Question about 2006 Kia Sedona

Open Question

RADIO REMOVAL How do I remove radio on 2006 kia sedona without breaking the trim

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
eitan
  • 291 Answers

SOURCE: remove factory radio

This is one that you can stare at all day. the trim pieces that include the air vents (usually woodgrain) will come off and expose the screws that hold the radio in. They are held in by spring clips, a gentle pry will get you started. Here is a website that shows how to remove one for a cell phone mount: http://www.bracketron.com/main/xmain_landing_page.php You may have to take the climate controll screws out to get the radio out far enough to reach the plugs on the back. You should be able to figure out the rest. good luck, and be gentle.. the trim is getting cheaper and cheaper, and is really easy to break.

Posted on May 15, 2008

Ad
pippall
  • 1486 Answers

SOURCE: tape stuck in radio system

with the ignition switched on. use a long nose pliers and pull pressing the eject button the same time.

Posted on May 31, 2009

  • 98 Answers

SOURCE: 2009 Saturn Outlook radio removal

start by carefully prying the woodgrain/brushed aluminum panel around the column shift upwards. Start at the rear, near the cubby. be very careful not to break it where the panel wraps around the drivers side of the shift indicator. when it is removed, you will see screws holding the next panel on (may be 7mm hex or philips - can't remember...) once removed, you can pry that section off as well exposing the radio and climate control screws. both have to come out to get the radio out. the XM portion is not in this radio, but is actually in the rear end of the truck behind the side panel on the driver's side. Be careful if you go poking around in there, because you may have a power inverter back there feeding 115v power to the center console (entertainment package).

Posted on Jul 21, 2009

inkedsgt
  • 359 Answers

SOURCE: 2006 Cadillac STS - How do i remove the plastic

it is all clips and a couple of hidden screws torx bit # 15

Posted on Nov 30, 2009

  • 68 Answers

SOURCE: how to replace radio in 2007 kia optima

The trim snaps in, no screws! I have used a hook type screwdriver, the kind used to install springs... I carefully insert the tool between the lower left corner of the radio and the bezel. Rotate the tool 90 degrees toward the bezel and pull straight out. Id say it comes off with maybe 15 pounds of pulling force. The radio is screwed in with brackets. You'll see once the bezel is off. **Keep in mind that many Optimas use an external amp located between the right rear door and wheel well. Also, some use 2 ohm speakers, all the way around. You may need to change all of it to upgrade your sound system, I did**. Good luck.

Posted on Jan 29, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Factory stereo not working and needs replaced. how does dash come apart to do this


REMOVAL

  1. Disconnect and isolate the battery negative cable.
  2. Remove cup holder.
  3. Remove trim panel above cupholder by pulling straight out.
  4. Remove center instrument panel trim panel.
  5. Remove screws holding radio to instrument panel.
  6. Pull radio rearward to gain access to the back of radio (RADIO). CAUTION: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.
  7. Disconnect the antenna cable by pulling the locking antenna connector away from the radio (ANTENNA TO RADIO).
  8. Disconnect bolt holding ground strap to the radio (if equipped).
  9. Disconnect the wire connectors from the back of the radio.

Nov 19, 2013 | 2002 Dodge Grand Caravan

1 Answer

Horrible AM radio reception in 2006 kia sedona


While a.m. radio does not get very good reception anyways,they have after-market antennas that will improve reception to the radio.You can get it at the parts store or you can have it installed at a car audio installation center.

Oct 06, 2010 | 2006 Kia Sedona

1 Answer

REMOVAL OF THE RADIO


Here ya go!

4c47b30.gif
Exploded view of the radio, tape player or CD player removal, 1990-94 vehicles

  1. Disconnect the negative battery cable. Wait at least 60 seconds before beginning the remainder of the procedure, in order to disarm the Supplemental Restraint System (SRS).
  2. Using a plastic trim tool, remove the radio panel. Pry the lower part of the radio panel away first, then separate and remove the panel.
9d61d07.gif
Using a plastic trim tool, carefully pry the radio trim panel away

08e17de.gif
Remove the center trim panel for access to the radio retainers

WARNING When removing and installing the floor console, do NOT allow it to bump against the SRS-ECU!

  1. For 1995-98 vehicles, remove the floor console assembly, as outlined in Section 10 of this manual.
  1. Remove the mounting bolts and pull the radio receiver, tape player or CD player out slightly. Detach all harness connectors and remove the unit from the vehicle.
4c48f2d.gif
After removing the console, unfasten the radio mounting screws

e7143a0.gif
Pull the radio out enough to access the connectors

4cb0996.gif
Unplug the electrical connector from the rear of the radio ...

3795675.gif
... then disconnect the antenna lead and remove the radio from the vehicle


Installation is the reverse of the removal procedure.

Oct 29, 2009 | 1992 Eagle Talon

1 Answer

How do i remove the stereo from my car to put another one in it


start by lookin all around the radio trim peices for screws make sure check behind the ashtray.after all that pry all the trim off should be a few screws holdin radio in remove them an the wireing harrness from the back of radio an antenna plug.by the wireing harness at local radio shop to plug into faactory wireing harness.makes jib alot easier.if u need more detailed help send me a pic of the radio

Oct 03, 2009 | 2006 Kia Rio

1 Answer

Tape stuck in radio system


with the ignition switched on. use a long nose pliers and pull pressing the eject button the same time.

May 31, 2009 | 2006 Kia Sedona

1 Answer

2006 hyundai sonada need to replace radio


Plastic trim removal tools are required for this job or you will break something. Recommend you refer this job to a Hyundai Dealer.

Mar 27, 2009 | 2006 Hyundai Sonata

3 Answers

1999-2003 Ford Windstar radio removal procedure


remove the trim around the radio face be careful not to break it, it should snap off its a delicate proceedure take radio face plate off ( if equipped) radio should come out

Nov 09, 2008 | 2003 Ford Windstar

2 Answers

Remove factory radio


This is one that you can stare at all day. the trim pieces that include the air vents (usually woodgrain) will come off and expose the screws that hold the radio in. They are held in by spring clips, a gentle pry will get you started. Here is a website that shows how to remove one for a cell phone mount: http://www.bracketron.com/main/xmain_landing_page.php You may have to take the climate controll screws out to get the radio out far enough to reach the plugs on the back. You should be able to figure out the rest. good luck, and be gentle.. the trim is getting cheaper and cheaper, and is really easy to break.

May 15, 2008 | 2007 Kia Sorento LX 4x4

Not finding what you are looking for?
2006 Kia Sedona Logo

Related Topics:

321 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

yadayada
yadayada

Level 3 Expert

76846 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6910 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...