Question about 1999 Buick Park Avenue

1 Answer

1999 buick park avenue change battery now stereo has no display

Check fuses and relay there good

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Can anybody give info on what I need to do to get my radio and AC back on since I changed the battery

Posted on Aug 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 park avenue


No lights are most likely the dimmer switch at the light switch, Replace it. rear defrost, could be a broken wire, switch is bad, or the little stands that go across the window, one is broke. No heat, probably the vent motor on the passenger side under the dash, close to the center console.

Jan 13, 2015 | 1999 Buick Park Avenue

1 Answer

98 Park Avenue Instrument Cluster Stopped working


Always check your fuses first to see if they are blown.

Jan 27, 2013 | 1998 Buick Park Avenue

1 Answer

Cant find turn signal relay on a 1999 buick park avenue


Should be a little(usually silver) square box plugged into your fuse panel, usually above your left leg in drivers seat. Most vehicles , although i am not familiar with the Park Avenue. Probably has a cover that would have to be dropped.

Nov 23, 2010 | 1998 Buick Park Avenue

1 Answer

My front seat in my 1998 buick park avenue will not move forward nor back, is there a relay for this?


Hi! If it has switch control, then most likely it has a Fuse or Relay... emergency fuses is located by the driver seat left foot,
under the dashboard. The Controler fuses or relay is most likely located under the hood by the driver side or near by the car battery... You may also want to check the motor relay or the motor it self, sometimes this will cuase the problem that the motor is no longer generating power. Check the Manual for fuses guide or fuses ampers. best of luck.

Glad to help.
Ginskie.


Sep 22, 2010 | 1999 Buick Park Avenue

1 Answer

Need to find heater blower resistor on 1991 Buick Park Avenue


GM: Electra/Park Avenue/Ninety-Eight 1990-1993 REpair Guide
Blower Resistor Module


b4bdc8d.jpg

Fig. 1 Blower resistor assembly is underneath the fuse block
REMOVAL & INSTALLATION

  1. Disconnect the negative battery cable.
  2. Remove the rear sight shield.
  3. Remove the fuse/relay block assembly and bracket.
  4. Disconnect the resistor module connector.
  5. Remove the retaining screws and remove the resistor module.

To install:
  1. Inspect the gasket and replace or repair as required.
  2. Install the resistor module and secure with screws.
  3. Connect the resistor module connector.
  4. Install the bracket and fuse/relay block assembly. Install the sight shield.
  5. Connect the negative battery cable, and check the climate control system for proper operation.
Hope this help (remember rated and comment this).

Mar 29, 2010 | 1991 Buick Park Avenue

1 Answer

My buick park avenue wont start, i think its a fuel pump relay


the relay can be found in the fuse box thats located under the hood open the box and look for the fuse or relay that says fuel pump. this fuse box is usually on the drivers side of the vehicle but it can also be on the passenger side.

Jan 30, 2010 | 1994 Buick Park Avenue

2 Answers

1994 buick park avenue . driving home and shut off


how did you jump the fuel pump relay, by bypassing the relay or by applying power to contact that closes the relay? If you bypassed the relay completely you need to b ench test the relay you can do this easily by using any 12v dc power source. If you tested the fuel pump relay by applying power to the relay and the pump run and developed pressure. I suspect a wiring or ground issue. Good luck

Oct 07, 2009 | 1997 Buick Park Avenue

1 Answer

96 park avenue radio removal/installation


http://www.ehow.com/how_5437765_install-radio-buick-park-avenue.html

wiring diagram

http://www.modifiedlife.com/1999-buick-park-avenue-car-stereo-wiring-diagram/



Jul 17, 2009 | 1999 Buick Park Avenue

1 Answer

Electric controls in door won't work after battery change


Could be a fuse..
Could be a relay..
Could be a bad control panel in the door..
See if there is power getting to the controal panel..

Hope this helps !!
rate me good ;o)

Jul 14, 2009 | 1999 Buick Park Avenue

Not finding what you are looking for?
1999 Buick Park Avenue Logo

Related Topics:

253 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...