Question about Dodge Ram 1500

1 Answer

My truck occasionally dies when stopping and taking off and then starts right up.It shows no diagnostic codes.

My truck occasionally dies when stopping and taking off and then starts right up.

Posted by on

  • Anonymous May 12, 2009

    my truck seems to stall, like if it needs spark plugs? i replaced them on christmas time and then last week, it work better for a coupe of days and now it's right back to it's old ways or worse? it's died on me a few times also at stops and driving into my driveway.

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Ive had the same problem. You have a vacuum leak or the EGR is clogged with carbon. The best solution would be to look for leaks around the breather and vacuum hoses. For the EGR just remove it and clean the gunk out. Im giving this info asuming that your dodge is a 90-97 or so.

Posted on Apr 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car starts then just stops


When it dies, does it start right back up? Have you tested to see what it does not have when it dies? Is it loosing spark? Is it loosing fuel pressure?

Jun 09, 2015 | 1999 Chevrolet Malibu

2 Answers

Po502 code


First step would be offering up what type of vehicle.

Oct 08, 2017 | Nissan Murano Cars & Trucks

1 Answer

What could cause my bank 1 O2 sensor to keep going bad


For the code pulled was diagnostic trouble code diagnostics done or was the O2 sensor just replaced > What was the code # P0xxx what . There are a number of codes for the O2 sensors on cars . They don't say replace the O2 sensor . diagnostics must be done , electrical circuit testing , plus other tests

May 16, 2017 | Jeep Cherokee Cars & Trucks

2 Answers

1995 honda civic dies when you stop occasionally.


check the throttle lines ,set idle just above stalling point if need be

Oct 22, 2012 | 1995 Honda Civic

1 Answer

P0300 P0420 P172 P0175 BEST WAY TO FIND WHAT PARTS NEED FIXED


BEST WAY TO FIND WHAT PARTS NEED FIXED ?????? Take it to a qualified repair shop that knows how to run diagnostic's for these codes .

Feb 23, 2018 | 1996 Isuzu Rodeo

1 Answer

I have a 91 Buick Century that dies after a few minutes.


Fuel or ignition problem? Right after it dies, check for spark at a plug. A bad coil will often work till it's warmed up, then fail. If you still have ignition spark after it dies, or if it starts right up again, then it's something else.
Check the fuel pressure to make sure it's at proper pressure. Also scan the computer for any trouble codes that are related. It's easy on your car if you understand how the flashing light translates to two-digit number codes. Use a wire or paperclip to bridge terminals A and B of the diagnostic test connector protruding out from bottom of dash. It's a 12 pin connector. A and B are the two upper right terminals on it. Now turn key on and the check engine light will begin blinking the codes. Code 12 is diagnostic mode-one blink, pause, pause,blink, pause blink. See? 22 would be blink, pause, blink, pause, pause, blink, pause, blink. See? 33 would be three blinks, short pause and then 3 rapid blinks. (I"m going blink crazy!) Well, get the codes-they are two digit codes, and will keep repeating, lower numbers first and in succession, over and over while in diagnostic mode. Maybe an idle sensor fault will show up.
Good luck.

Dec 06, 2011 | Cars & Trucks

1 Answer

When 1993 dodge caravan is driven awhile, It sometimes will not


idle is set at factory but if the idle air control valve is bad it won't idle right also if the throttle position sensor is not working right it won't idle right a diagnostic scan should be able to determine which one is needed.

Aug 25, 2009 | 1993 Dodge Caravan

1 Answer

I have a 2002 montero sport and i've changed the alternator and battery and now when i start the truck it works fine but when i get to a stop light or stop sign the truck will die out on me, it starts with...


Two areas to consider are the MAP sensor and the Idle Control Valve, both pricey items for your vehicle. I'd go to a local autoparts chain and see if they can run a free diagnostic test for you. The codes will point you in the right direction.

Apr 23, 2009 | 2002 Mitsubishi Montero Sport

1 Answer

2003 silverado wont make a sound


i have an 02 silverado and i had the same type of issue! wound up being a short in a wire running over the gas tank that operates the fuel pump! it would start fine and then it would die! and not start back! then it would start! take it to the dealer and have them check it - however diagnostics will not show a problem unless they can duplicate it!! hope this helps

Jan 03, 2009 | 2003 Chevrolet Silverado 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

366 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...