Question about 2000 GMC Jimmy

1 Answer

How do I remove the dash board to access the thermostat? Heating won't shutdown...A/C doesn't come on. 2000 Jimmy.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 548 Answers

On the edges of the dash are a series of hidden clips, use a small screw driver or plastic scraper (better) to pry the dash pieces up and loosen them from the clips. I assume you are just taking the face off and not the top of the dash. You want to stay away from the areas that house the airbags.

Posted on Apr 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove center of dash in 2004 touareg


No need to remove dash, it's accessible from underneath. Its your door control motors for your a/c. there are 3 of them total

May 23, 2014 | 2000 GMC Jimmy

1 Answer

'99 olsmobile heating and ac


You have a problem most likely with the air temerature control blend door actyautor or the door is jammed or in most cases both. Repair requires the dash to be removed so have it properly diagnosed as the repair is well over $1000.00

May 07, 2013 | Cars & Trucks

3 Answers

Hi, heater fan is blowing cold air and sometimes warm air depending on when i start the engine.


could be your heater core or thermostat ,check to see if your water pump has a leak

Jan 27, 2011 | 2000 GMC Jimmy

1 Answer

I have a 99 GMC Jimmy,4wd,4.3L,with climate control. I cannot switch mode on heat/ac,it constantly blow warm/hot air,also can hear a "clicking" sound behind dash,was told this a a "blend door motor"...


yes there is a procedure,but no short cut in removal of dash board.but my advised is that pleased contact a perfect electrician to remove it safely because of the electrical wires.

Aug 08, 2010 | 1999 GMC Jimmy

1 Answer

2000 GMC JIMMY WHERE IS THE HEATING CORE


usually its under the passanger side dash, but when in doubt follow the coolant lines, they should be about an inch around

Jan 02, 2010 | 2000 GMC Jimmy

1 Answer

How to remove plastic housings to access heater core. Have already removed dash and other components.


remove the small 7mm head bolts surrounding the case cover and pull towards you gently.Just watch there are 2 hidden on the bottom near the floor.

Dec 27, 2009 | 2000 GMC Jimmy

1 Answer

How do you remove a heater core from a 2000 GMC JImmy


2000 GMC Jimmy heater core replacement in order to replace a heater core in a 2000 gmc jimmy the coolant must be completely drained and the entire dash including radio, vents and panel covers must be removed. four screws hold the top portion(closest to the windshield) in place. they can be found under the windshield defrost vent. after the entire dash is removed a safety harness under the steering column must be removed and the steering column must be dropped to the driver seat. the heater core housing(black plastic) is located right center of the dash and is a two part housing one piece on top of the other. the housing is attached to the fire wall and must detached before replacement can continue. after detaching the housing from the fire wall separate the housing by unscrewing the six screws that hold it together. the heater core is now exposed. disconnect the heater core from the two hoses and discard. installation is the uninstall process in reverse. it is a very long and drawn out process that is not accomplished in just an hour or two . make sure you have most of the day or several afternoons to finish . Good luck and take pictures with your cell phone to use as reference.

Nov 27, 2009 | 2000 GMC Jimmy

2 Answers

200 gmc jimmy st heater


Had similar problem in my 2000 Jimmy. No hot air from heater. Had the shop (Midas) disconnect heater hoses at the fire wall and blow out the heater core with air hose. Got rust and junk blown out. Hooked up and flushed system with new anti freeze. Got lots of heat now.

Oct 25, 2008 | 2000 GMC Jimmy

2 Answers

1998 Jimmy-heater core


Heater core is located under the dash board, as Jenkins said you need to remove the dash board amd all other panel to access it, you will have to spend at least 2 hours to remove them if you're not familiar with it, becareful not to break plastic locks and tabs. Get your self a service manual for your car and it will be a great help.

Oct 17, 2008 | 1998 GMC Jimmy

Not finding what you are looking for?
2000 GMC Jimmy Logo

Related Topics:

118 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...