Question about Chevrolet 2500

Open Question

The passenger kick panel vent does not open. Just looking for troubleshooting tips

The interior vacumm operated vent on the passenger kick panel does not open. Whats the best way to diagnose what part needs to be replaced? Steve

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
ginko
  • 19396 Answers

SOURCE: Need to replace the driver's door interior door opening assembly

Hi there.

The procedure is roughly the same for all mk3 x types.
You need to remove all the screws on the armrest and on the ashtray, then undo all the plastic clips using screwdrivers on the panel.

You find detailed instructions on links below, I quote:

" remove two screws at the bottom of the armrest.
pull out ash tray.
remove screw in the middle of the ash tray holder.
pull up on armrest, it should pop up, then pull it out
start at bottom right of door and start popping out the plastic clips (all the way around the door)
(remove speaker wires)
push up door panel - done"



WikiAnswers - How do you remove a rear door panel in a Jaguar XJ6


Also from manual:

Disconnect vehicle battery ground lead.
Remove the door trim pad veneer panel.
Remove the upper trim pad.
Remove the door armrest.
From inside the door pocket, release the puddle lamp (1 Fig.1) securing quarter turn fastener.
Undo and remove fixing (3 Fig.1), (front door only)
Carefully release lower trim pad fir tree fasteners.
To avoid damage and distortion of the door metal, lift the lower trim pad complete with clip and clip retainer.
Carefully pull the trim pad away from the door panel.
Disconnect the multi-plugs (1 Fig.2) and remove the lamp.
Carefully displace the trim pad (2 Fig.1) from the door retaining clips.
Disconnect the multi-plugs (2 Fig.2) and (3 Fig.2).
Remove the door pocket.
Displace and remove the retaining clips and remove the trim..
Refit in the reverse order of the removal procedure. Check the trim pad retainers for damage before refitting.

Before refitting the lower trim pad, remove the clip retainer from the pad and and reposition retainer to the door.

ndo door handle escutcheon screw and remove escutcheon
Remove the door trim pad veneer panel.
Undo and remove the upper trim pad securing screws.
Remove the chrome strip.
Undo and remove the top channel securing nuts.
Displace and remove the top channel assembly.
Place the trim pad aside (Fig. 1).
Refit in the reverse order of the removal procedure.

bbad647.gif

36a4a47.gif

cc1f9fe.gif

Thanks Jaguar XJ6 Interior Lights

I will be grateful if you can rate the solution given.

Many thanks.

G.

Posted on Feb 25, 2009

Ad
  • 1 Answer

SOURCE: Replacing passenger side-view mirror on 1999 Dodge Stratus

Watched my dad do it this afternoon. There is an exposed screw on the left side of the door panel and one at the bottom of the panel. There are also two hidden screws, one behind the door handle and one inside the little hole in the armrest (pop off the plastic plugs). There are also three recessed screws behind the speaker cover. You can pop the speaker cover off with a flathead screwdriver. I'm pretty sure thats all of them. You can pop the panel off then, but watch the wires connecting stuff inside. The hardest part is getting it over the door lock. .

Once the panel is loose you have to pop off the black plastic cover hiding the back of the mirror. There are three recessed bolts holding the mirror. My dad had to get a special wrench to get those off and he dropped one inside the door, so be careful (we fastened a magnet to a coat hanger and got it back). Mine had some remote gizmos, so he had to had to unplug the little square thing and then popped off what was left of the old mirror. If your new mirror has a wire with a little box, feed it through the hole and plug it in. Once you have it positioned correctly, you can screw on the bolts and put eveything back together. It helps to have another person there while you are trying to position the mirror correctly. Hope I didn't miss anything. Good luck!

Posted on Apr 23, 2009

  • 548 Answers

SOURCE: interior door panel removal 04 honda civic

you must carefully pop off the door plastic clips using a screwdriver and prying gently until they pop out , also remove the screws under any small round plastic screw cover inserts and in the plastic door handle area

Posted on Sep 19, 2009

roniecon
  • 6927 Answers

SOURCE: need to locate blend door actuator on 2002 ford

Open the glove box,and look on top of ac/heater box toward the center of vehicle,it should be setting right there.

Posted on Oct 10, 2009

  • 1 Answer

SOURCE: Infiniti G35 trunk won't open

I had this problem as well.
The wiring harness in the trunk is a bit short and some of the wires fray. when this happens, the car doesn't recognise that the fob is close by so it fails to open.
Just pull back the boot near the trunk hinge on the passanger side and look for frayed wires.

Posted on Dec 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOW DO I CHANGE THE HORN FUSE ON MY 1999 BUICK LESABRE


Jim, Remove passenger side kick panel to access the fuse box where horn fuse is located #3 fuse in your manual, box fairly high up under dash. Horn relay under hood/engine compartment fire wall.
Check the attached links,instruction and guides and a manual for your buick, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Interior Fuse Box Location 1990 1999 Buick LeSabre 1992 Buick LeSabre...
Troubleshooting broken Horn or fuse or relay GM Buick LeSabre 1994 1995...
http://pdfstream.manualsonline.com/8/81776d98-998a-493c-aac6-a5895c51d47b.pdf
Horn doesnt work Ricks Free Auto Repair Advice

Jun 27, 2016 | 1999 Buick LeSabre

1 Answer

Remove passenger kick panel


passenger kick panel Debra, Check the attached links,instruction and guides, 1st link will download pdf. showing how all panels are removed., Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

http://schwarttzy.com/wp-content/uploads/2013/01/Hummer-H3-Interior-Trim-Paneling-1.pdf
Hummer H1 Service Manual Inner Kick Panels Replacement
Body Control Module Repairing Bad Solder Joints

Mar 31, 2016 | 2006 Hummer H3

1 Answer

2006 750li passenger defrost not working


BMW defroster works on vacumm so if you have air blowing from the dash vents when the seclector is on A/C and when on bi-leval the air comes out of the dash vents and the floor vents then you have a vacumm leak most likely a vacumm hose is off, Or due to the age of the car the engine heat causes the hoses to crack and break. the BMW V-8 engine has a problem with the rubber holder for the PCV valves cracking and leaking that causes very low vacumm pressure also check all of the vacumm lines that go through the fire wall most likely your problem is just a disconnected or broken vacumm hose or the PCV valve holders.

Dec 14, 2014 | 2006 BMW 750Li

1 Answer

I posted a question about my 2000 mazda mpv when I turn on the heat in the front it blows hot on passenger side but not on driver side in fron by steering wheel


i cant give a direct answer i can only ask questions has anyone been under the dash put radio in heater core anything and knocked the vents loose do you hear air hissing or vacumm leak check fuse box for heater vents a/c vents blown fuse look under hood if you hear air look for loose hose going to firewall

Oct 13, 2014 | Cars & Trucks

1 Answer

Where is the fuse panel for my 1995 Jeep Grand Cherokee?


You have one under the hood near the battery and one on the passenger side interior kick panel (or near it, visible with the door open)

Jun 11, 2010 | 1995 Jeep Grand Cherokee

1 Answer

GMC 2003 truck heater/ac not consistent.


check for any vacumm hose leaks that comes from the engine to the ac box, check for vacumm actuator proper operation.

Jul 21, 2009 | 2003 GMC Yukon XL

1 Answer

2000 ford expediton a/c is blowing air but not through front vent


the problem is a vacumm leak , the control panel works with vacumm from engine supplied by small hoses and also have an vacumm tank under right front fender , check for disconnected hoses or break, the main vacumm hose is on engine intake manifold, ahh , also check control panel

Apr 25, 2009 | 2000 Ford Expedition

2 Answers

How do I open the fuse box under the hood? Are there any other fuse boxes?


theres 3, one under the hood, 2 inside the vehicle ..the interior fuse boxes are on the sides of the dashboard on both drivers and passenger sides. open the doors and look for the removable panels on the dash between the drivers and passengers dashboard.remove the panel....u will see the 2 interior fuse boxes...these 2 interior fuse boxes house the vehicles multiplex control units..

Apr 15, 2009 | 2002 Honda Accord

1 Answer

Fuse Box Cover for 2006 Mustang


For the interior (passenger side kick panel) reach to the side of the fuse box and with your fingers pull the tabs out all the way from the back. It is a tight space, be ready for some scratches depending on how big your hands are.

Mar 19, 2009 | 2006 Ford Mustang

2 Answers

1999 ford f350 super duty vents only blow on defrost.


I am going to assume this truck is a diesel. If it is there is a small vacumm motor on the passenger fender well and a vac tank next to it. Chances are the vac motor has gone out. Most of the time there is a reason this motoe fail. It usually means there is a vacumm leak somewhere in your system forcing the vac pump motor to run to much burning it out!

Jan 03, 2009 | 1996 Ford F350 Crew Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...