Question about 1986 Ford Bronco II

2 Answers

Vaccume module off the transmission

I have a 1986 Bronco 2.9 cylinde automatic 4 wheel drive traveling along white smoke started did not overheat could this be my head gasket and how do i know or what else should i look for thank you for your time if you could soveing my problem

Posted by on

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 232 Answers

It does sound like you have a bad head gasket,pull your radiator cap and check for oil and the odor of exhaust or fuel and also check the level,if your pulling coolant into a cylider there is a good chance your pushing exhaust into the water jacket,pull your oil fill cap and look for white/gray frothy oil on the underside of the cap,these are all good indicators of a bad head gasket.

Posted on Apr 17, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Expert
  • 145 Answers

Check the vacuum modulator on the transmission, unplug the vacuum hose and see if there is any transmission fluid leaking from the valve. Check coolant level

Posted on Apr 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Location of vaccum modulator valve on a 99 ford ranger


There isn't one , transmission is controlled electrically . If it doesn't shift right have it checked for DTC's - diagnostic trouble codes . Does the speedometer work ? VSS - vehicle speed sensor , input speed sensor .

Dec 21, 2016 | Ford Ranger Cars & Trucks

1 Answer

88 bronco 2 automatic v6 will sometimes not go in any gear but if I'm lucky it will kick in and go can anyone tell me the problem


the problem was changing that fluid! rarely happen, but it will happen when people change transmission fluid on older car then the car messed up. when you change the fluid you washed all the friction material on the clutch surface by putting in new fluid.

Jan 23, 2014 | 1988 Ford Bronco II

1 Answer

My 99 expedition won't stay out of all wheel drive I changed the transfer case motor and now it stays I awd for about 10 minute then kicks back out and then the 4x4 light flashes and then it is ok until...


The 4X4 system on your vehicle is computer controlled , GEM module . generic electronic module . The four wheel drive mode switch is a low voltage input to the GEM module . The GEM energizes relay's to control the mode as depicted by input from the mode switch an torque on demand relay an someother inputs . Probably has DTC - diagnostic trouble codes stored in the GEM module .
Transfer Case -Automatic Four-Wheel Drive (A4WD) The automatic 4-wheel drive transfer case system consists of the following:
  • automatic 4WD indicator light
  • brake pedal position (BPP) switch
  • torque on demand (TOD) relay
  • front output shaft speed sensor
  • generic electronic module (GEM)
  • 4WD high indicator light
  • 4WD low indicator light
  • 4WD mode switch
  • rear output shaft speed sensor
  • shift position sensor
  • throttle position output (TPO) from the powertrain control module (PCM)
  • transmission range sensor P1804 Transmission 4-Wheel Drive High Indicator Circuit Failure GEM REFER to Section 413-01 . P1806 Transmission 4-Wheel Drive High Indicator Short Circuit to Battery GEM REFER to Section 413-01 . P1812 Transmission 4-Wheel Drive Mode Select Circuit Failure GEM REFER to the Symptom Chart. P1815 Transmission 4-Wheel Drive Mode Select Short Circuit to Ground GEM GO to Pinpoint Test C . P1820 Transmission Transfer Case Clockwise Shift Relay Coil Circuit Failure GEM GO to Pinpoint Test B . P1822 Transmission Transfer Case Clockwise Shift Relay Coil Short Circuit to Battery GEM GO to Pinpoint Test B . P1824 Transmission 4-Wheel Drive Clutch Relay Circuit Failure GEM GO to Pinpoint Test A . P1826 Transmission 4-Wheel Drive Low Clutch Relay Circuit to Battery GEM GO to Pinpoint Test A . P1828 Transmission Transfer Case Counter Clockwise Shift Relay Coil Circuit Failure GEM GO to Pinpoint Test B . P1830 Transmission Transfer Case Counter Clockwise Shift Relay Coil Short Circuit to Battery GEM GO to Pinpoint Test B . P1836 Transmission Transfer Case Front Shaft Speed Sensor Circuit Failure GEM GO to Pinpoint Test A . P1837 Transmission Transfer Case Rear Shaft Speed Sensor Circuit Failure GEM GO to Pinpoint Test A . P1838 Transmission Transfer Case Shift Motor Circuit Failure GEM REFER to the Symptom Chart. P1846 Transmission Transfer Case Contact Plate 'A' Circuit Failure GEM REFER to the Symptom Chart. P1850 Transmission Transfer Case Contact Plate 'B' Circuit Failure GEM REFER to the Symptom Chart. P1854 Transmission Transfer Case Contact Plate 'C' Circuit Failure GEM REFER to the Symptom Chart. P1858 Transmission Transfer Case Contact Plate 'D' Circuit Failure GEM REFER to the Symptom Chart. P1866 Transmission Transfer Case System Concern - Servicing Required GEM REFER to the Symptom Chart. P1867 Transmission Transfer Case Contact Plate General Circuit Failure GEM REFER to the Symptom Chart. P1874 Transmission Automatic Hall Effect Sensor Power Circuit Failure GEM GO to Pinpoint Test A . P1875 Transmission Automatic Hall Effect Sensor Power Circuit Short to Battery GEM REFER to the Symptom Chart. P1891 Transmission Transfer Case Contact Plate Ground Return Open Circuit GEM REFER to the Symptom Chart. P1892 Trans. Automatic 4-Wheel Drive 4X4 Mechanical Lock Output Circuit Failure GEM GO to Pinpoint Test B . P1893 Trans. Auto. 4-Wheel Drive 4X4 Mechanical Lock Output Short to Battery GEM GO to Pinpoint Test B .
  • Your best bet , take it to a qualified repair shop .

