Question about 1994 Cadillac DeVille

1 Answer

How do I change my rear brakes on my 2000 Cadillac Seville STS?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 55 Answers

You will need to remove the parking brake cable from the caliper then remove the lower slide pin bolt, flip the caliper up and pull out the old pads and install the new ones. You should get the rotors machined for the best braking performance or replace them.

Posted on May 02, 2009

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2 Answers

SOURCE: How do I R&R front motor mounts on 2000 cadillac sts

Very easy, just remove front tires and unbolt, BUT I doubt you are asking right question. Not mounts, but mount in dead front center is problem. There are 4 mounts, transmission center back, left center and right center and front center. That takes full torque of motor and heat from exhaust. GM has a shield for exhaust.

Posted on Mar 01, 2010

mastatech
  • 478 Answers

SOURCE: How do you change the brake light on a 2000

Open the trunk and locate the screw that hold the lense assembly, remove screws, turn the socket that holds the brake bulb which will releas the socket, pull out the bulb, and replace with new bulb, reinstall in reverse order.

Posted on Jul 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What's code 1574 Cadillac STS 2000


Hi Antron,here's a link to your Cadillac codes,P1574 is stop light switch,that switch is attached to your brake pedal. http://www.engine-light-help.com/cadillac-check-engine-light.html Here's another link to what the stop light switch look's like.First look and see if your's is just loose and needs tightening,if bad,then remove electrical connector,then part and take to Autopart store and match up with new one and then install, http://www.autozone.com/electrical-and-lighting/stoplight-switch/duralast-stoplight-switch/cadillac/seville-sts/2000/8-cylinders-9-4-6l-sfi-dohc-ho/363562_0_0

Aug 13, 2015 | Cadillac Cars & Trucks

1 Answer

1999 cadillac seville sts cruise control modulator


Center rear of the engine compartment, near the power brake booster

Apr 14, 2013 | 1999 Cadillac Seville

1 Answer

How do I fix my brake lights on a 1998 Cadillac sts seville


Depends on what the problem is.
Do you have power in and out of the brake light switch ?
And in and out of the turn signal switch ?

Apr 06, 2013 | 2000 Cadillac Eldorado

1 Answer

Rear noise.


could be bearing

Jan 23, 2013 | 2001 Cadillac Seville STS

1 Answer

HI, my 1993 cadillac sts brake pedal goes to the floor no brakes, and the fluid is on the driveway under the rear of my car, what happened and what to do to fix the problem.


Probably a broken brake line. Most brake and muffler shops can handle this type of repair. New line must be installed and system bled od air.

Aug 22, 2010 | 1993 Cadillac Seville

1 Answer

How do you change the brake light on a 2000 Cadillac Seville STS ?


Open the trunk and locate the screw that hold the lense assembly, remove screws, turn the socket that holds the brake bulb which will releas the socket, pull out the bulb, and replace with new bulb, reinstall in reverse order.

Jul 10, 2010 | 2000 Cadillac Seville

1 Answer

How do I R&R front motor mounts on 2000 cadillac sts


Very easy, just remove front tires and unbolt, BUT I doubt you are asking right question. Not mounts, but mount in dead front center is problem. There are 4 mounts, transmission center back, left center and right center and front center. That takes full torque of motor and heat from exhaust. GM has a shield for exhaust.

Dec 02, 2009 | 2000 Cadillac Seville

2 Answers

1998 cadillac seville sts air ride prob


Disconnect the - battery terminal for a minute and reconnect.
Good Luck

Jun 14, 2009 | 1998 Cadillac Seville

Not finding what you are looking for?
1994 Cadillac DeVille Logo

1,093 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...