Question about 2006 Suzuki Grand Vitara

1 Answer

Tire removing after removing the lugs in my car to change flat tire,its still intact doesnt come out.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

If you have removed all the wheel nuts and the wheel wont come off , use a large tyre lever or a long piece of wood to lever against back of wheel and lower ball joint , if you have alloy wheels they corroied to the hub , when refitting wheel use some copper grease to prevent this happing again

Posted on Apr 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 buick take off my front tires


remove wheel cover then with tire on the ground just loosen lug nuts just a little dont remove lug nuts then safely raise support vechicle.then remove front tires.

Apr 07, 2013 | 1991 Buick Century

Tip

Hard to remove tire lug nuts made easy


Did you ever have to remove a tire on your car or someone elses and the wheel lugs were too tight?
Ok I have a "proven simple solution".
Keep available a deep socket 1/2" drive impact wrench quality for both 3/4" lug nuts and 13/16" lug nuts and a small 2-4 lb. hammer.
Put the socket on the tight lug, strike it with the hammer dead on, remove it with your lug wrench, if that doesnt work, apply WD 40, use a 1/2 breaker bar and slide a 2 foot pipe over the handle of the breaker bar, lean your body weight on the breaker bar/pipe and walla it will come off.

on Jun 06, 2010 | GMC Blazer Cars & Trucks

1 Answer

Changing flat tire


Loosens the lug nuts Jack up the wheel. Remove the lug nuts Remove the wheel Install the spare Install the lug nuts until snug Lower off the jack Tighten the lug nuts Let me know if you have any questions and I'll do my best to answer them. Thank you for using FixYa.com!

Feb 19, 2012 | 1998 Toyota Tacoma

2 Answers

Having difficulty changing front drivers side tire on the Jaguar x type 2003. the tire is flat and we cannot seem to remove the tire


If all the lug nuts are removed and the tire will not come off it is frozen onto the hub. This is really common with aluminum wheels. If you can safely support the vehicle so that it will not fall off the jack you can try kicking the backside of the tire. This will work most of the time.

If that doesn't work put the lug nuts on till there just snug and then loosen them 3 or 4 turns. remove the jack and drive the vehicle back and forth until the wheel falls off the hub.

Everyone I work with as well as myself, have at least a four pound plastic deadblow hammer just to remove the wheels that this happens to.

Jan 30, 2011 | 2003 Jaguar X-Type

1 Answer

Changing rear flat tire


Find jack follow instructions to raise vehicle after parking brake is on. Remove lug nuts and take wheel with flat tire off. Replace with the spare tire and tighten lug nuts. lower vehicle, put jack , lug wrench and flat tire in vehicle. Drive to a tire repair store and fix the problem.

Dec 11, 2010 | 1996 Dodge Caravan

1 Answer

Step by step removing and replacing the spair


Hi my name is Tom and I am here to help you.

By changing the spare tire, I am going to assume that you mean changing a flat tire using the spare tire. If I am mistaken please advise.

Locate the area where the spare tire and jack are located. You should see a lug wrench. This would be a X shaped device with closed sockets. Find the correct lug size needed for the Caravan. Loosen the lugs by turning the wrench counter clock wise. A little reminder is (lefty loosey, righty tightey)

After the lugs are loose, jack the car up using the jack provided. Near each wheel is notches which show you where to place the jack. Do not jack any further then you need to lift the car up. Keep in mind that an inflated tire is larger than a deflated.

Remove all the lug nuts and replace the flat tire with a good one. Put the lugs back on and hand tighten.
Lower the car and tighten the lug nuts firmly.

The only thing I believe I left out was removing the wheel covers. You should find in a packet with the jack a device to unlock the wheel cover. I can not tell you what it is because each car is unique.

I trust this is detailed enough for you. If not, please feel free to contact me and I will answer any questions you might have.

Please take the time to rank the information I gave you and how helpful it was. This will help me to do a better job for you and other to follow.

TomE

Jun 29, 2010 | 2006 Dodge Grand Caravan

1 Answer

Flat tire


your owners manual is a valuable source of information, but if you do not have it here is what you do: the vehicle should be on a flat hard surface then you need to locate your jack and lug wrench , with the vehicle still on the groung loosen each lug nut about one turn then make sure that your emergency break is on, place the jack under the vehicle in an appropreate spot to raise the wheel off the groung, once the wheel is off the ground you can remove the lug nuts and pull the wheel off. Then you can put the spare tire on and replace the lug nuts tighten them in a criss cross patern as tight as you can get them then lower the vehicle back to the ground and check the lugs again. I hope this helps, good luck !!

May 12, 2010 | 2001 GMC Yukon XL

2 Answers

How do I change the tire on a 1999 chevrolet silverado 1500 4wd


the plastic nut doesnt actually come all the way off. it just stays with the center. and once you get these undone you can then pull the cover off

Jan 09, 2009 | 2005 Chevrolet Silverado

1 Answer

How do I remove the center lug on wheel?


On our Mazda3 the special lug removal tool was in the glove box in a blister pack with spare lugs. After having the car serviced the tool dissapeared and after searching I found it in the lug removal vrench where the dealership mechanic left it. Hope this helps. Alex

Nov 23, 2008 | 2005 Volkswagen Touareg

Not finding what you are looking for?
2006 Suzuki Grand Vitara Logo

354 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...