Question about 2000 Ford Focus

1 Answer

Over head light not working

How do you change the over head light in a 2000 ford focus?

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that gotĀ 5 achievements.


    Visited the website for 3 consecutive days.


    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 97 Answers

Make sure the light switch is in the off position, prise out the light assembly at the side opposite the switch disconnect the wiring connector you should then be able to take out unit and change bulb

Posted on Apr 16, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to fix head gasket on a 2000 ford focus

i wouldnt attempt this if you have never done it before u need to know the toroque settings for the head bolts u need to set the timing the head will need skimmed and tested its alot of work

Jun 09, 2012 | 2000 Ford Focus

1 Answer

Focus 2ltr 99.t,reg wont start when warm/hot runs perfect from cold ,engine management light just come on .thanks

try changing the auto choke temperature sensor ,its on the head but i cannot remember exactly where ,get confused with the escorts

Dec 11, 2010 | 2000 Ford Focus

1 Answer

How do i change the divers head light on a 2007 focus

raise hood, Remove by lifting up 2 plastic retainers, it will fall out at that point

Jun 10, 2010 | 2000 Ford Focus

1 Answer

How do you get head light bulb out of spar ring on

you have to unclip the little wire clip that holds the bulb in usally push the ring ends out to one side or the other hope this helps

Dec 02, 2009 | 2000 Ford Focus

1 Answer

2000 ford focus sedan 2.0 dohc ztec engine rear

check all battery leads and earth straps
"" car body and engen bay straps""
also check battery terminals are tight check its full of battery water too if its been low for a time bump it!
and have a ""drop meeter test"" done on the battery if its a bad battery it should show that up first time it could have cracked plates inside the battery its self, test by turning on head lights then hit starter, if every thing go's dead!!!! put ""good jump start"" battery on to car and try it again,,, all should work just fine then,,,,it could just be a flat battery?????

Oct 27, 2009 | 2000 Ford Focus

1 Answer

Remove my head lamp

You Have to Press Small lock. Pls Inspec the light Wire Clip.

Jun 07, 2009 | 2000 Ford Focus

1 Answer

Everything dims

change altenator the brushes are worn ,it charges then stops and starts to charge with higher RPM

Jan 07, 2009 | 2000 Ford Focus

Not finding what you are looking for?
2000 Ford Focus Logo

Related Topics:

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

79123 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers


Level 3 Expert

5677 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides