash, is code 11. always 2 digits. 5 flashes, pause 5 more, is code 55 end of codes. let us know if it works and if yes, what they were.



2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 15 Answers

You really need to take it to a mech. and get them to hook up a computer to it and see what codes it findsand get that fixed or he can reset th computer so the light goes off but if there is a problem than the light will just come back on.once u see what the code is than u can go in the right direction of getting it fixed so the light will stay off

Posted on Apr 19, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 334 Answers

Did you get your engine scaned? a bad 02 senser will trun on the engine light on .no a fuel fulter will not trun your engine light on ok

Posted on Apr 19, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

1994 Plymouth Voyager 3.3 The "Check Engine Light" comes on after driving 6 miles on open highway.

Take to local auto parts store and they will usually run codes for free and from there you can find the most likely source of the problem area.

Jun 09, 2012 | 1994 Plymouth Voyager

1 Answer

1996 plymouth voyager won't start replace cam sensor and crank sensor still won't start just turning over

Back to basics. You need spark, fuel, and compression (manifold vacuum). Before you replace any more parts, check to make sure that you have no stored codes. If your check engine light is on, retrieving the codes will point you in the right direction. If you have to, tow it down to your local Autozone. They will scan it for free! If the check engine light in not on, the problem is most likely the fuel system. So, locate the fuel pump relay under the hood next to the driver side front fender. Remove it and CAREFULLY remove the top by lifting the two clip tabs with a small screwdriver. reinsert the relay and crank the engine while observing the relay to verify that the relay pulls min. That is, that the contact moves. If it doesn't, check the fuse and the relay itself. (Swap the AC clutch relay, they're the same). If it does, try manually closing the relay with the key on while someone listens at the open fuel opening, (take the gas cap off first) If you don't hear the fuel pump running, it is probably the pump. Please note that I own a 97 voyager that is very hard to start, and I have often had to manually operate the fuel pump relay in order to prime the engine so that it will start. Hope this helps!

May 02, 2011 | 1996 Plymouth Grand Voyager

1 Answer

Got Tune Up, but failed smog because Check Engine light is on.

I take it your talking about "check engine" light. Have you tried disconnecting battery for a minute or so? If light comes back on, try cycling your key just to "On", off, on, off, on & then leave in "On" position (not start) & count flashes of check engine light. Will be 2 digits, for example: 3 flashes, pause, 3 more will be code 33. 2 flashes, pause then 5 flashes would be code 25. Write them down & lets see what you get,and let us know. code 55 means end of message.

Sep 11, 2009 | 1996 Plymouth Voyager

1 Answer

No Spark!

You will need to replace the ecm.

Mar 25, 2009 | 1996 Plymouth Voyager

1 Answer

1996 plymouth voyager mini van engine stays on, 500.00 complete tune has been done engine light went off but came back on less then a mile from Pep Boys.

A tune up in most cases has nothinf to do with a check engine light, unless the engine is missing, go to Autozone or Kragen auto and ask to have the OBD system checked for trouble codes, then post them here and we will look at them, the test by the way is free.

Mar 02, 2009 | 1996 Plymouth Voyager

1 Answer

Will not start

try the electronic key ignition switch.

Nov 26, 2008 | 1996 Plymouth Voyager

1 Answer

Hard to start

Check the enginer codes by turning the key off an on 3 times in 5 seconds. The check engine light will flash. Just count them. Note a short flash is a 2 diget number. It sounds like your TPS is the prob. Frankster016

Oct 23, 2008 | 1996 Plymouth Voyager

Not finding what you are looking for?
1996 Plymouth Voyager Logo

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides