Put car drive gear shift stuck

SOURCE: dodge magnum gear shift

I had the same problem. The interlock was not the problem. I had the shifter replaced (at my own expense because drive train warranty would not cover). After examining the old shifter discovered source of problem is a plastic cam on the front of ths shifter. A tiny PLASTIC ear which connects to a small spring had broken off. I repaired this by putting in a small screw where the ear had been. Incidentally, my tow truck driver had also seen the same problem on several Chrysler 300s. In my estimation this is a poor design on Chrysler's part.

SOURCE: gear linkage loose so wont stay in park, car rolls

loosen up the linkage at the transmission a little,click the linkage i click on the transmission(shift it manually to reverse),put the gear selector in the car in reverse,then tighten the linkage.see if that helps.

SOURCE: My 2003 Mercury Mountaineer Gear Shift is stuck.

THERE IS A SENSOR ON THE BRAKE PEDAL THAT RELEASES THE THE SHIFTER.THERE A 3 COMPONENTS INVOLVED.U CAN PUT IT IN NEUTRAL BEFORE U START THE CAR.THEN WIL SHIFT.

SOURCE: My renault megane automatic is stuck in reverse and won't start

Hi all,
I have a 2002 Renault Megane 1.6 Convertible and experienced exactly the same fault. Needed a team effort but we found a very easy quick fix to this problem. If you take the plastic cover off from under the gear shifter, you will notice a release button covered by a rubber cover. Pressing this release button allows the gear shifter to move from its locked/jammed position. (This is not the fix but it helps with the fix).
If you are fortunate enough to have a 2nd person available, have them poke their head under the bonnet to watch the Gearbox cable move....while you are shifting the gear shifter inside the vehicle. Your partner will see that a cable with a plastic locking device (right hand side of the engine cover) has popped off the shifter for the transmission. Move the shifter until you can physically put the plastic locking device back on the shifter mechanism and your all good to go. No need for that new gearbox that you might have been quoted on!! An easy fix that I am surprised no mechanically minded professional/body in the world has volunteered the solution to. I wonder why????

Good luck!

Stan Cather

• 414 Answers
• Posted on Jul 02, 2009

SOURCE: Gear Shift button Stuck

Mist the switch with a small amount of windex then blow it out with canned air.