SOURCE: 2001 bmw 740il output speed sensor location
hello ryk786, i/m not a hundred percent certain, but I think the output speed sensor is located at the back of the transmission. With the pan removed, if you look at the valve body and see the EDS valves and connectors, look about 2 inches back toward the end of the case and you should see a connector by itself. There should be a retaining torx bolt and spring holding the sensor in place. After installing the new sensor, do not over-tightend the bolt. The torque should be around 5-6 Nm.
SOURCE: 99 Chevy Malibu - auto trans - no dipstick
You have what is called a closed cased transmission. You have to crawl underneathe to get to the tranny and remove the upper bolt close to the side of the case (more towards the bottom of the transmission). When you fill it, you fill it till it starts to drip out of that hole.
Looking for a picture for you.
SOURCE: oil filter location 2004 Chevrolet Malibu Classic
Standing at the front of the car looking at the intake manifold, its on the right hand side of the manifold about 6 inches down from the valve cover under a black cap with a 32mm top on it.
SOURCE: were is the crankshaft position sensor located on 2001 chevy mali
It mounts in the side of the block near the crankshaft,it fits in a hole,going into the engine block.,look on the inside of the engine compartment ,on the firewall side,left of the pulleys,down low.
SOURCE: Change headlight on 2008 Chevy Malibu
Hi there,
Well first you can please follow the below steps -
1. Make sure the ignition key is in the off position and the headlight switch is off. Release the hood latch.
2. Open the hood and locate the top of the headlight assembly where you intend to change the headlight. If a plastic shroud is present, locate the center bolt and remove it with a ratchet and a socket. Lift the shroud out of the way to access the headlight assembly retaining brackets. Some later models may feature a snap-release shroud requiring no tools to remove.
3. Locate the brackets on the top rear of each side of the headlight assembly. Lift them all the way up to align the hole on the bottom of each bracket to the retaining tabs on the assembly.
4. Pull the assembly forward away from the Malibu, but be careful not to scratch the bumper. There are three guide pins that require unseating. The guide pins are what aim the headlights and it may take some wiggling to get the pins from their seats.
5. Support the assembly with one hand and then reach behind the unit with the other. The low beam bulb is on the outside, the high beam bulb is on the inside. You can also replace the parking light if desired. Locate the wire harness connection. Un-clip the wire harness from the back of the bulb socket. Remove the bulb by turning it counterclockwise 1/3 of a turn to align the release tabs of the ring and the assembly. Wiggle the bulb out of the assembly.
6. Place the latex gloves on your hands before opening the package of the replacement bulb. Oil in our skin can damage the glass bulbs of halogen headlights.
7. Carefully insert the new bulb into the ring and then align the tabs of the ring to the tabs of the headlight assembly. Push inward and then twist clockwise 1/3 of a turn to lock the bulb in place. Reattach the wire harness. Rest the headlight assembly inside its cavity and test the operation of the headlight before securing the headlight assembly in place. Be sure to turn the lights and ignition back off.
8. Align the three guide pins to their seats and push the assembly back into them gently until they snap into place. Replace the retaining brackets by pushing them downward to lock into place. Replace shroud, if applicable. Remove the tools and old bulb and close the hood. Post comments for further help or information......
Good Luck!!
63 views
Usually answered in minutes!
×