Question about Mazda 929

Open Question

1993 mazda 929 sunroof opened but will not close.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

bigg t
  • 640 Answers

SOURCE: 1993 lincoln towncar sunroof switch

you should have 3 wires to the switch.n.o.--c--n.c.(normally open--common--normally closed).take the middle wire and connect to either wire to close the sunroof.experiment with the n.o and n.c wire until the sunroof closes,you wont damage anything.please rate me as fix ya,thanks---any ? let me know

Posted on May 25, 2008

polarcycle
  • 1392 Answers

SOURCE: sunroof will not close

If the motor is stuck, you can probably hold the switch to the forward position, and smack the roof. This may allow the motor to start working. I don't think there is any way to do it manually.

Posted on Jun 15, 2009

  • 3 Answers

SOURCE: 08 SRX Ultraview Sunroof hard to close

Try spraying silicone lubricant in the groove that the rear brackets slide in (from the mid section of the roof to the rear).

Posted on Nov 29, 2009

  • 15 Answers

SOURCE: 2005 mazda 3 sunroof

H Kim -

The "gearbox" is unfortunately under the headliner with no easy access. If you are also experiencing a clicking sound when the motor is activated, the regulator track had slipped position and will need to be reset.

I have been through this problem twice now. The first time the motor / gearbox came loose from it's mounts, began slipping (click, click,click), very nasty sound. I remounted the motor with threadlock on the screws, but alas.. two years later (mine's 2006) it slipped again.. I don't know why yet, I need to drop the headliner once more and have a look. If you would like a copy of your FSM, drop me a line.

Here's the RESET procedure from the FSM, absolutely gospel, no other way to fix it:
Sunroof Motor Assembly Note: Note • If the guide is removed, initial position setting of the sunroof motor will be required. After installing the sunroof unit, perform initial position setting using the following procedure. 1. Press the TILT UP switch to fully tilt up the glass panel.
2. When the glass panel reaches the fully tilt up position, temporarily release the TILT UP switch and press it again for approx. 13 s continuously. Continue pressing the switch until the glass panel automatically stops at the fully tilt up position after reaching the mechanical lock position.
3. When the glass panel stops at the fully tilt up position, temporarily release the TILT UP switch, then press it again within 5 s and hold.
Note • Press the TILT UP switch continuously until the glass panel opens to the fully open position, returns to the fully closed position and then stops. 4. Release the TILT UP switch when the glass panel stops at the fully closed position.



ALSO, Here's the clearance adjustment specs for having the glass panel in the correct resting position:


GLASS PANEL ADJUSTMENT
1. Fully close the glass panel.
2. Measure the gap and height difference between the glass panel and the body.
3. Loosen the glass panel installation screws and move the glass panel to adjust.


Standard clearance a: 0.2-2.2 mm {0.008-0.08 in} b: 0 mm {0 in} 4. Tighten the screws.
5. Insert any available thin plastic card between the weatherstrip and the body, and verify that they are sealed. (There is resistance when the plastic card is moved.)


• If they are not sealed, perform Steps 3-4 and adjust again.

Posted on Jan 01, 2010

  • 1 Answer

SOURCE: 03 Jeep Liberty Sport sunroof wont close.

03 Jeep Liberty sunroof wont close. I have 4 sunroof buttons; Open, Close, Vent and ASC. Open and Vent buttons are working fine. Close button is not responding. ASC button is flashing red and green but does nothing when pushed. I have no way to get it closed

Posted on Feb 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1993 Mazda 929 checked battery and starter is good turns over but wont start?


problems include
cam/ crank sensor failures
immobilizer not operational
flat fob key battery
broken timing belt /chain
ecm problem
no fuel pressure
run the fault codes to find the area ans sensors at fault

Jan 08, 2017 | 1993 Mazda 929

1 Answer

How do you reset computer and sensor lights on 1993 Mazda 929


try disconnecting - battery terminal for 10 seconds should clear codes

May 23, 2011 | 1993 Mazda 929

1 Answer

Need to finnd door panels


Try here - http://motors.shop.ebay.com/__?_from=R40&_trksid=p3841.m39.l1313&_nkw=mazda%20929%20door%20panel&_sacat=&rvr_id=216116190515&MT_ID=335&crlp=2765493868_9887&tt_encode=raw&geo_id=491&keyword=mazda+929+door+panel&adgroup_id=1077570238

Mar 08, 2011 | 1993 Mazda 929

1 Answer

I cant find a fuel filler neck for my 1993 mazda 929.does a 1993 mazda 626 fuel filler neck work for a 929?


You should be able to call a body shop and have them order you one. I used to work in my uncles body shop and you can get them. I have been out out of the body shop business about 10 year and don't have books anymore. On this I can not help you. You can e-mail Mazda, and they may be able to tell you. Try your friendly body shop, they can get it for you. hope this helps

Jan 13, 2011 | 1993 Mazda 929

1 Answer

An help closing the sunroof on a 93 Mazda MX-3? It opens but it doesn;t close. Fuse is OK. I can hear the motor when you press open but nothing when you press close.


Sounds like a faulty switch. If you pop it out and test it with a test light, You should see the power switching from one terminal to another.

Sep 08, 2009 | 1993 Mazda MX-3

1 Answer

I'm trying to find out where the module is located on a 1993 Mazda 929


TRANNY AND ENGINE COMPUTERS ARE BEHIND RIGHT KICK PANEL.

Feb 17, 2009 | 1993 Mazda 929

2 Answers

1993 mazda 929 v6


CHECK THE RUBBER INTAKE HOSE TO THROTTLE FROM AIR CLEANER BOX,CHECK FOR BREAK OR NOT SECURE PROPERLY.

Aug 04, 2008 | 1993 Mazda 929

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...