Question about 1991 Chevrolet Corsica

1 Answer

Removing door panel

I have a 1996 chevy corsica and my rear window has gotten off track. My main problem is getting my door panel off. I cannot figure out how to remove the window handle crank.

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Usually these handles are held on with a clip, round with open ends, hard to describe. Haynes manual says to use a special upholstery tool, one with forked ends to push the clip off. Poor man's solution is to use two flat headed screwdrivers to find the ends of the clip and push on both ends at the same time. Usually ends up with ripped upholstery. Check at Harbor Freight for cheap upholstery tool.

Posted on Apr 17, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 chevy equinox. drivers side power window. window gets stuck have to manually help it get...


need to remove the door panel and check the tracks or for debris in track

Jun 17, 2017 | Cars & Trucks

2 Answers

Window off track of chevy tahoe rear window how do you get it back up


If it is off track just take the inner door panel off and put it back on track. if that don't work replace the broken window regulator and check the window motor to see if it is still good. replace if necessary .

Feb 16, 2013 | 2004 Chevrolet Tahoe

1 Answer

Troubleshooting 00 chevy Cavalier rear manual window


Remove the door panel and make sure the window is still on the tracks ...It is a fairly simple fix.Remove the to nuts and washers from the window track and reinstall the window on the track and tighten up nuts..Be careful when cra nking on the window crank,the window may shatter while placing pressure on it while its out of track..

Aug 02, 2012 | 2000 Chevrolet Cavalier

2 Answers

Rear door panel removal:rear door window just fell down oneday and i was told it might just be off the track. it has electric windows


Its not off the track!!
You just lost the holders clipping your window glass piece.
  • Look for screws in door panel or around the speaker vents.
  • If you are sure that the speaker cant be removed without opening the door panel then read this below.
  • Mostly seen near areas like door lever(inside), power window switch set, bottom and each sides of the whole panel.
  • If its manual window, then look for a circle clip in between the winding window lever and the door panel. Plunge screw driver between them a make a gap then look.
  • Assure that all clips or screws which obstacles the removal of the panel.
  • Simply pull the panel from sides towards you

Sep 23, 2011 | 2007 Chevrolet Malibu SS Sedan New Cars

1 Answer

How do you get the driver's door latch out past the window guide?


Remove all screws around the outer edge of the door panel. Carefully pry off the decorative cover behind the door handle and remove the torix screw. Lift up firmly on the door panel to remove. To reinstall, line up molded plastic hooks on back of door panel with notches in the door, push down to secure, reinstall torix screw, decorative cover and screws.
Also before you lift away the panel, you'll need to undo the electrical connectors for the power window and door locks

It is best to get the whole power window regulator assembly from the junkyard, which includes the power window motor. Cost should be no more than $40. Remove interior door trim panel by removing all screws and pulling up on the door panel. Unbolt existing window regulator assembly and slide guides from aluminum window track (you will have to uncrimp one end of track). Installation is the reverse of removal (remember to recrimp aluminum window track after reassembly). I did this repair in 45 minutes, power window worked like new. Good Luck!



Dec 12, 2010 | 1996 Chevrolet Monte Carlo

1 Answer

How do I replace a side mirror chevy corsica?


Please don't forget to rate....thanks:


Removal & Installation The door outside mirrors are stud mounted to the door filler. The mirror glass face may be replaced by placing a piece of tape over the glass then breaking the mirror face. Adhesive back mirror faces are available. Left side flat and right side convex mirror faces must be replaced with the same type mirror face when surfaced.
  1. Remove the door trim panel.
  2. Remove the upper trim panel.
  3. Remove the sound absorber.
  4. Remove the (3) nuts.
  5. Remove the control cable from the upper trim panel.
  6. Remove the filler and mirror.
To install:
  1. Place the filler over the studs on the mirror.
  2. Install the control cable through the filler and connect to the upper trim panel.
  3. Install the (3) retaining nuts and tighten to 42-72 inch lbs. (4.7-8.1 Nm).
  4. Install the sound absorber, upper trim panel and trim panel.

Mar 06, 2010 | 1996 Chevrolet Corsica

1 Answer

Removing the door panel from a 97 Chevy S-10 pu truck


The center section does come out it has little tabs front and rear you have to bend it very carfully.GOOD LUCK

Sep 16, 2009 | 1997 Chevrolet S-10 Pickup

1 Answer

Right rear window is off the tracks. How do I remove the panel?


if the window is off track the regulator is probably bad. to remove the door panel should be a couple of screws by the inside pull handle and possibly one by the door handle itself also check the bottom of the door for any then just pull it off and lift up to clear latches and remove plastic film to get to inside of the door

Aug 30, 2009 | 2001 Oldsmobile Aurora

1 Answer

Rear passenger window just slides how do I get the door panel off


Well first take the mirror cover off. Then the roll up window handle if its manual. There is a star head behind the handle to open the door, remove that and unplug all wiring.Then behind the handle to close the door there is a cover, it has 2 screws, take those out and the rest is just plastic door clips just pull away from the door and they will start coming off.

Mar 12, 2009 | 2000 Chevrolet Malibu

Not finding what you are looking for?
1991 Chevrolet Corsica Logo

259 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...