How do you remove a 2000 honda accord ext.door handle to replace it with a new one

Replace it, very easy. Look at Amazon or EBay for great prices on aftermarket handles.

Remove screw, unhook rod, install new handle. Look on Amazon for best price.

remove the inside panel of the door. the arms that attach to the handle will need to be removed , ( they are little plastic clips that usually are very brittle,, so use care in removing them. ) replace the handle with the new one,, Its really pretty easy once you get the inside panel off and an actually see what your doing, good luck

There is a very easy solution to this problem. Get the vehicle identification number of your vehicle you can call the dealership and get a new set of keys made and it doesn't cost that much to do. This will save you alot of time and frustration trying to remove the door handles

for the door handle you have to remove the door panel disconnect the rods then you have a 10mm bolt one a side door handle.engine light is nor related to door handle it say one of the sensors is down you have to plug in and check it.speedometer it my be a fuse, my be the cable from gearbox or the instrument cluster itself

Have to take off inner door panel and all parts then u will gain access to inside of door remove all linkages and remove bolts from door handle and install in reverse order.

inside the handle there is ONE screw covered by a piece of plastic. remove the plastic and then remove the screw. pull handle out and disconnect it from the door latch bar. replace in reverse

If its broken you can find a new one here
http://www.rockauto.com/

I broke the left rear one on my Accord.

You need to remove the inner door panel (will have a couple screws in the inner door handle and push pins around the outside. Inside the door are thin metal rods connected by plastic connectors. Check all the connectors, especially at the inner and outer handles. If they both failed at the same time, I would suspect the latch itself.

philips head screw driver and a flat tip to take plastic rod holder... very easy...pry rod off old and replace w/ new... unplug powerwindow switch if applicable