Question about 1999 Ford Crown Victoria

2 Answers

Bubbling during idling or low speed

My ford crown victoria police interceptor 99 which i have used for the last 2 years travelling 50000km in Saudi Arabia has developed a problem. During idling or at low speed under 40 km , the car starts bubbling and the ac stops working.when i increase speed till about 70-80 after pressing hard the acc pedal, suddenly the car jumps up and comes to the normal functioning. Any solution???

Posted by on

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

You mean 70-80 kph? because in mph that is very fast! check your thermostat, and if its not a problem with the thermostat sticking , it may be a problem with your water pump

Posted on Aug 10, 2009

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 10 Answers

Sounds like you're LOW on Coolant, it's overheating, and when you're romping on it, you're forcing ram air in to make it go, or it drops out of limp/overheat mode...

Check coolant levels, keep an eye on your gauges to make sure you're not overheating

Posted on Jul 24, 2009

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

MrScary66613
  • 1990 Answers

SOURCE: 2004 and 2001, are parts interchangeable?

Yes they are as long as the Motors are Similar.

Posted on Jan 22, 2009

  • 66 Answers

SOURCE: 99 crown vic police interceptor steering wheel??

i have ran into 2 issues in these vehicles---if it binds while sitting still also, check the steering shaft, i have found the u-joints in the shaft tighten up and binds dangerously tight---if they are free, sounds like you may have a steering box issue or restriction in a line---hope this was helpful!!

Posted on Jul 07, 2009

ZJLimited
  • 17970 Answers

SOURCE: I need fuse panel diagrams for ford crown victoria

For check passenger compartment fuse panel, is located below and to the left of the steering wheel by the brake pedal. Remove the panel cover to access the fuses.

Other details and descriptrions can find it in 2003 Ford Crown Victoria - Owners Manual (page 164 and next).

Hope helps (remember rated this).

Posted on Aug 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does my 2007 Crown Victoria Police Interceptor vibrate when I get to 40 miles an hour and then die off back to normal by the time it reaches 50


Ford Crown Victoria Questions - what would cause a whole ...

www.cargurus.com > Questions > Ford > Crown Victoria
CarGuruswhat would cause a whole car vibration when going between 48 and 65 mph, even ... Asked by Dfranz Aug 29, 2013 at 11:53 AM about the 2001 Ford Crown Victoria Police Interceptor ... You have an open diff by turning one wheel the driveshaft should turn before the .... 2007 Ford Crown Victoria Police Interceptor For Sale.

Nov 03, 2015 | Cars & Trucks

1 Answer

Diagnois overheating on 2003 Ford Crown Victoria police interceptor


Does the cooling fan come on at 225F? Have the fan tested by the dealer with a scanner.

Jul 02, 2012 | 2003 Ford Crown Victoria

1 Answer

Water pump failed. Car overheated. Engine lost power. Car smoke out from back of engine and from rear of car. I replaced water pump. Car still smokes when I drive it. Still has no power.


Notorious for intake leaks, the composite plastic intakes crack and leak coolant-as to the lack of power, you mght have overheated it and done some damage to the engine. There was a recall (information below) for the 4.6 for the intake-the overheating and lack of power means you should at least have compression checked and go from there-you may have bad head gaskets or worse. Do a compression test before you do anything else.

Ford Motor Company will extend the recall (01M02) on 4.6L V8 equipped vehicles with plastic intake manifolds. Some of the composite intake manifolds used on 4.6L SOHC engines may develop fatigue cracks at the coolant crossover duct. This condition could result in engine coolant leakage which, if not serviced, may cause engine overheating. Complete loss of coolant may result in engine damage or engine failure.
The updated recall now includes:
• Certain 1996 through 2001 Model Year Crown Victoria Police Interceptor
• Certain 1998 through 2001 Model Year Crown Victoria with Taxi
• Certain 1998 through 2001 Lincoln Town Car Limousine and Livery Prep Package
• Certain 1996-2001 Crown Victoria Taxis, Police cars and Lincoln Town Car Limousine and Livery cars.
• Certain 1996 through 1997 Crown Victoria Police Interceptor Vehicles with 4.6L SOHC engines built at the St. Thomas Assembly Plant from the beginning of production for the 1996 Model Year through January 28, 1997.
• Certain 1998 through 2001 Crown Victoria Police Interceptor Vehicles with 4.6L SOHC engines built at the St. Thomas Assembly Plant from November 22, 1997 through December 15, 2000.
• Certain 1998 through 2001 Crown Victoria Taxi Vehicles with 4.6L SOHC engines built at the St. Thomas Assembly Plant from November 22, 1997 through December 15, 2000.
• Certain 1998 through 2001 Lincoln Town Car Limousine Prep Package and Livery Vehicles with 4.6L SOHC engines built at the Wixom Assembly Plant from November 22, 1997 through December 15, 2000.

Sep 23, 2011 | 2001 Ford Crown Victoria

1 Answer

Speedometer and odometer does not work in 1998 Crown Vic police interceptor


Either the speed sensor,or the dash cluster is of fault. Have Auto Zone test the speed sensor,if ok ,,, I would replace the cluster ( buy used ) much cheaper.
Please rate this.

Jul 27, 2009 | 1988 Ford Crown Victoria

1 Answer

99 crown vic police interceptor steering wheel??


i have ran into 2 issues in these vehicles---if it binds while sitting still also, check the steering shaft, i have found the u-joints in the shaft tighten up and binds dangerously tight---if they are free, sounds like you may have a steering box issue or restriction in a line---hope this was helpful!!

Jul 07, 2009 | 1999 Ford Crown Victoria

Not finding what you are looking for?
1999 Ford Crown Victoria Logo

493 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5470 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...