Where the check engine sensor located Toyota paseo 96
SOURCE: 1990 toyota pickup
The knock sensor is located in the center of the engine under the intake.
SOURCE: how do i pull check engine codes for a 92 toyota
look for data link under hood. get a jumper wire.hook it to terminal E1 AND TE1.IF YOU CANT LOCATE IT.GET A HAYNES MANUAL.IT WILL MAKE IT EASY TO LOCATE.
SOURCE: how can i locate and test the starter relay on a
You don't need to.You need to put new contacts in the starter solenoid switch,just take the three 8mm bolts out of the solenoid cover and pull out the plunger and you will see what i'm talking about,the car has no relaly for the starter.
Testimonial: "Hey to wrirguy212 Thanks for your time! I am needing more details. starter/solenoid bench test good. parts store lists a starter relay mounted on fw"
SOURCE: check engine light on 2003 toyota tacoma, O2 sensor?
An O2 sensor code is a tricky one. It could mean SEVERAL different things, and I know how bad it sucks to hear this, but your best bet is to take it in and have a diagnostic ran on it at either a dealer or a good mechanic shop with a computer they can hook up to it. I had an "O2" code come up a while back on another car I used to have, and literally spent weeks and hundreds of dollars trying to fix it, and never did. Finally out of desperation took it in, paid the $90, and they found the problem and fixed it in like 30 minutes. Something I would have never even thought of was causing it (can't remember off the top of my head). After that I stopped wating time and money on check engine lights. One comes on in my car, I take it to have it ran for free at and auto parts store just to make sure it's not a loose gas cap or something, just to get an idea of what I'm looking at, then go and make an appointment to have to hooked up to a diagnostic computer to track down the problem. Good luck, and hope this helps save you some time and money.
SOURCE: disable airbag light on a toyota paseo?
you could remove the instrument cluster from the dash and unplug / remove the light, or go the easy way and use a piece of electrical tape and cover it. as far as disabling it I would think the only way would be to reprogram your ECM
88 views
Usually answered in minutes!
×