Question about 2000 GMC Jimmy

1 Answer

Chevy s10 will not start

I have changed my fuel filter, my fuel pump, and fuel is getting to the injectors, and i have spark...but the truck will still not start

Posted by on

  • carhob May 11, 2010

    have u check fuses,ecm,ign.,engine?

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 89 Answers

Make sure the fuel pressure is to spec (65-70)psi
These V-6 engines had problems with the fuel injection poppets.They would gum-up and cause a hard-no start problem.check with your local dealer,some injectors had extended warranty period,because of the problem.if you spray alittle carb spray in the intake,does it start?

Posted on Oct 07, 2009

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 1991 Chevy S10 Pickup

First check for battery voltage. Then make sure you have a check engine light when the key is in the run position. Make sure the fuel pump relay is good. Check to see if there is power on one side of the injectors, if these wires have a short to voltage or ground the injectors will not funtion properly. In this system the injectors are supplied with constant power and ground controls pulse width. In these blazers and s-trucks PCM ground sees to become an issue. In mine I directly routed the system grounds to a metal body panel under the right side of the dash. In my Blazer I swapped out the motors and converted from and automatic to a manual transmission. And another problem I found was when I lifted the dash to install my clutch pedal, I broke my brake light switch. In an automatic the brake pedal switch interups the ses light circuit. If the PCM dosent sense the ses light on the system cannot ground. Good Luck with it, At the time I had completed my second of four automotive level so it took me a bit to figure it out on my own. Once I took my level 3 (electricl) it sunk in alot quicker. Happy hunting, don't get too pissed off.

Posted on Nov 19, 2008

  • 2 Answers

SOURCE: 96 s10 won't start

I would start with checking the battery, belts and fuses. Some places like Autozone will check the battery under a load for free. If all that checks out, then move on to fuel and spark. That will give you a good indicator of where to go from there. If you have no spark then you are moving on to your coil, distributor, etc. If you have no fuel then you would check your filter, injectors pump etc. Keep in mind that a broken timing chain/belt will cause a no start condition as well, as will a faulty neutral safety switch, so if nothing else seems to add up you might check those as well. good luck

Posted on Jan 29, 2009

emissionwiz
  • 75051 Answers

SOURCE: 1992 chevy s10 will not start

does the exhaust sound restricted? if u are not sure most muffler shop will test for a restricted Cat for free.

Posted on Apr 15, 2009

  • 729 Answers

SOURCE: Chevy s10 will not start

check your battery voltage first sir! it should not be at most 12 volts. if it's almost 10volts or lower, then it needs recharging or replacement, (which ever you prefer! you may having spark at 10volts but its not enough to ignite the air-fuel mixture inside the engine.
check also the air filter, there should be not water trace in it! check oil, should not be milky.

Posted on May 28, 2009

  • 142 Answers

SOURCE: truck wont start already change fuel filter

when you turn the key on you should hear a humming or whinning noise coming from the fuel tank if not,then its your fuel pump which is a very common problem

Posted on Sep 28, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

07 chevy cobalt 2.2L no injectors pulse!the fuel pump works fine!when I spray starter fluid inside the throttle body & than the want to start...NEED HELP PLEASE!!! LIKE A.S.A.P


Hi,

I would check n replace the fuel filter if needed. Also, it could be one of the spark plugs. Was it running before? Can you think of anything that happened or changed recently?

Aug 08, 2016 | Cars & Trucks

1 Answer

No fuel spray from injectos


1986 chevy s10 2.5l no gas coming from injector. - S-10 Forum

www.s10forum.com/.../1986-chevy-s10-2-5l-no-gas-coming-from-inject...
Sep 2, 2009 - 24 posts - ‎7 authors I have no gas coming from my injector it a 1986 chevy s10 2.5l I have replaced the fuel pump,oil pressure switch & I checked and oil would ...

Oct 12, 2015 | 1988 Chevrolet S-10

1 Answer

1995 Chevy S10 V6 4.3L 4x4 Pick up truck wont start


Make sure battery has a full charge. If it cranks good but won't start, have a helper crank it while you visually check for spark at the spark plugs. If spark everywhere, use a gage and check proper fuel pressure and fuel injector pulse.
If you have tbi fuel injection, fuel pressure is 9--13 psi.
If you have cmfi fuel injection, my info says 55--61 psi.

Apr 24, 2017 | Cars & Trucks

1 Answer

2002 chevy s10 turns over but will not fire after changing clutch


I can't imagine what could cause the engine not to start by just pulling the transmission out.
Are you getting spark to the plugs and fuel to the injectors ?
Fuel pump is running when you turn the key switch on ?

Feb 09, 2013 | 1998 Chevrolet S-10 Pickup

2 Answers

My 93 s10 2.8 just shut off and woulnt start, I'm


Are you not getting fuel to the throttle body? Or are you not getting any injector pulse? BIG DIFFERENCE!

If you have lost injector pulse and spark at the same time, the most likely cause would be a failed distributor module.

Apr 14, 2012 | 1993 Chevrolet S-10

2 Answers

My chevy s10 2001 turns over but does not start its not getting gas to injectors


Well you need fuel to the injectors, a spark, compression, air and a signal to the injectors to fire for the engine to start.
So if you've got fuel, make sure you have spark to the plugs, the air filter is not clogged, compression is above 120, and the crank and cam positions sensors are good.

Jan 21, 2010 | 2001 Chevrolet S-10

2 Answers

88 chevy s10 fuel pump working. carburetor


did you try changing the fuel filter? it could be completely clogged

Oct 28, 2009 | 2000 Chevrolet S-10

1 Answer

Chevy s10 will not start


check your battery voltage first sir! it should not be at most 12 volts. if it's almost 10volts or lower, then it needs recharging or replacement, (which ever you prefer! you may having spark at 10volts but its not enough to ignite the air-fuel mixture inside the engine.
check also the air filter, there should be not water trace in it! check oil, should not be milky.

May 28, 2009 | 2000 GMC Jimmy

1 Answer

Have a 1994 chevy s10 blazer with a vortec 4.3 changed fuel filter,fuel pump,plugs,wires,and module in the disturbuter.still will not start


You need to check and make sure you have fuel pressure, then check for spark at ignition, if those check out then check for pulse width at the injectors. That basically is the electrical signal which tells injectors to spray fuel. Use what is called a Noid light on injector pulse width check. that will eliminate all possibilities other than internal issues with engine. I.E. broken cam, broken timing components, obviously if all I mentioned checks out then run compression test. Good Luck

Jul 15, 2008 | Chevrolet S 10 Cars & Trucks

Not finding what you are looking for?
2000 GMC Jimmy Logo

429 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...