Blower motor resister instalation, were & how

The blower motor is located under the right side of the dash in the A/C Heater housing. Disconnect blower cooling hose. Remove blower connector from retainer and unplug the connector. Remove the 3 blower motor screws and remove blower motor. Reverse procedure to install..

The blend door may not be working properly. It is actuated by a vacuum motor.

or the following part may be bad:

Blower Motor Control Module Removal & Installation To Remove:

1. Remove the insulator from the right side of the instrument panel.
2. Disconnect the connectors from the blower motor resistor and blower motor.
3. Loosen the two forward screws and remove the rear screw of the resistor assembly.
4. Remove the blower motor resistor assembly.

To Install:
Install the blower motor resistor assembly. Install the rear screw and tighten the forward screws. Connect the electrical connectors to the blower motor and resistor assembly. Install the insulator under the right side of the instrument panel.

BLOWER MOTOR IS LOCATED UNDER THE INSTRUMENT PANEL NEAR THE GLOVE BOX.

The Blower Motor Resistor is located behind the glove box on the dash. Remove the whole glove box to access. The Resistor is mounted against/sort of into the fire wall.
1. Disconnect the negative side of battery.
2. Disconnected the Electrical Connection to the Resistor.
3. Remove the bolts/screws. I believe they have 8mm heads, there should be 2 of them.
4. Replace with new one/Replug electrical connection.
5. Reconnect the negative side last.
6. Test System before putting the glove box back in!
The Blower Motor is easy (compared to $1000) to remove and replace.

You need a blower motor resistor, it's located in the blower housing under the dash

Check owners manual for location of heater blower motor front,check with a test light,if it's good locate blower motor under glove box and test the two wires for power when switch is turned on,if power is present motor needs changed.if no power check blower motor resister.

There will be a blower motor resister very close to the blower motor,It will have 7 wires going to it,give,or take one.Also,it mounts with two screws.This is your speed control.Remove the resister,and replace it with a new one,available at auto parts house.

Passenger side under dash right next to connector for blower motor,Should have 5 wires to connector and be flat connector.Helpfull hint is to change blower motor when changing resistor,( blower motor is what causes resistor failure.

try the fan relay should be located on the heater box

Hi my name is Allen!

If the blower motor is not working the most likely cause is the blower resister, but you must replace the blower motor also because the resistance build-up inside the motor is what damages the resister.

For further asistance you may reach me at FixYa!