Question about 1989 Pontiac Firebird

1 Answer

Zero braking : 90 firebird 5.0l

The brakes go all the way to the floor but it doesnt brake at all ...the is brake fliud in it...wtf is the deal is it the master cyclnider or the brake booster?

plz help asap
mike

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 104 Answers

Check for a major leak in the brake system if there isnt its your master cyl.

Posted on Apr 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hand brake light on dash intermittant. Switch at hand brake is ok


check the brake fluid level. the brake fluid can be low and comes on when stopping or going around curves. the brake fliud level sensor uses the same brake light as the parking brake. if the fliud is low check the pads and /or shoes for wear.

Aug 07, 2011 | Toyota RAV4 Cars & Trucks

2 Answers

Replaced all 4 dics brakes how do you bleed them


well if you didnt squeeze the calipers in using a tool or c-clamp then there is a bleeder screw on the back of the caliper youll need 2 people for this operation.

1 start car
2 pump brakes till as tight as they will go and hold it to the floor
3 second person undoes the bleeder screw after all fliud or air is gone retightens it(the preson in the car still has brake depressed until vavle is closed)
4 repeat till small amount of pedal travel.

Dec 13, 2010 | 2002 Buick Park Avenue

3 Answers

Brakes are going to the floor most of the way checked rear brakes and they are still good bleed them and problem still there


Normally when the brake pedal goes almos to the floor it is an indication of low brake fluid. Low brake fluid is an indication that front and/or rear brakes are wearing. As the brake pads wear down more brake fluid will be required in the wheel cylinders or calipers. Hint, the front brakes usually wear much faster than the rear due to the fact that the fronts due a much greater braking function that the rear. Check the front pads. Don't let them get down to the metal scraping metal stage before you change them out. This causes unnessary damage to the rotors. Look at your master cylinder on the firewall under the hood in front of the steering wheel. If the fluid level is belowhte "max" mark add fluid. Low fliud should also show as a red "brake" light on your dash, but not always.

Sep 08, 2010 | 1994 Honda Civic

1 Answer

How do I fill brake fluid? My brake pedal goes all the way to the floor.  I think I need to add fluid. The other cars I've seen the brake fluid was in a reservoir on the drivers side of the engine


You need to do more than just adding fluid. There must be a leak some where in the brake lines. You need to fix that than add fliud and bleed all the brakes. If you don't your brakes won't work right.

Dec 09, 2009 | 1997 Nissan Maxima

1 Answer

Clutch pedal does not recoil


The clutch master could have leaked its fluild at the slave, line or master itself, Master brake fliud willl be found under the carpet behind the clutch pedel The master is next to the brake master and looks the same only smaller remove the lid add brake fliud and hand pump the clutch pedal. ( Pull up from floor ) this can take alot of pumps. The pressure plate can have gone through and its destroyed the clutch will need replaced and the job should be done by a mechanic that has done the work before this is not a good car to learn the job on as mistakes are very expensive. A good mechanic not learning the job on your car will charge for this work and $800 is likly

Aug 11, 2009 | 1991 Volkswagen Jetta

2 Answers

Grinding and rattleing sound on the brakes of a 99 Gmc Sierra


air in the brake lines can cause that, bleed the brakes out, not very difficult if u know anything bout brakes, i can give u steps if u dont know how

Jul 13, 2009 | 2000 GMC New Sierra 1500

2 Answers

Brake fade on a honda accord


here are the possibility, air in the brake line, brake line has a hole, no brake fliud, master brake cylinder bad.
need to bleed the brake lines and see if there is ahole in any of the brake lines. if not, then your master brake cylinder need to be replaced.

Apr 15, 2009 | 1995 Chrysler New Yorker

1 Answer

My 1999 chevy tracker 78k miles rear drivers side leaks a fliud and makes a light scrubbing noise brakes and drums were replaced it may have something to do with 4wheel drive axle i was told has anyone had...


Is the fliud a lite clear brown/tan (brake fliud) or is it a dark black colour (gear oil)? It sounds like you have a brake fluid leak. Check your steel line on the rear axle and then remove the wheel and drum and check the wheel cylinder. Top up your Master cylinder and bleed the brakes. You might find the light scrubbing noise gone.

Apr 04, 2009 | 1999 Chevrolet Tracker

2 Answers

Peugeot 205 brakes not working


hi you got a brake fliud leak do a visual check around all your wheels at the back of them look for signs of leaks ifyou cannot see any have a look at your master cylinder for leaks if you can,t see any take the wheels off and have a proper look yates210456

Aug 02, 2008 | 1989 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...