Question about 1990 Plymouth Acclaim

1 Answer

Blower motor resistor & vent intake on 1990 Plymouth Acclaim

I need to know where the blower motor resistor is located and where the outside air intake for the vent is located.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Plymouth Master
  • 6,674 Answers

Usually passenger side down under are where wipers are mounted. If you turn heater /defrost blower on high & listen standing on passenger side, you should be able to pinpoint it easier. Look below that on firewall and good chance your resistor is in that area.

Posted on Apr 15, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Can't locate the blower motor resistor

Here's a link to what your blower motor resistor look's like,it's next to the blower motor,2 screws hold it on.Blower Motor location can change from year to year. It can change with the trim level of the vehicle. A vehicle that has front and rear climate controls may be configured differently than a vehicle that has front controls only. The following are two different repair procedures. One is given because the blower motor is located and accessed in the engine compartment, the other is given because the blower motor is mounted inside the vehicle. Here's a link to your blower motor. GET 35 GIFT CARD FOR EVERY 100 SPENT ON ONLINE SHIP TO HOME ORDERS

Sep 28, 2015 | 1990 Cadillac Deville

1 Answer

Blower motor resistor location

Most likely on bottom or side of blower motor..behind glove box area most of the time

Sep 06, 2014 | 1990 Plymouth Acclaim

1 Answer

How to troubleshoot low air flow from the vents on a 2000 Toyota Echo?

check the polartily at the fan & make sure the fan is turning the correct way
but first check the cabin filter/air intake is no blocked

Apr 04, 2014 | Toyota ECHO Cars & Trucks

1 Answer

Pontiac g6 2006 heater/ac fan doesnt work on #3 speed setting, fan made squealing bearing noise for a while but quit, also inside/outsied air vent switch vent makes clicking noise when set to outside air

you will need to replace the blower motor as it has probably siezed going by the squealing noise you say you heard.i`m assuming this has more than 3 speeds for the fan motor.if it wasn`t working on one speed then you probably have a bad blower motor resistor that will need to be replaced as well so you will have all fan speeds.this is located in the air duct housing near the blower motor and will have about 6 wires on it.some of these on under the hood on the firewall anywhere from the passenger side to the center of the firewall.not sure about the vent switch.if the vent switch is moving the doors and you hear a clicking then you may have a vent door problem that the door pivot is worn.

Nov 01, 2013 | 2006 Pontiac G6

2 Answers

My blower motor works sometimes, but sometimes not. It seems to work better if I am at higher speeds for a while. Is this most likely a blower motor or resister issue?

bet on the motor on this one,sounds worn,at higher speeds the vibration can help the brushes in the blower motor work better.
you can test my theroy by giving the blower mortor a sharp tap while its running to see if it increases in speed.
if it does then you have your answer.
the brushes in the blower motor build up carbon deposits over time and cause the motor to slow tapping the motor the deposits release and allow the current to flow more freeley.
good luck,Gary

Oct 24, 2013 | 2001 Mazda 626

1 Answer

The air conditioner wont turn off at all in my 1993 cutlass ciera

Replacing the AC blower motor resistor in most cases cures this problem. The blower motor resistor is located next to the blower motor and the connector is on the outside of the air ducting.

Sep 06, 2012 | 1993 Oldsmobile Cutlass Ciera

1 Answer

Heater blower does not blow

blower motor resistor open circuit located under hood behind washer reservoir

Dec 13, 2011 | 1989 Plymouth Acclaim

1 Answer

Why won't the blower motor work in my 1990 plymouth laser

you may have a relay that is not working or your blower motor is simply burnt. find the connections for the blower motor uplug and test to make sure you are getting power to the blower.if you are then test the blower motor.if that is allright then test your resistors for the different speeds .it may be one or all but in my experience 90 percent of the time the blower motor is the culprit.

Nov 21, 2011 | 1990 Plymouth Laser

1 Answer

Where's the ac blower motor located on a 94

Under the dash on the passenger side. It has two wires connected to it and looks like a cylinder about 3" in diameter.

Sep 01, 2011 | 1994 Plymouth Acclaim

Not finding what you are looking for?
1990 Plymouth Acclaim Logo

338 people viewed this question

Ask a Question

Usually answered in minutes!

Top Plymouth Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Plymouth Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides