Question about 1990 Isuzu Pickup

1 Answer

The fuel pump is direct wired to the fuse box and stays on after truck is running

The fuel pump stays on in my 1990 Isuzu pickup. The guy I bought it from wired it to the fuse box. How can I get this working properly?

Posted by on

  • iceref01 Apr 14, 2009

    How would I install a toggle switch inline?



1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

It needs to be wired to the keyswitch.
You can also put a toggle switch inline, and turn it on and off manually.

Posted on Apr 14, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Fuel pump problem?

Caution *** For your safety, Installation of this electric fuel pump requires that it be wired through the oil pressure switch

Jul 27, 2013 | 1991 Isuzu Pickup

1 Answer

Petrol gage not working properly

Given the vehicle age, you will most
likely have to drop fuel tank & replace
sending unit for gauge

Sort of old for that ,unless your changing
the fuel pump at same time

Oct 03, 2012 | 1990 Isuzu Pickup

1 Answer

1990 Isuzu Truck 2.6 5-Speed , Cranks but no fire to the plugs, new cap. rotor Turn key to ignition on and no check engine light, no heat/ac , no flashers. HELP!

OK several things to check, is there power to the fuel pump, check as close to pump as you can? and did you check the ignition coil?

Jun 09, 2012 | 1990 Isuzu Spacecab

1 Answer

Fuel pump not working on starting my picup


May 02, 2012 | Cars & Trucks

1 Answer

Where is the fuel pump relay on a 1990 Dodge

It is a black box on the driver side mounted to the fender.. Black box.. what is your pickup doing? I would pull teh computer an take it in to a Dodge Dealer ship to have them Test it! and check at your local junk yard for the computer. good luck hope you figure it out!

May 10, 2010 | 1990 Dodge Dakota

2 Answers

Need to replace 1990 isuzu pickup fuel pump 2.6 what is the way to do this? How long should it take?

electric fuel pump is in that gas tank. you can do this 2 ways. one is take the bed off. un hook all your wires and remove the bolts out of the bed then get 3 buddies and remove the bed. so you can get to the top of the tank to get the fuel pump. or you can get a floor jack and support the tank and remove the tank straps and slowly ease the tank down so you can unhook the wires and hoses. then remove the tank all the way and work on removing the pump.

Apr 07, 2010 | 1990 Isuzu Pickup

1 Answer

How do i insert a fuel pump on a 1990 isuzu pickup

If it is on the engine you will need to remove the right front wheel then you can get to it.

Feb 28, 2010 | 1990 Isuzu Pickup

1 Answer

Where/ how do i locate the power wire for the fuel pump on my 1996 holden rodeo? i've been told there will be some wires for the guage and some for the pump which lead into tank. Is there a way of...

if my memory is right there is a connector near chassis rail that comes from on top of fuel tank, 2 wire connector this is for pump you can check for power on wires from turning ignition to on position it should power up fuel pump for approx. 5 seconds then stop. will have continuous power while cranking (black with blue trace) other wire is black(earth) this is separate from tank sender unit. are you getting power at fuse check with test light if no power relay is not working.

Jun 24, 2009 | 1990 Isuzu Pickup

1 Answer

Won't start

you may need to check to see if your fuel pump is connected properly,or if it works.turn the key just befor starting you should hear a slight hum if you don't that may be it

Jun 15, 2009 | 1990 Isuzu Pickup

1 Answer

Fuel pump wont run and keep blowing a fuse in the front fuse box

The power wire to your fuel pump must be shorting out somewhere. Disconnect it and see if your fuse still blows. If not, then follow the wire all the way back to the fuel pump, and look for a bare spot. Good luck!

May 03, 2009 | 1994 Toyota Pickup

Not finding what you are looking for?
1990 Isuzu Pickup Logo

Related Topics:

282 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14411 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides