Question about 1999 Dodge Durango
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2004 dodge ram rear end noise
while you had the cover off did you by chance look at the condition of the ring gear and spider gears...if it was run for any length of time low on fluid or with two different sized tires you may need some repairs but first inspect the ring gear and rotate till you can see the 4 little beveled gears inside the differential ....use a screwdriver and check for excess movement...look at the crossshaft and look for wear.....hope this points you in the right direction.
Posted on Sep 20, 2009
SOURCE: 1996 jeep grand cherokee, quadra
Since you aready paid $400, go back to ;the shop and get your $'S worth!! Unless someone can prove that the axle bgs were bad, you shoulld ask why pinion & side gears were not diagonsed!!! (dosen't anyone test drive stuff after they "fix" something anymore??? Dosen't anyone give a damn???
If you can't get anywhere with this, find a junkyard unit and install it yourself. It isn't that hard. Just be sure that new lone has the same mount points and gear ratio matches ratio lof front axle.(count gear teeth if you must)
Posted on Feb 22, 2009
i have been having the same problem i am going to try and replace the sway bar links a few people have said thats what it is and i figure y not the only real way to test them is to take them off and move them around if they move real easy there shot get greasable ones wif you replace them
Posted on May 29, 2009
Not terrible of a job to do. You will have to jack up the rear end and support it on stands and be sure to chock the front wheel so it does not roll forward while jacking it up. Remove the rear wheels and the drum assembly or rotor if disc brakes. Remove the rear differential cover be sure to have a drain pan to catch the fluid that comes out of it. Find the center carrier you will see a pin about 3/4 of inch in diameter going throught the center carrier with a bolt on one end remove the bolt turn chunk until pin comes out. Push the axle in enough to let the c-clip to be removed then pull out the axle. You will then have access to the axle seal and axle bearing. You will probably need a bearing puller with slide hammer to get bearing out. Then put back together.
Posted on Sep 24, 2009
Testimonial: "This is very helpful for someone that knows very little about changing wheel bearings. Thanks a lot."
Tips for a great answer:
Feb 13, 2013 | 1999 Dodge Caravan
Oct 15, 2012 | 1999 Dodge Durango
Nov 14, 2009 | 2000 Dodge Durango
Aug 26, 2009 | 2002 Dodge Durango
Jul 09, 2009 | 1999 Dodge Durango
May 15, 2017 | 1999 Dodge Durango
534 people viewed this question
Usually answered in minutes!