Question about 1999 Daewoo Nubira

1 Answer

Daewoo Nubira Starter Motor Refit.

Can the Starter Motor on a Daewoo Nubira 5/99 be refitted from above?

Do any other parts first need to be removed to refit or remove the starter motor? Regards Dennis.

Posted by on

  • Anonymous Mar 14, 2014

    digrama de tiempo de motor 2.0 daewoo nubira


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Daewoo Master
  • 22,156 Answers

Changed a clutch on one of these a few weeks ago and cant remember what i done ,old timers i think ?? not sure but its from below with a rear support bracket ,and a inlet manifold stay bar ,,,3/8 drive socket set with a knuckle and 3 long extension bars to get to top inside bolt as well i think ?? honestly cant remember ,i work on all makes and cant remember every one

Posted on Apr 14, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Daewoo car wont start, starter replaced, battery checked good, getting clicking noise

bad earth connection, take the earth cable off the battery and where it connects to the chassis, clean the connections and refit

Nov 26, 2013 | Cars & Trucks

1 Answer

What engine oil for daewoo nubira 2000 1.6

Use in temperatures above -6 degrees

Peak Performance 5W-30 Conventional Motor Oil 5+ Jug
Lucas 5W-30 Motor Oil 5+ Jug
Motorcraft Synthetic Blend Motor Oil 5W-30

Hope helps.

Jan 12, 2011 | 2000 Daewoo Lanos

1 Answer

Loud click from starter, starter wont turn.

Copper heavy duty contacts either side of starter motor armature within the motor body have worn to nothing and so no contact. No contact means no electricity to the starter motor coils means no turn over. You can buy a kit to replace the copper contacts for less than $10. It will take about 45 minutes to remove, clean, strip, replace and refit the starter motor.

Aug 30, 2010 | 1994 Toyota Camry

1 Answer

Do i need to replace the head bolts on a daewoo matiz after a head gasket refit?

Not really if the bolts are ok and the thread is fine and not damaged.

Apr 29, 2010 | 2002 Daewoo Nubira

1 Answer

Timing marks for a daewoo nubira cdx

on bottom pulley there is a mark on the outer edge. line this up with the peg in the lower plastic cover.
on both top cam gear pulleys, there are punch indentations on them. get a straight edge like a mettle rule. place it through the bolts central and line the two cam pulleys to the outer making sure the rule is in line with the indents and the bolt centers. fit belt then recheck. DO NOT START ENGINE YET.remove all spark plugs. turn engine over by hand with a bar and socket to bottom pulley. DO NOT BE TEMPTED TO TURN OVER BY STARTER MOTOR. as this will bend most of your valves. if the engine turns over one complete revolution. then refit all the spark plugs and start engine.

Jun 05, 2009 | 2000 Daewoo Nubira

2 Answers

Change alternator on daewoo nubira

first you need to remove the belt . there are only several bolts to remove the alternator . there should be a diagram on the panel by the hood prop rod to show the belt route

Feb 18, 2009 | 2000 Daewoo Nubira

1 Answer

Starting slow

sounds like starter motor needs cleaning.Remove and give a good spray with wd 40 along the shaft clean any burnt on grease etc. regrease and refit if problem has not disappeared right away replace starter motor as windings are failing

Nov 04, 2008 | 1984 Chevrolet Chevy

1 Answer

Daewoo nubira transmission control module

Hi, the TCM is located at the passenger side kick panel (LHD), when you remove the kick panel you will see the ECU (engine control module) directly above it is the TCM. I hope this can help.


Oct 07, 2008 | 1999 Daewoo Nubira

1 Answer

Brake pad change for 99 daewoo nubira cdx

I also have a 99 nubira, you should be able to do it with out a book...............they have disc all round and the general set up is the same front and back, If i remember rightly, wheel off, unbolt caliper from mount ( 2 bolts on back face ) pads simply pull off from bottom of mount, refit new pads ensuring same shape on as one that came off. open bonnet and take off cap to brake fluid, using suitable tool ( i used a large screw driver ) push both pistons back into rubber gaitor ( keeping a eye on level in brake fluid, as it will possibly overflow ). You should then be able to refit caliper back to mount. refit bolts, mop up any overflow and replace cap.........JOB DONE :) ........................remember, before you go out onto the road start the car and pump the foot brake a few times until the pedal goes firm again.

Hope this helps you. steve

Jun 19, 2008 | 1999 Daewoo Nubira

Not finding what you are looking for?
1999 Daewoo Nubira Logo

Related Topics:

419 people viewed this question

Ask a Question

Usually answered in minutes!

Top Daewoo Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

75822 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Are you a Daewoo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides