Question about 1993 Jeep Cherokee Country

1 Answer

They signal lights,the wind shield wipers,the a/c and heater , and the amplifier stop working in mw 1993 jeep cherokee

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 242 Answers

Sounds like you blew a fuse. Check under driver's side using a fuse tester or just pull each one out and check if it's blown.

Posted on Apr 17, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wind shield wipers will not work


do you hear a motor noise if yes then flip up the rear cover at end of wiper arm and tighten the nut.it is on a spline .if no noise then tap on wiper motor and if it goes on then replace the motor

Nov 03, 2013 | 1992 Jeep Cherokee Sport

2 Answers

1988 jeep cherokee,6 cylinder my front windsheild wipers dont work.fuse is good.the wiper motor makes a noise when its turned on.is there a relay that could be faulty?wiper switch is the same as the turn...


No relay in the circuit.
There is a delay module but if it fails that usually causes the wipers to stop in the middle of travel or only run on high.
And the switch is working if you hear noise coming from the motor. The wiper switch is not the same switch as the turn signals but it is near that assembly.
I would say if you have power to the wiper motor the motor is probably dead or something happened to the linkage to the arms.

Feb 27, 2013 | 1988 Jeep Cherokee

1 Answer

Cannot get the wind shield wiper motor back in the wind shield wiper stops in the middle of the wind shield


this is normally caused by a bad wiper motor or binding of the wiper gears and linkage arms.
check to see if the linkage arms are tight and not loose. also try and lube up the pivot points.
another thing to check is to make sure you have 12 volts to the heater.

c...

Jan 02, 2011 | 2000 Ford Windstar

1 Answer

1988 jeep cherokee wiring problems


Your 'mechanic' may have blown a fuse during the installation. To check them, you really should buy a cheap digital multimeter; they are easy to use and can be had for < $20 US. Sometimes the fuses don't 'blow' bad enough to see that the fuse element is broken but a meter will tell you if they conduct or not. 

Sep 08, 2008 | 1993 Jeep Cherokee Country

Not finding what you are looking for?
1993 Jeep Cherokee Country Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...