Reseting dme on e90 bmw after removing batterly

SOURCE: BMW E90 323I, ABS resetting.

hey hassa, if you swapped an ABS control unit from another vehicle, it needs to be coded to your vehicle. If your vehicle does not recognize the replacement vin, it will set a fault. also, make sure to have the ABS sensors calibrated after the control unit is coded. most dealers charge about 1hr labor to perform coding and sensor calibration.

SOURCE: bmw e90 fuel

YOUR BATTERY SAFTEY TERMINAL MOST LIKELY BLEW (ON POSITIVE BATTERY CABLE ON RIGHT SIDE OF TRUNK). NEEDS TO BE REPLACED. SEE A DEALER.

SOURCE: how to reset service light for BMW e90 320i in

This is for 2001 onwards :

- Iginition OFF (POS 0) with key in.

- Press and Hold the trip odometer button while turning key to position 1 (ACCESSORY)

- Keep the button depressed (about 5 secs.) until you see "Oil Service" or "Inspection" with "Reset" or "Re" in the display

- *Note: On vehicles with "High" cluster, you will also see the amount of fuel (in litres) remaining until next service

- Press the button again and hold for approx. 5 secs. until "Reset" or "Re" flashes

- While the display is flashing, briefly press the button again to reset the Service Interval. After the display has shown the new interval you should see "END SIA" for about 2 secs.

Note that if the "Reset" or "Re" does not flash, then you have not met the minimum consumption level and cannot reset.
You can find more information at:
http://www.bmwtips.com/tipsntricks/reset-plug/reset.htm