Question about 1987 Ford Ranger

1 Answer

Ok was low on fuel ,got some then went across the street shut it off . tried to start it just spins .Wont start i have spark an fuel. changed fuel filter timing gears and mod ,still wont start,, theres fuel going to injectors

Posted by on

  • codytiger Apr 19, 2009

    thanks did that still no luck

  • codytiger Apr 19, 2009

    also new plugs wires spark plugs cap an rotor still wont start can hear fuel pump working ....

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sergeant:

    An expert that hasĀ over 500 points.

    Champion:

    An expert who has answered 200 questions.

  • Expert
  • 255 Answers

Try to start it with some ether

shack

Posted on Apr 19, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Car start but wont idle shut off


Could be fuel starvation or idle control valve

Jul 02, 2015 | Cars & Trucks

2 Answers

After changing fuel pump and crank sensors, car won't start. 1999 Lincoln contintal


wouldnt start before all that or just after, (hummmmmmm)
wont crank or cranks robustly but wont start.
check fuses yet?

May 12, 2015 | 1999 Lincoln Continental

1 Answer

1999 chrysler cirrus 2.5l won't start


The ECM sends a GND signal to the Fuel Pump relay to switch it ON. When 'jumping' relays, there is a risk that you might feed +12V to Gnd switch line, in this case the ECM line. If left too long, this would blow the diodes in the ECM. Try using another ECM. Try following the ignition circuit from the ignition coil back to the ECM. One of the wires connected to coil should have +12v when IGN on. Sparking only happens when ECM sends GND pulses to the coil. If ECM is OK, check camshaft position sensor, which is also usually referred to by the ECM for ignition firing.

Jun 12, 2014 | 2004 Volkswagen Passat

1 Answer

Restarting problem on 84 d150


change your fuel pump relay.

Dec 22, 2013 | Dodge Cars & Trucks

1 Answer

2004 325xi BMW wont start - replace spark plugs and fuel pump


If u hear the engine cranking in the AM, the batt & alt sound good. If you don't get any engine cranking in the am you may have an electrical short draining the battery. Before u convict the starter u must make sure the battery has full power in the AM. (12V) & 12 V to the starter

Apr 10, 2017 | 2004 BMW 3 Series

1 Answer

Car turns over but won't start.


Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.


To confirm the problem, the basic troubleshooting is required.


Click this link below and follow the troubleshooting:------

http://technoanswers.blogspot.in/2012/02/car-starting-issues.html

---------

This will help.

Thanks.

Feb 07, 2012 | 1999 Lincoln Town Car

1 Answer

We havnt changed the oil in a very good while n today i was drivin down the street n it started stupping n shut off i thn tried to crank it and it will start thn stupper thn cut bak off i thn tried to put...


low oil wont cause this problem did your oil light come on and was the oil low cause if not adding to much oil can damage the motor it might be time for new spark plug wire basically a tuneup when was the last time u had one

Sep 18, 2009 | Pontiac Grand Am Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...