Question about Hyundai Motor 2003 Elantra

1 Answer

Crank Seal Leaking

I have a 2003 Hyundai Elantra that is leaking from the crank seal. Is this an easy fix? If I have a shop do it how much can I expect to spend?

Posted by on

  • Paul May 11, 2010

    front or rear seal.

×

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 776 Answers

You haven't mentioned WHICH ONE? THE 'FRONT' OR THE 'REAR' SEAL? Tell you what, Go to http://www.hmaservice.com/ and register (vehicle by VIN). Afterward, you'll have access to technical information (manuals, wiring diagrams, service bulletins, etc) about your vehicle.

Posted on Jul 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I replaced front crank shaft seal in 2003 chevy impala and its still leaking and wont start what dod i do


The shaft may be worn down by the old seal and it wont work with a new seal because of the size change. Are you sure that you have the timing set right? Also did you remove the crank sensor or the crank sensor wires?

Feb 25, 2015 | Cars & Trucks

1 Answer

Right axle seal leaking


Can I conclude front cv shaft on the right side from your posting? If this is a yes you will have to pop the shaft out,pry the old seal out and very gently(a large socket works well) tap the new seal into place.If you are not handy I am afraid its a trip to the mechanic.Service on these is replacement only.good luck

May 07, 2014 | Hyundai Motor 2003 Elantra

1 Answer

Crank seal leaking


how to use this product to stop minor crank seal.
thanks

Jan 10, 2014 | 2003 Dodge Neon

2 Answers

Hyundai repair forum


pcvalve stoped up

Dec 17, 2013 | Cars & Trucks

1 Answer

2003 Hyundai Elantra only has 35,000kms on it! Started leaking oil really bad, took it to mechanic, he fixed the engine seal, went and picked it up, leaking oil on the way home, took it back and they tell...


dear friend-your mechanic is not very convincing,did he perhaps use a pirate seal,or incorrect seal,according the km this car is still new,so it is not posssible for crankshaft to be damaged.please get a second oppion,as it might be that the leak is from somewhere else and not the seal in question.

Nov 06, 2009 | Hyundai Motor 2003 Elantra

2 Answers

2003 Hyundai Tiburon Leaking Transmission Seal


The beaings job is to not only give the axle something to rotate on, but also the keep the axle centered in the hole. When the bearing gets loose, it allows the axle shaft to have an oblong roation, which wears on the seal and allows it to leak. You don't have to run the trans low on fluid to have the output bearings go bad. If you have gone enough miles to wear out a clutch, you have gone enough miles to get some play in the bearings.

Jun 02, 2009 | 2003 Hyundai Tiburon

2 Answers

Oil leak problem with 1996 toyota camry


I am going to see a mechanic - my trusted mechanic who does not nickel and dime me - to see what this is. I have the same problem and he told me he has never done this job on a Camry and is unsure. Given the miles, he has suggested that maybe it is time to part ways with the car. I am going to ask him if he will put some florescent dye in it and let me drive it for 50-100 mi and then check to see where the leak is and fix it. Let you know what happens. I have to try, the car is solid.

Mar 30, 2009 | 1996 Toyota Camry

1 Answer

Transaxel leaks transmission fluid


was the seal put in correctly. there is a certain way that a seal must be installed. generally i like to bake sure that there are no burrs on the shaft that slides through the seal. also the rubber part of the seal is usualy dry and they should have given you seal grease to soften it up before installation. did you use a seal driver to install the seal? trying to just tap it in with just a hammer will usually damage it and then it will leak. double check to make sure it was the right seal it's been known to happen that you go and buy a seal and you get home and it's the wrong one. i'm sure the problem is a a mis installed seal. unfortunately when you remove the seal you will not be able to reuse it due to the damage . you will have to purchase another one. hope this helps. please rate this solution....thanks

Aug 31, 2008 | Hyundai Motor 1996 Elantra

Not finding what you are looking for?
Hyundai Motor 2003 Elantra Logo

Related Topics:

318 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...