Feb 26, 2018 | Cars & Trucks

1 Answer

I have a 1990 chevy pickup 5.7l v8 that made a loud noise when i was driving. Next the truck starting losing power and makes an engine tapping noise. I parked the truck.for several months and now tyin to...


Well, billowing white smoke from the tailpipe is generally antifreeze burning off in the engine, which would indicate either a blown head gasket into a cylinder or a broken fluid passage. In the old days there was a way an automatic transmission could leak trans fluid into the engine and create white smoke too, but that shouldn't apply to your vehicle. Not certain about the noises, but clearly you have some internal damage. You can check the antifreeze level to see if you have lost fluid. You can pull the spark plugs to see if you notice damage to the plugs or deposits on the plugs indicating antifreeze.

Dec 11, 2010 | Chevrolet 1500 Cars & Trucks

2 Answers

Hi, what does it mean when huge amounts of white smoke comes out of the exhaust? otherwise drives ok? it is a renault megane 1.5 dci 2004. regards catherine


Symptom: White smoke or water vapor from the exhaust. You notice white smoke coming from the exhaust when you start your car. If it is cold out, this may be normal. If the smoke does not disappear after the car is warmed, you have a problem. Possible causes:
  1. Transmission fluid may be entering the intake manifold through vacuum modulator.
    The Fix: Replace vacuum modulator
  2. Cylinder head gasket(s) may be bad.
    The Fix: Replace cylinder head gasket(s).
  3. Cylinder head(s) may be warped or cracked.
    The Fix: Resurface or replace cylinder heads. (Resurfacing is not a DIY job)
  4. The engine block may be cracked.
    The Fix: Replace engine block.

Oct 12, 2009 | 2005 Renault R5

1 Answer

Smells like gas and when i press on the gas it putters. white smoke coming out of exhaust


White smoke is usually a sign of head gasket problems.Gas smell could be the unburnt fuel from the cylinder head which is the source of the problem.

Jul 14, 2009 | 1986 Ford Bronco

1 Answer

1986 FOR BRONCO II v-6 ENGINE 4 WHEEL DRIVE AUTOMATIC 2.9 LITER


LOCATE EGR VALVE,, BELOW HOUSING, THIER ARE OPENINGS GENTLY, USING FINGER, INSERT IN OPENING, PUSHUP ON DIAGHRAM, WHEN YOU RELEASE FINGER IT SHOULD RESEAT AND SEAL,LISTEN TO ENGINE OPERATERTION FOR VARIATION TO IDLE, YOU HAVE JUST CHECKED TO MAKE SURE DIAGHRAM IS NOT BAD, NEXT CHECK VACMN TO VALVE,AND CONDITION OF HOSE.

Oct 05, 2008 | 1986 Ford Bronco

Not finding what you are looking for?
Cars & Trucks Logo

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

fordexpert

Level 3 Expert

5687 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...