Question about 1988 Ford F 150

1 Answer

No fuel presure... theres no power progres in the fuel pumps..

Wont iginte motor...

Posted by on

  • carhob May 11, 2010

    could u add more details?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Ignition module on distrubitor is bad

Posted on Apr 18, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 chevy truck wont rev past 3500 rpms


does your motor have a govner on it also sounds like bad plugs or coil packs

May 15, 2012 | Cars & Trucks

1 Answer

Turned car off now turns over but wont start


spray some starter fluid in the intake and then see if it will start and die.
this will tell you if its igintion or fuel problem.

i bet the fuel pump went out.

Apr 26, 2010 | 1991 Nissan 300ZX

1 Answer

2000 jeep wrangler just shut off changed fuel pump


check foe fuel pump presure at fuel rail,,,if u have fuel pump presure check all fuses with a test light not buy sight,,could be deceviving ,look at and check to see if fuel pump relay is working if no fuel presure i,if u have presure in fuel rail ,replace the cranck shaft sensor

Jul 03, 2009 | 2000 Jeep Wrangler

2 Answers

2001 Will crank but wont start


Hi , these trucks are notorious for fuel pump issuse. (I have 2 in the shop now).First check for spark if spark is present then we need to check for fuel.if a presure gauge is avail,install the gauge and crank the engine.if presure increases to 50-60 psi fuek is probably not the issue. now if a gauge is not avail you can remove the air cleaner/snorkle assy.spray some carb cleaner in the throttle body,then try to start if (if it starts for a second the problem if fuel.now if it starts go under by the fuel tank,reach up (from the drivers side and unplug the fuel pump plug (4 wire) have some one crank the engine ande check for battery power on gray wire durring cranking,if battery power is present check black wire for good ground.if both power and grounds are present pump is no good.if now power then swap the fuel pump relay w/ same design relay (in the underhood relay center) relays are also a known issue w. the s and t trucks,good luck Thanks

Jun 18, 2009 | 2001 Chevrolet S-10

1 Answer

FUEL ISSUE WONT RUN RIGHT


CHECK THE FUEL PUMP PRESURE
ON THE FUEL RAIL AT THE INTAKE THERE SHOULD BE A PRESURE CHECK VALVE

May 26, 2009 | 2004 Dodge Ram 2500

1 Answer

Geo Metro 1994, diagnose no fuel presure problem.


Quite a few things can cause a car to die after idling for awhile, but if you have verified that the fuel pressure is actually dropping when the motor dies, the likely culprits are:
1) Electric fuel pump in the gas tank is bad
2) The fuel pressure regulator (on the throttle body) is bad
3) An electrical problem in the power to the fuel pump (like a bad fuel pump relay or lose ground wire to the relay's circuit)

Apr 04, 2009 | 2006 Geo Metro

1 Answer

96 intrapid 3.5


hi how are you?just because you hear the fuel pump running does not mean that it is pumping enough preasuer to the motor to open the injectors. you need 48 lbs with key on engine off and with the vacume line off the presure regulator.if you have enough presure then you will have to check for a good blue spark.the fuel presure test port is located just under the thermostat housing on the steel fuel rail.

Feb 02, 2009 | Dodge Intrepid Cars & Trucks

1 Answer

My honda maccord wont statr without having to pump gas pedel


if you have a 95 accord you dont need tp pump the throttle it is a fuel injected car the problem does lie in the fuel system the filter is a good place to start but i woud check the fuek injectors and the fuel presure regulater. and to let presure out you got to loosen the bolt on the fuel filter witch is located on the fierwall. if you have any other honda questions please let me know

Brad Ross

Nov 15, 2008 | 1995 Honda Accord

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...