Question about Ford Explorer

1 Answer

Instaled rebuilt transmistion how do i ajust linkagage

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Adjustment transmission linkage went fine. but parts store were transmission was purchased gave me the wrong transmission fluid (merkon3) transmission calls for merkon V . Parts store is ordering new transmission. I still have to r&r.

Posted on Apr 16, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmistion over heats when towing


You should install a transmission oil cooler that is good for 20,000 psi it will help with the loud of the trailor and the size of the tires.

Jan 26, 2014 | 1997 Ford F250 SuperCab

1 Answer

Transmistion slams into gear


Souds like low fluid. Check and fill to level.

Mai Lor

Feb 25, 2013 | 1998 Ford Taurus

1 Answer

Have a knock in my 2000 2.5 jeep cherokee just had the head rebuilt new lifters and pushrods can't ajust rockerarm it's torque to the right setting


I'm not sure where your knock is coming from, but If you rev your engine up and the knock becomes faster and louder you may have a bad rod bearing. If this is the case and you haven't ran your engine too much it is possible to put a new set of bearings in it and you'll be ready to go. But it is possible that you have spun a bearing and the crank would be ruined. Hope that's not where your knock is. Hope this helps, Jeff Horton

Jan 28, 2013 | 2000 Jeep Cherokee

2 Answers

How do i check and add fluid to my 2006 vw jetta


It will most likely be on backside of engine, drivers side is a good bet but could be passengerside also. Add fluid through the same spot you check it.

Oct 26, 2012 | 2006 Volkswagen Jetta

1 Answer

Excessive noise from camshaft after head reconditioning and correct adjustment both standard setting and allowing for head being shaved - to no effect on a daihatsu charade 1991 G100


if its upper noise eg folowers and lifters if they are hydrolic lifters where these replaced are the cams ok if they are manually ajustable tappets these can be ajusted unless the following are goosed again the cams are pitted or mishapen will need new cam shaft the lifter rods are worn or week valve springs
but if they are hydrolic will have to be replaced inc cam shaft hope this makes sence ivan

Oct 01, 2012 | 1990 Daihatsu Charade

1 Answer

My windshield wipers stopped working they stopped in the middle of my windshield 2005 kia sorento


does the wiper arms move free if so the linkage assembly has come apart you have to take the plastic part under the windshield off along with the wipers arms to have access to the linkagage ,if the arms ar hard to move possible motor damaged or fuse burnt do basic first check fuses then do the process of elimination ,motor ,linkage good luck

Oct 10, 2011 | 2007 Kia Sorento LX 4x4

1 Answer

MY 2002 MAZDA TRUBITE 3 LITRE AUTO TRANNY HAS A PROBLEM,I HAVE TO EXCEL. BEFORE CAR MOVES,IS THERE ANY AJUSTMENT.


No --- It is slipping

Have a trans shop check it out

May have to be rebuilt

Don't change your trans & power steering fluid
every 30,000 miles,that happens

Jun 14, 2011 | 2002 Mazda Tribute

1 Answer

When i get up to 30 mph it wont shift and it sounds like i am in nutural and then it goes back down to 25 and shifts good till it gets back up to 30


ur trans is old with probly many miles-hav the car scanned-inspec the fluid-ajust bands and tv cable before u get it rebuilt

Jan 20, 2010 | 1997 Dodge Stratus

1 Answer

Automatic transmission keeps losing fluid newly installed


Sounds like it might be leaking through the Torque Converter seal. Easy fix...just sucks having to take the tranny out again.

Apr 27, 2009 | 1995 Honda Accord

2 Answers

Transmistion fluild hose to radiator


the bottom one should just pop off i had to replace my radiator like two months ago and my girlfriends uncle works at a dodge dealership and i had him do it but i was standing there watching him and it looked like he had no problem at all with it

Jun 17, 2008 | 1998 Dodge Ram 1500 4WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...