Question about 1996 Jeep Cherokee Sport

1 Answer

Header Panal came loose on my 1997 Jeep Cherokee

My header panal on my 1997 Jeep Cherokee SE has come completely off on one side. Do you know if it uses some kind of replacable clip or do I have to replace the entire header. Thank You

Posted by on

  • nyc3065 Apr 23, 2009

    Thanks cartiea2k3, I will try that if all else fails but do you know how the header actually is supposed to attach? Does the header panel have bolts sticking out from it or does it use some kind of clips?




1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 3 Answers

Take the header out and install monkey glue of some thing close to it? Glue headed to the bi- board or particle board? and get a small roller and use small amounts of glue and rollover it. Simple.
When ever you abuse it you can always glue it?

Have a good day. T. Whittaker

Posted on Apr 22, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1992 jeep wrangler yj 4.0L, I6, fuel shut off

I am not sure of your question, there is not enough information. However, I had a problem with a diesel Grand Cherokee that appeared to have a fuel shut off problem, it turned out that the header pump was worn out, and it further turned out that the Cherokee had a history of the header pump wearing out.
The header is the pump that supplies the injector pump with diesel fuel from the tank, and if this pump goes, not enough fuel is supplied to the injector pump causing the engine to cut out, and having to be bled again. As soon as the engine cools down, the pump appears to be working fine again.
Another possibility is that you might have a problem of sorts with your engine. The engine control computer senses the problem and turns the engine to limp mode, which allows the engine to work at a much reduced power output, giving the impression of diminished fuel supply. This allows the driver to get the car to a service agent before further damage is done.
Give us some more info to give you a better answer.

Sep 12, 2013 | 1999 Jeep Grand Cherokee

1 Answer

Every time I push the brake pedal, turn on the lights, heater or rear wipers, or try to use the power windows the engine dies. I do not see a visible short anywhere, what do I do now?

if you car use ECM+EI+CCM+LG, will be a GOOD idea go to repair shop for pass the SCANNER +COMPUTER TEST. You will have effective result.
Now the electronic for the car involve a great knowledge and many tools special for diagnostic and troubleshooting very expensive. Do not waste your time.

God bless you

Jun 27, 2012 | 1989 Jeep Cherokee

1 Answer

How to change a starter in 2002 Jeep Grand Cherokee 4.7 liter

You will need to remove the exhaust header pipe assembly

Jun 17, 2012 | 2002 Jeep Grand Cherokee

1 Answer

Head Light Removal. How do you remove the

All information about Headlamps removal can find in the Service Manual Section ZJ-Secc-8L-Lamps...


Hope help with this (remember rated this). Good luck.

Jul 09, 2010 | 1997 Jeep Grand Cherokee

1 Answer

Where can i find a fuse panal diagram for a 1997 jeep cherokee sport

generally found on the underside of "fusebox" cover. i don't know whether you mean the junction block. (which is located just aft of the battery). or the fuse block which i think is on the edge of the dashboard where the driver's door touches the dash. (if you don't know where to look you'll often times overlook it) hope this helps

Apr 11, 2010 | 1997 Jeep Cherokee

1 Answer

I need to replace my 2003 chevy malibu drivers side mirror. I am pulling of the door panel, having problems removing panel, I am unsure where clips are>

the clips are all around door. about 7 or 8 inches apart. on both sides and bottom. use a flat blade or similar to pop clips loose on panal. when clips are loosened, then roll down window and slide panal upward to remove. good luck!!

Oct 18, 2009 | 2003 Chevrolet Malibu

2 Answers

Where is the cooling fan rlay located on a 2002 jeep grand cherokee 4.0 cyl

Your cooling fan relay is located below the passenger front head light under the hood.

Jun 08, 2009 | 2002 Jeep Grand Cherokee

1 Answer

94 jeep driver door ajar on info panal, it is not the door switch.

It has to either be the switch, a short to ground in one of the wires that goes to the info panel or a bad info panel. I'd say the most likely is the switch, I think they're built into the door latch assembly.

May 01, 2009 | 1994 Jeep Grand Cherokee

1 Answer

Catalyst converter or no catalyst coverter\for 1995 jeep 4.0 str6

No it doesn't hurt anything but the environment and the smog polices feelings. Power improvements from a free flowing pipe. no additional power going bigger except for more noise which might make you think it is faster

Mar 27, 2009 | 1997 Jeep Cherokee Country

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

142 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides