Question about Ford Ranger

1 Answer

How long does this job take at a shop

Flat rate to R&R left side radius arm bushing on 89 Ford Ranger 4 wheel drive, 2.9 motor

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

1 hr

Posted on Apr 14, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 Infiniti QX4 is unstable while driving. the car starts waving when I slightly accelerate on highways and if I push further on the pedal things go to normal again until I remove my foot from th


Have the car looked at by a reputable shop it sounds as if control arm bushings may be at fault possibly a tie rod end but theyshould have noticed that at tire shop when you had the work done.so prob going be control arms / radius arm bushings

Jan 22, 2013 | Cars & Trucks

1 Answer

My 2003 f150 pulls to left when i initially apply brakes,then straightens out.I replaced both calipers,rotors and pads.bled air out of lines and problem still exist's.


Check the rubber bushings on the front suspension arms, especially the lower radius leading arms. When you brake the inertia of the car is thrown forward and the lower arms come under enormous strain. If the radius arm to body frame bushing has gone then the leading arm moves rearwards slightly and causes toe out on the front wheel. If one side is weaker than the other then the car steers/pulls in the direction of toe out. If these check out then look at the ball joints on the steering arms and the steering links. Use a pry bar and be quite forceful, its a big truck and there should be no movement.

Sep 16, 2011 | Ford F-150 Cars & Trucks

2 Answers

Steering is loose, lots of play in steering wheel


you need to do what i call a dry check i do before performing an alignment have someone sit in truck and shift steering wheel from side to side lightly while you look at steering components check for loose pitman arm,drag link if used inner tie rods outer tie rods or excessive play in steering box then jack up each front wheel and check upper and lower ball joints

Mar 18, 2010 | 1992 Ford Bronco

1 Answer

I'm looking for a front suspension diagram for a 1997 Ford Ranger 4wd. Can you point me in the right direction?


Suspension The independent front suspension (IFS) system is composed of a two-piece front driving axle, two front coil springs (5310) and two radius arms. The front driving axle consists of two independent axle arms. One end of each axle arm is anchored to the frame (5005). The other end of each axle arm is supported by the front coil springs and radius arm.

Front Suspension
f8852f9.gif

Mar 15, 2010 | 1997 Ford Ranger SuperCab

1 Answer

1995 e150 ford van,, 4.9 6cyl i need to replace the bushings on the radius arms. do i need to remove the springs or do the radius arms , just unbolt (front and the back) and remove? i appreciate your help....


Hi Darrell,
No the springs will remain in place,You will need new bolts and nuts before you start the job,they are 1/2 x one inch.you'll need five of them.unfortunately there are three large rivets you will need to torch off besides the other three bolts and nuts. Remove the radius arm nut and outer bushing before you loosen the arm.
good luck

Dec 29, 2009 | Ford E-150 Cars & Trucks

2 Answers

When i hit the brakes hard and fast the front end makes a clunk noiseon the driver side.


the most probable cause of that clunk is the radius arm bushings need replacing i have done LOTS of those . if you are not a mechanic or have limited skill this repair is fairly difficult..( not being rude just trying to save you a headache ) the radius arm extends rearward from front axle to frame..one on each side . look at the bushings where it goes through the frame bracket there should be a rubber bushing on both sides of that frame bracket and they should be compressed with no gap.. i hope that helps

Dec 10, 2009 | 1992 Ford Explorer

1 Answer

How do I replace left Radius Arm insolator on 1996 F-150 2x4


Pretty easy for the regular backyard mechanic to do. First drive up to a pretty good sized tree so you are almost directly in front of it head on. loosen the nut on the back. Using a come along pul the front left side to pull your radius arm from the hanger. change out the front bushing and loosen the come along slowly so you can line the radius arm back into the hanger....a jack may be needed even though I have never had to use one. once the radius arm is back in place replace the rear bushings and torque to 200 ft lbs. i think its 200 ft lbs but check with a repair manual or ask a mechanic to make sure.

Hope this helps yah cause I have done it this way on alot of vehicles I have owned and it doesnt cost nearly what it does to take it in and have it professionaly done. And it only takes about 45 minutes to do a side. But do both if replacing the bushings on one side, always do the other also.

Jun 09, 2009 | 1994 Ford F150 Styleside Supercab

1 Answer

1999 ford explorer pulls to right when put into 4 wheel drive


they have what are called Radius Arm Bushings.That cause this problem and other vibration problems also. Go to Explorer forum com site for info on how to replace the.

Feb 01, 2009 | 1999 Ford Explorer

1 Answer

Ford escort 14oo, 1997


big problems with bushes on radius arms,take vehicle to garage straight away,do not drive this vehicle you could kill someone

Dec 21, 2008 | 1998 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...