Question about 2005 Jeep Liberty

2 Answers

Tried to start jeep liberty 2005 went and opened

Tried to start jeep liberty 2005 went and opened the door with my remote key. door opened fine then would not start. tried a few times. then the remote key would not work at all. Tried to jump the vehicle over, still would not even crank over just made a clicking noise. some one tole me it could be soemthin with the security. any comments appreciated.

Posted by on

  • bluetick957 Apr 16, 2009

    thanks for the info. I did check the battery terminals there good and i disconnected the terminals and it still wont start, all the fuses are good. and i did like u said lock and unlock with the key but still nothing. i hate to call for a tow the jeep is parked in a hospital parking garage i dont know how they would get it out, i really dont thank it is the starter but i reckon it could be i just was thankin it may be somethin to do with the anti theft security i dont really understand these keys any other ideas would be appreciated

    thanks for the previous info

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Pull the panel underneath the steering wheel , it folds down, locate the security system module, locate a white plug on this mudule with a yellow, red and black wire, follow the yellow wire, it should go up to a pink wire that comes down from the ignition, disconnect this yellow wire at the point where it connects to that pink wire and yuor jeep should start, if it doesnt let me know, you then need to ckeck the starter relay, hope this helps, it helped me with my 05 jeep liberty,

Posted on Oct 04, 2009

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 6,982 Answers

Aside from the part about the remote, I would first check to make sure the battery has a solid 12volts in it and that the terminal connections are clean. After this, then check to see if operation has been restored. Jumping across a battery with bad connection often prevents the vehicle from starting. Also try closing the doors and then locking and unlocking drivers door with the key itself. This should re-set the security system

Posted on Apr 15, 2009

  • Richard Scordino Apr 16, 2009

    This is the frustrating part...likely If I was there I could have it running within the hour. I can't see or hear it and can only know what you tell me...ever try to tell someone how to tie their shoelace on the phone? not as easy as you might think, but you can do it yourself without looking!!!
    Good luck, hope it's something simple!!


×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I changed my batteries in my keyless remote


  • Jeep 1990 and later Remote keyless entry programing
  • Put the key in the ignition with all doors and trunk closed
  • Open the driver's door on the automobile and leave the door open.
  • 4 Move the switch on the door to the lock position while the door is open.
  • 5 Switch the key in the ignition two clicks to the right to the "On" position. do not start
  • 6 Press the lock button on your keyless remote for your Jeep and hold the button for 5 seconds. Release the button and remove the key from the ignition to complete the programming.


  • Read more : http://www.ehow.com/how_5019251_program-keyless-entry-jeep.html

    Jan 20, 2015 | 2002 Jeep Liberty

    1 Answer

    My horn started blowing on my 2005 jeep liberty


    that's the antitheft open drivers door window , with door closed put key in door and turn open to lock 3 times in a row and remove key

    Oct 14, 2014 | 2005 Jeep Liberty

    1 Answer

    Doors will not open by using remote key pad


    both RKE keys dead.? car came with 2 , lost one?
    replace the battery in RKE fob yet, why not, its like $1 fix.

    Aug 02, 2014 | 2005 Jeep Liberty

    2 Answers

    Is there a way to unlock the rear door of a 2004 jeep liberty from the inside


    If you hit the unlock button in the door 2 times, it should unlock the tailgate. Otherwise you may have to go back to the dealership and have them program a new remote for you. If the battery in your remote went dead, it may work again by replacing the battery.

    Jul 11, 2014 | 2005 Jeep Liberty

    1 Answer

    Why won't 2004 jeep liberty rear hatch door open?


    There is no keyhole and switch on the rear hatch in Jeep liberty.
    You can control the hatch by remote key and window/door switch on the driver seat side.
    I don't know why they make like this, it's inconvenience.

    Jun 09, 2014 | 2006 Jeep Liberty

    1 Answer

    Central locking 2005 subaru liberty stopped working on 2 doors


    1. Replace battery in remote
    2. Replace sensor at rhf door lock (it is inside of door)

    Apr 30, 2014 | Cars & Trucks

    1 Answer

    Door lock


    need to change old battery, or use jumper start using other car

    Jul 02, 2013 | 2005 Jeep Liberty

    1 Answer

    My horn went off and would not turn off on my 2005 Jeep Liberty. The remote key won't work and the engine will not work with my key


    Your alarm has been set off, once this happens the engine can not be started until the alarm is clear. It pretty much disables your ability to drive the car just in case it would be stolen. The dealer will need to check out to see if the alarm malfunctioned or ? what caused it to go off.

    Jun 13, 2010 | 2005 Jeep Liberty

    1 Answer

    I have an 08 Jeep Liberty that has a remote starter on the key. I tried to unlock the car with the remote, however, that didn't work, so I unlocked the car with the key. The alarm went off, I tried pushing...


    Sounds like you have a key without the chip in it. Replacement keys without the chip will only unlock the doors and will activate the theft alarm when you start the vehicle.

    May 22, 2017 | 2008 Jeep Liberty

    1 Answer

    I have 2002 Jeep Liberty (Sport) - won't start!


    Your security system could have a problem, replace battery in keyless remote. If not helping you may have to take it somewhere and have security system checked

    Sep 17, 2009 | 2003 Jeep Liberty

    Not finding what you are looking for?
    2005 Jeep Liberty Logo

    549 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Jeep Experts

    yadayada
    yadayada

    Level 3 Expert

    75066 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    7754 Answers

    Are you a Jeep Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...