Question about 1995 Jeep Wrangler

2 Answers

Wont start, new battery, relay good, starter good.

2001 4.0 wrangler wont start, battery new, starter good, relay good, what else can i try?

Posted by on

  • 3 more comments 
  • consuming805 Apr 19, 2009

    starter will not engage, enigine does not turn over, can be rolled off to start with the clutch but will not start with teh key

  • consuming805 Apr 19, 2009

    i had the battery tested and it is good, if I jumper the starter relay pins under the hood the starter will engage.
    I have also tested the clutch switch and checked for power on either wire at the switch while turning the key. no power indicated.

  • consuming805 Apr 19, 2009

    what should i look for at the steering column?
    I checked the conections and even took the key cylinder out and inspected it and teh rod going to the switch. no damages there.

  • Dennis Yachimec May 11, 2010

    Turn the key on and see if you can hear the fuel pump kick in. It will only run for about 3 to 5 seconds.

  • Anonymous Mar 15, 2014

    not starting and can be jumped from the starter cylynoid



2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Check the Starter Solenoid mounted near the battery.Check it out in the dark...have someone try to start it and see if it sparks at the solenoid.connections may be loose.Also check/wiggle wiring harness to starter.

Posted on Apr 19, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    An expert that hasĀ over 500 points.


    An expert who has answered 200 questions.

  • Expert
  • 255 Answers

Take battery out have it load tested, have starter tested
seems like we are missing something


Posted on Apr 19, 2009

  • james shack Apr 19, 2009

    okay now i would goto the electrical portion of the ignition switch on the steering column above brake pedal

    some areeally testy to get to

    hope2help shack

  • james shack Apr 19, 2009

    ther is no voltage at switch. because it is a ground can you jump the switch with paper clip, bobby pin. or small wire ?




1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Blown fuses

sounds like a bad ground somewhere or check your ground wire on your starter and even your igniton switch cause if they go bad then your car either wont start or wont stay running

May 14, 2013 | 2001 Chevrolet Lumina

1 Answer

2001 chevy blazer wont start starter and all wires are good. what else could it be?

Take your battery to a battery shop and have the cold cranking amps (CCA) checked. Your battery can read on any multimeter but if the CCA is not there, you need a new battery. If the CCA is good then check your starter relay. Relays do stick occasionally. Swap it out with another relay with a similar amp rating if available. However, more than likely the CCAs are not there.

Sep 05, 2017 | 2001 Chevrolet Blazer

1 Answer

03 wrangler wont start

A problem on the ignotion?
wifi obd tool for ipad iphone

Oct 08, 2012 | 2003 Jeep Wrangler

1 Answer

2001 s430 bought new battery car wont start

Check for a good/clean connection on your battery terminals.Make sure it's on good & tight, then try to start the car - if that's not it. Get a jump, then go to Auto Zone, O'Reilley's, etc and get the battery & the starter checked. I'm betting it's either a poor connection, bad battery or your starter is going out (or possibly the starter relay switch) Start with your connections - that's the easy fix.

Jul 10, 2011 | Mercedes-Benz S-Class Cars & Trucks

1 Answer

Wont turn over

The starter is most likely the problem,tap on the starter lightly with a hammer while trying to start the engine,dont get run over doing this it will take two people,if the engine starts,the starter needs replacing.

Apr 25, 2010 | 1998 Jeep Wrangler

4 Answers

My 91 jeep won't start...

The Starter relay is bad.

May 05, 2009 | 1991 Jeep Wrangler

1 Answer

2001 Ford Explorer Sport wont start

Even though I bought the vehicle new, there was an aftermarket security system installed. The system had a bad diode, so i removed the system and reconnected the factory wires.

Mar 27, 2009 | 2001 Ford Explorer Sport

1 Answer

2.5 jeep wangler 1999 wont start .starter checks out ok

Could be a bad connection between the battery and starter. Starter solenoid, or neutral safety switch if it is standard transmission.
Check for power at the solenoid.

Jan 26, 2009 | 1999 Jeep Wrangler

1 Answer

WOnt run over - battery good - can turn it over but jumping the starter

if the battery is good and you jump the starter she should run otherwise you may have a sensor issue, try to get a hold of a code reader and see if any codes have popped up..

Aug 02, 2008 | 1998 Jeep Wrangler

1 Answer

2001 jeep wrangler starting problems

check the starter relay first please rate -jeff

Jul 01, 2008 | 2001 Jeep Wrangler

Not finding what you are looking for?
1995 Jeep Wrangler Logo

Related Topics:

606 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides