Question about Honda Prelude

1 Answer

I need assitence with my prelude

I have backfire n my car is not responding good at all, i already change the map sensor, and the the rpm goes down every single time that i put the clucth in and when the engine is cold is really hard to start the car and when it really start and i don't push the gas it die...also it burn to much gasoline..and my car is a honda prelude 1998 base model

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 22 Answers

Have a look in the distributor cap check for cracks and check rotor arm for burning

Posted on Apr 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hesitant when accelerating and already replaced MAP sensor


I use a hand held diag computer that can read 02 sensors,as long as the sensors are going up and down between lean and rich they are working.

Nov 12, 2012 | Cars & Trucks

1 Answer

Looking for a map sensor for my honda prelude si 2.0 1987.


Rock Auto.Com --- on internet

$129.79 for standard
$206.79 for wells brand

You need to know that is the problem

You install yourself in about 5 min
Don't need a repair shop

Sep 30, 2012 | 1989 Honda Prelude

1 Answer

96 Chevy K2500. Approx 170,000 miles Auto trans w/overdrive. Have already replaced rt exhaust air sensor, throttle position sensor, mass air flow sensor, complete tune up(plugs/wires/cap/everything), egr...


Hello! The problem is more than likely being caused by the Manifold Absolute Pressure (MAP) sensor...It is bolted to the side of the throttle body...Has wire colors Gray (+5volts)...Light Green (Signal out)...And Black (Return or Ground)...Using safety pins...Push the point into the rear of the in-place MAP connector...Clip the (+) meter probe, set to read +5volts, to the Light Green wire...The (-) probe to the Black...Start the engine...At idle reading is close to +5 volts...At 2500 rpm reading drops to 1.5-2.0 volts...If you have already replaced the MAP and do not get these results...Pull the MAP connector and read back into it using the same procedure...If, for instance, the Light Green signal lead remains on +5 volts it is probably shorted to the Gray in the harness...No voltage is present; The Gray wire is open...Or, No ground on the Black, the Black is open...Whatever you find wrong...Merely cut out the bad wire and re-connect on both ends..See diagram of MAP location below....Send a comment via e-mail....Guru...Saailer



9_26_2011_12_25_49_am.gif

Sep 25, 2011 | Cars & Trucks

2 Answers

I have a honda civic vtec vti 1992 when i start it it idles at 5800rpms i have change the iac valve and the map sensor what could it be i have no trouble codes showing


honda prelude 1990 4 spd manual trans ac ls model. accelorates normally and in between all gear changes engine does not slow down to 1000 rpm it remains at 2000 rpm.

Jan 23, 2010 | 1990 Honda Prelude

1 Answer

97 prelude turbo backfires when letting off the gas


not enough fuel the map sensor needs remapping

Jun 13, 2009 | 1989 Honda Prelude

3 Answers

1998 honda prelude check engine light goes on if i quickly rev the engine to 6000 rpms


your o2 sensor is not reading right change it out and it will be fine

May 06, 2009 | 2000 Honda Prelude

2 Answers

Honda prelude si 1991


Hi you are going to need an idle air control motor. This motor/sensor is what holds your idle at the correct rpm at idle.

Mar 27, 2009 | 1991 Honda Prelude

1 Answer

MAP sensor


There are 3 wires from the MAP to the ECU

Brown is E (Ground)

Yellow is VC to VCC (sensor to ECM)

Light Green with a Red tracer is PIM to PIM

Hope this helps. Thnaks for choosing FixYa for assitance.
A FixYa rating from you from my answer would be appreciated.
Thanks in advance.

Jan 24, 2009 | 1995 Toyota Corolla

1 Answer

Engine sound rough


check the throttle position sensor or the mass air flow sensor

Dec 09, 2008 | 1990 Honda Prelude

1 Answer

Jeep GCL Backfires Stalls


Aaron, I had the same problem. It is the most expensive part of course the computer. I replaced everything as well till I replaced it. They are remanufactured and have had problems with them as well. I am on my third one now at 200k miles. Oh and by the way it does not show up on the diagnostic check. Good luck

Frank

Nov 30, 2008 | 1997 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

257 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7689 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...