Question about Cadillac Seville

1 Answer

1995 cadilliac sls-i dont know if its a motor mount or a calibor problem...when i hit my breaks my motor and car is shaken-like its having a siezure...what do i look for

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 226 Answers

I would first check the brake rotors. While you are at it, see if your lug nuts are tight on the wheels, and there is no run out. If brake system and wheels are good, you might have a front suspension problem. Normally it is not a broken motor mount. Rick

Posted on Apr 14, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

We have a 2002 Cadillac Seville SLS our son ran off the road and hit a ditch now our car has an oil leak at the bottom of the engine by the lower motor mount what could it be?? PLEASE HELP


sounds likely that the sump has been punctured or a seal to the drive shafts or crank pulley damaged , only way to tell for sure is to get on a vehicle lift so can see under neath , will need to go to a mechanic shop for this

Oct 07, 2015 | Cadillac Cars & Trucks

1 Answer

I have a 2002 Cadillac Deville recently I had valve cover gaskets done. Since then every time I drive my car I can feel a vibration threw the gas pedal as if the motor mounts are broken. When I drove the...


yes. in order to change the rear valve cover gasket the easiest way to get it out is to drop the subframe which supports the motor from under the vehicle

Aug 04, 2012 | Cars & Trucks

1 Answer

Shaking in reverse


I read you other post. A motor or transmission mount may cause vibration throughthe whole car. However, it will not cause the delay you described in going into reverse. If you want to know if you have a bad motor mount all you have to do is get someone to help you and watch the motor mounts when you put the thing in gear (both forward and reverse) and brake-torque the engine a little. If the mount is broken, you will see the break when it comes up under load.

Otherwise, it sounds to me that you are describing an internal transmission problem.

Apr 13, 2012 | 1995 Volvo 850

1 Answer

1995 Lincoln Continental, passenger seat won't tilt back forward


YOU HAVE A SWITCH OR A TILT ACTUATOR MOTOR PROBLEM. LINCOLNS HAVE 5 OR 6 ELECTRIC MOTORS MOUNTED ON THE UNDERSIDE OF EACH FRONT SEAT WHICH REQUIRES REMOVING THE SEAT TO INSPECT .THEIR ARE ALSO CABLES ATTATCHED TO THESE MOTORS SO LISTEN WHEN YOU HIT THE TILT SWITCH DO YOU HEAR A MOTOR NOISE? IF YOU DO THEN YOU MAY HAVE A BAD CABLE.

Apr 11, 2012 | 1995 Lincoln Continental

1 Answer

I need visual help on my 1995 chevy c2500. its 8600 pounds gross with 13 inch rear drums, need to know how to get drums off without breaking anything


Hit the drums with a hammer. Serious to god! Hit the sides, hit the face between the studs, soak studs and center ring with wd40. Don't worry about breaking the drum. You have to be a muscle man to do so and as long as you don't hit the studs, you will not break anything either.

Mar 07, 2010 | 1995 Chevrolet C2500

1 Answer

Rotors won't come off


get a really big hammer! and some wd40. Sometimes you just need to pound the **** out of them to get them off. Sometimes they break into bits. Wear safety glasses and gloves I have had bits of rotor fly off and slice me open before. Hit in between studs dont hit studs, dont hit caliper mount on knuckle either. It bends easy! At this point I hope you know if they come off you cant reuse them. They will get deformed and crack even if you cant see it.

Apr 24, 2009 | 2002 Ford Escort

1 Answer

1995 Taurus motor mounts


these are known as cradle bushings. the frame around engine is called the cradle. you can get mounts from ford should just replace these and be fine

Oct 16, 2008 | 1995 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...