Question about 2007 Mitsubishi Outlander XLS

1 Answer

Paint issues with 2007 Outlander

I baught a bran new outlander 2007 on oct 22nd 2008. I only have 32,000km to this day and I have lots of paint chip on my hood and side panels. My car being fire red, the paint gone shows a white spots, and I have lots, soon my car hood will be whitw!

In the past with my other cars, I usually did about 60,000km in the same time (1 and half yrs) and NEVER did I have that much paint damaged on these cars.

Do Mitsubishi use cheaper paint then Honda, Gm, Chevrolet, Dodge and Oldsmobile? These are the past cars I owned, all baught new...

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 226 Answers

There probably a whole batch of them from the factory that weren't prepped right for the final coat... I think it's a factory error. I would complain to the dealer and the company. I don't think they use any cheaper paint, and essentially use the same techniques in painting the vehicles.

Posted on Apr 14, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

What is the cylinder head bolt torque settings fir a 4g69 mitsubishi engine ?


Apply engine oil to the thread of the bolts and to the washers.
Tighten the bolts to the specified torque, using the tightening sequence shown.
Tightening torque: 54 ft-lb +/- 2 ft-lb
Loosen all bolts fully in the reverse order of tightening.
Re-tighten the loosened bolts to the specified torque in the tightening sequence shown.
Tightening torque: 15 ft-lb +/- 1 ft-lb
This step is to make it easier to ensure you are making 90 degree turns. Make a paint mark across each bolt head and cylinder head.
Tighten the cylinder head bolts 90 degrees in the specified order.
Tighten the bolts another 90 degrees in the specified order and check that the paint marks on the cylinder head bolts are aligned with the paint marks on the cylinder head.
Link to the guide for this engine:

Aug 04, 2014 | 2007 Mitsubishi Outlander 2.4

1 Answer

My outlander 2007 battery keeps running down. I have bought two new batteries in the last 3 months and also changed my alternator

Why wouldn't you have had the current drain diagnosed
to find out the problem?

Was the Alternator tested & found to be bad or either
battery found to be bad

We can't guess from the internet

The vehicle should have been properly
diagnosed & resolved long ago.

There are 300 or more people on this site a day,
who apparently don't know how to find any repair
shops or dealers that can resolve anything at all

Dec 07, 2012 | 2007 Mitsubishi Outlander XLS

1 Answer

2007 Mitsubishi Outlander XLS

Sounds like your alternator stopped working....

Jul 20, 2017 | 2007 Mitsubishi Outlander XLS

1 Answer

Replacing brake lamp in 2006 mitsubishi outlander

put some tape on a flat screw driver a pry the lense off keep wiggling the lense and it will come off be carefull not to scratch the paint good luck CJ

May 12, 2010 | 2006 Mitsubishi Outlander

2 Answers

How much is it to get a 2005 outlander repainted

From Econo paint or MAACO for about 199.00 up to 5,000 custom paint - 5eeb193.jpg

Apr 27, 2010 | 2005 Mitsubishi Outlander

2 Answers

Paint chipping and cracking issue

sounds like a port of entry paint repair. A lot of times cars get damaged in transit and the repairs are carried out with out the knowledge of the dealer or the new owner at the port of entry. Usually without much thought of using the right flexable products so the bumper lasts, it looks good but cracks later.

Apr 14, 2010 | 2009 Hyundai Genesis

2 Answers

What are the best tires suitable 07 Outlander XLS They have a great setup on deciding which tires you want with a ton of information.

Nov 18, 2009 | 2007 Mitsubishi Outlander XLS

1 Answer

I need to take off my headlight on my 2003 outlander, How do I do this>

To do this safely you need to remove the bumper.
The headlight has 3 10mm bolts holding it on.
If you remove the one vertical screw from back edge of the bumper and the plastic fasteners across the top, you can usually pull the bumper far enough away to sneak the headlamp out, just be cautious of your paint.

Aug 29, 2009 | 2003 Mitsubishi Outlander

1 Answer

AM Band in Rockford Fosgate 6 Disc Changer not working

check it out w/dealer and some mitsubishi seems like there is an issue with some corrosion in the antenna base on some models from 2007. Under warranty replaced the antenna base.

Jun 18, 2009 | 2007 Mitsubishi Outlander XLS

Not finding what you are looking for?
2007 Mitsubishi Outlander XLS Logo

Related Topics:

272 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides