Question about 1986 Ford Bronco II

1 Answer

Turns over freely but will not start

No spark from coil even after replacing coil

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 57 Answers

Look for your ground wire for the block (engine) thats most likely the problem they arent usually to hard to find on trucks and s.u.v's

Posted on Apr 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

98 ford explorer replaced egnition. Now it wont start. Starting fluid does turn it over. But isn't getting feul


out of fueL, bad fuel , old fuel>?

replace what exactly , ignition parts t are many.
key switch.?
Igniton coil(or coils, or cops or coil packs)
Distributor.
spark wire, (not replaced 1 by 1 = fail..)
ok , the PCM monitors spark and that fails, (even if spark is good)
it will cut fuel. so what did you touch>?

i use a noid light, if pass I check fuel pressure
if noid fails, i find out why PCM is cutting fuel.
check fuses 1st. always. for ever. and ever

Jul 05, 2014 | Cars & Trucks

1 Answer

Engine won't start. Getting no spark.


Have you check to see if the timing on the car is right?

Nov 08, 2013 | Cars & Trucks

2 Answers

It turns but it wont start,it has gas and power


Pull off the coil ignition cable at the distributor and check for spark coming out of coil when cranking engine over. Use a heavy rag or glove to hold the wire 1/4 inch from a metal ground. Should see a strong blue spark when cranking to verify ignition is good. If no spark, check for battery voltage to coil on the coil primary. If you have current to the coil, suspect a bad coil, ignition module, crank position sensor, or cam position sensor, or pcm. The coil, ignition module, and sensors can be tested before replacing.

Jan 29, 2013 | Cars & Trucks

1 Answer

1989 chevy 350 pu. started and died. engine turns over freely. i have determined it is not a fuel problem. where to start?


Check coil for spark. Which type if Dist does it have? Should have High Enegry which are know for modueal in the dist going out.

Oct 03, 2011 | 1990 Chevrolet K1500

1 Answer

1994 f150 4x4 super cab 5.0 turns over but wont start, fuel pump turns on, replaced coil, cap, rotor, plugs and wires?


Hello! Even though you have replaced coil, cap, rotor, plugs and wires; I need to know that you have a strong blue spark at a plug...Have you checked a plug for spark? I don't want you to misunderstand why I'm asking you that question; Certainly not to insult your knowledge but I need to know for sure that there is a strong spark...Guru..............Saailer

Aug 24, 2011 | 1990 Ford F150

2 Answers

2001 won't start. turns over but doesnt even act like its firing. sometimes there is a smell of gas like it is flooded. started back in jan when it was cold. replaced battery and spark plugs to no...


check the color of your spark if it is blue your good if orange replace coil dependig on your setup and if you have 1 coild or 8 coils you many have to check each cylinder seperate just pull out spark plug replace the spark plug wire have someone try to start car and lood at color of spark i should note dont hold the wire just let it rest close by

if that is ok replace your crankshaft postion sensor as it tells the cars ecu when and to what cylinder to fire spark to faulty crankshaft postion sensors 99 percent of the time wont allow car to start or very hard starts the other 1 percent

if it helps please leave good review 4 thumbs

May 09, 2011 | Chevrolet Tracker Cars & Trucks

2 Answers

Dodge, 92, V-8, 318, electrical shut-off, engine cranks but no spark at least from coil back, no codes even after multiple times, intermittent problem, then wait several hours spark comes back and car...


Check that your have primary 12 v to the coil when it won't start.Can there be a loose connection?Coil is inexpensive to replace,Does distributor have a capacitator? Small cylinder by points.Change it too.I would check all grounds and connections clean and tighten.Good Luck.

Sep 29, 2009 | Dodge Ram 250 Cars & Trucks

1 Answer

1995 Geo Prism wont start


check all fuses real good with test ligh..i mean alll fuses.... next sounds like ignition switch might be bad... not supplying voltage to coil in crank position..but when let off cranking it returns back to run position it momentarily causes spark

Sep 06, 2009 | 1996 Geo Prizm

1 Answer

Car would not start or the engine wouldn?t even turn over.


Try removing spark plugs and turning engine over by hand with socket wrench on harmonic dampner if it spins freely probably not engine problem fluid in cylinders will cause hydro lock indicating blown head gasket or injector stuck wide open. a broken timing belt would still allow engine to turn over as your car should not have an interference engine. If engine will not turn by hand with spark plugs out susspect internal engine damage siezed bearings broken rod and so.

Oct 16, 2008 | 1992 Honda Accord

1 Answer

Car will not start


try to change the high energy ignition coil under the rotor cap as they go and all your car will do is crank and foul the plugs i paid 100 dollars to have shop find this problem the computer showed that i was getting spark but not enough upon removal of high energy coil there was a lil discoloring of the plastic cover which indicated spark burst thru casing and was not giving enough spark replacement part and new wires and plugs (old fouled) the car runs like new I love my honda !!!!

Sep 04, 2008 | 1999 Honda Civic

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...