Question about 2001 GMC Sierra 2500HD

Open Question

Won't shift into park

"2001 GMC Sierra 2500HD won t shift into park sometimes Playing w/gear shifter works sometimes" Looking through the rubber boot into the shift column area and pulling forward on the shifter it looks like a spring or something is broken.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 GMC SIERRA 2500HD

I have the same issue...what's the fix?

Posted on Oct 01, 2008

  • 507 Answers

SOURCE: where is the thermostat on a 2001 gmc sierra 1500 5.3l

follow the top radiator hose towrds the motor. you'll see a hose clamp then on the otherside of that is the thermostat housing. there's two bolts holding it on. remove that and any other little brackets that are in your way and it's right there under that housing. Drain a few gallons out of your cooling system, remove housing, and pop old thermostat out. Clean the block and housing with some emery cloth, like $0.40 at auto parts store. (Note, that might not be needed if it's an o ring instead of a gasket. People at store can tell you for sure.) Once it's shiney, place new thermostat it put on new gasket and reinstall. If o ring, place o ring on thermostat and reinstall. top of cooling system, start truck, and keep topping off fluid till it's blowing good heat and not overheating.

Posted on Jan 02, 2009

TheValley
  • 6 Answers

SOURCE: 4X4 inop on 2003 GMC Sierra 2500HD

I have found that when you are going to engauge 4x4 high, it is best to only be going about 3 miles an hour. Not faster, not stopped. It likes some movement to help it mesh. I've had perfect shifts since I started this. Hope it helps. Wade.

Posted on Jan 27, 2009

  • 1 Answer

SOURCE: 2003 gmc sierra duramax 2500

Problem with Diesel Fuel System. Gmc 2002 duramax 2500 HD 4x4 will start 

Posted on May 15, 2009

  • 335 Answers

SOURCE: 1989 GMC Sierra 3500 loose tilt steering column

Without taking the tilt mechanism off you can only reach 2 of the 3 bolts. If you use 1/4 in. socket on 1/4 in drive with 6 in extension you can just get at the left bolt. If you remove the tilt spring you can get to the bottom bolt. To remoce tilt spring retainer use standard Phillips.

Posted on Jul 19, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ok i put my new brake switch in and now my shifter lever won't shift does anyone know why it won't shift


you may have to adjust your switch might be in the hole too far, or defective

Nov 29, 2012 | 1995 GMC Sierra

1 Answer

My 2001 F150 won't shift into park.... It will shift into every other gear but park. Unless I go under the truck and manually turn the linkage back into park. Any ideas of what the problem may be?


Gday mate,geoff here, now on your shifter if column shift there is an adjustment where it goes down the box from the steering column under the hood and if stick shift should be just under the console, alternitiveley the rubber grommets on the linkage are worn and need replacement, some fuel hose will surfice here if the grommets are unavailable at the parts counter, hope this helped, geoff.

Feb 11, 2012 | Cars & Trucks

1 Answer

My key wont turn to off in order to remove my key from ignition while in parking


Ignition - Key Stuck In Ignition Switch/Won't Turn Bulletin No.: 06-02-35-005 Date: February 28, 2006 TECHNICAL Subject: Key Stuck in Ignition, Key Will Not Return to Off Position, Shifter Button Won't Release in Park Position (Adjust Shifter Detent Finger) Models: 2002-2005 Chevrolet Monte Carlo Condition Customers may comment on any of the following conditions: - The key is stuck in the ignition cylinder. - They cannot return the key to the off position to remove the key. - The shifter button won't release in the park position. Cause This condition may be caused by the detent finger shifting over time. This may result in mis-alignment and binding of the shift rod on the shift position guide.
WHERE YOUR SHIFTER IS YOU WILL HAVE TO TAKE IT APART ..MAYBE THE RUBBER BOOT IS IT THE WAY,OR THE SHIFT LOCK SELINOID WHENT BAD

Aug 05, 2011 | 2005 Chevrolet Monte Carlo

1 Answer

Truck sticks in park when trying to go into drive or any other gear. it wont move the shifter, on an automatic gmc sierra 1997


Replace the shift lock solenoid whichis located by the shifter inside the truck.It keeps the shifter locked in place until you press the brake pedal to shift

Jun 02, 2010 | 1997 GMC Sierra

1 Answer

Why wont my 2001 gmc sierra 2500hd go into 4th gear?


There is a speed/shift sensor you could change, but if you haven't changed the fuel filter in a while, i'd go there first. Sometimes, in fact, often, plugged fuel filters can cause the engine to starve for fuel, and make it seem like the transmission is the problem.

Jul 25, 2009 | 2000 Hyundai Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...