Question about 1999 Mercedes-Benz CLK

Open Question

2004 Mercedes CLK320 Headlight

My headlight is out and I am hoping I don't have to take the entire assembly out to change the bulb. Anyone steer me a clear path?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 91 Answers

SOURCE: headlight high beam not working

check relay

Posted on May 12, 2009

txkjun
  • 409 Answers

SOURCE: E300D Headlight Lens installation

First you have to remove the turn signal lamp. There is a plastic release tang that you push one way and pull the turn signal out. Next you have to remove the filler panel below the headlight assy to gain access to the bottom bolt. 2 screws hold the filler in place. There is also a black plastic filler panel that is pinned to the headlight assy remove it. There are 3 or 4  bolts that hold the headlamp assy in place 2 on top 1 on bottom actually it might be 2 on the bottom. (old age memory loss LOL) remove the bolts and remove the headlamp assy. The lens is held in by plastic clips just pry up gently on the locking clips and remove the lens. I hope this helps. It fairly easy and you should be able to DIY. Good luck and thanks for using FixYa!!

Posted on Dec 28, 2008

  • 14 Answers

SOURCE: headlight adjustment

under the hood, near the rear of the headlamp assemblies, there are adjustment screws with phillips head screwdriver slots. They may be hard to see with the radiator support above the headlamps, but they will be the only phillips adjustment screw heads on the whole headlamp assembly. They will be facing directly vertical facing up

Posted on Apr 13, 2009

lastech
  • 408 Answers

SOURCE: w124 Headlight

hello,good day, (four screw for headlight),remove your signal light for 2 screw,other 2 are in front side (visible)remove wiring and vacuum for adjustment range,ty

Posted on May 17, 2009

alicantecoli
  • 22156 Answers

SOURCE: where is the headlight relay located on a mercedes

box under the bonnet right hand side??? or was that the bmw?? my old timers is catching up with me sorry about this ,i will remember soon or was it behind the glovebox ??

Posted on Sep 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mercedes CLK320 headlight broken.


The socket or the wiring. Without the bulb in put a meter on the socket to make sure you are getting juice to it. if you are there then you may have just had bad luck with a bulb. If there is no power at the socket then you need to disconnect it and check the bare wires for power. No power there then you have to trace back to the fuse panel..

Nov 12, 2012 | 1999 Mercedes-Benz CLK

1 Answer

I've replaced the bulb, the passenger side headlight is still out. My feeling is the problem is electrical but I'm not sure.


Im assuming that you have check the fuses for the headlights and they are good.If your headlight is HID(Hight Intenstiy Discharge Xenon bulb) The headlight assembly will have a balast that might be defective.Deferentiating the Halogen from HID.Halogen will have a yellowish color when you turn on the headlights whereas the HID will have a whitesh to bluesh in color.If your clk320 does have a halogen then its highly probable you have an electrical problem but if its HID then you might want to replace the balast.

Nov 09, 2012 | 1999 Mercedes-Benz CLK

1 Answer

How do i get to the headlight bulb to replace it?


On this unit, you actually have to buy the entire assembly, and they assembly for this uncludes the entire vehicle.  So if your headlight bulb is out, you have to replace the entire automobile.  Sorry I cannot give you better news.

 

So I was able to find the assembly here:

http://cgi.ebay.com/Chevrolet-Trailblazer-4dr-4WD-LTZ-REDUCED-4X4-AWD-LEATHER-SUNROOF-HEATED-SEATS-BOSE-6-CD-/320648576540?pt=US_Cars_Trucks&hash=item4aa824fe1c

for about $5000.

 

Bet again, I'd like to stress that the headlight assembly inlcudes the car attached to it.

 

Thanks.

Jan 29, 2011 | 2004 Chevrolet TrailBlazer

2 Answers

Trying to change headlight bulb


Hello,

The 2004 grand prix pontiac houses 2 headlight bulbs per headlight assembly. The low beam headlight are located at the fender of the car and the high beam on the grill side of the assembly.

To replace the headlight bulb of Your pontiac grand prix, 2004 model. It is qiute technical and moderately easy to fix. There is no solution that cannot be done the DIY way, as long as You get the proper guide and You are technically able to do such works.
  1. Park the Grand Prix on a flat surface, apply the parking brake and ensure both the engine and headlight switches are off.
  2. Open the hood and approach the headlight assembly with the faulty headlight bulb.
  3. Locate the headlight assembly retaining clip. It's behind the headlight assembly on top on the fender side. Lift the clip upward halfway to release the headlight assembly.
  4. Pull the assembly out being careful not to scratch the paint on the fender or the lens of the assembly.
  5. Reach behind the assembly and disconnect the wire connection and plug from the headlight bulb socket.
  6. Turn the socket of the bulb counterclockwise 1/4-turn to remove the composite bulb from the assembly. Discard the bulb.
  7. Install the replacement bulb into the assembly (handling the plastic socket part only oil in skin will damage the glass bulb of halogen bulbs because of the intense heat they burn at), but ensure the tabs of the socket end of the bulb are aligned with the notches in the assembly before turning it clockwise and locking the bulb into place.
  8. Plug the wire connection back into the socket of the bulb before replacing the assembly back into place and pushing down on the retaining clip. Test the headlight bulb for operation before closing the hood.
Hope this was helpful. Thank You for using FixYa!!!

Jan 15, 2011 | 2004 Pontiac Grand Prix

3 Answers

How do i change the headlight bulb in a 2004 durango?


I know you posted awhile ago, but I hope maybe this could still help you. If you have a 2004 Durango it it second generation and I wouldn't recommend removing the entire assembly. Turn your wheel one way and then inside the wheel well is a plastic door you slide up and then out and you can reach right into the back of the headlight assembly. Turn the wheel and go to the other side. It's a pain, but it's a lot easier.

Dec 09, 2009 | 2004 Dodge Durango

1 Answer

Replacing the low beam headlight on a 2004 gmc envoy


Just above the headlight assembly are two angled tabs, pull these straight up (they may need some effort). These will release the assembly, carefully pull the entire assembly forward. Access to the headlight bulb is behind the two rubber caps, the upper cap is for the low beam. Remove this cap, twist the headlight bulb socket CCW and remove. Disconnect bulb from harness by prying up gently on locking tab on socket, and pull bulb out. Being careful not to touch the new bulb glass surface with your finger, plug it into the socket and install it back into the headlight assembly turning it CW. Reinstall rubber cap, seat headlight assembly on frame, lining up the bottom and top pegs. Once the assembly is fully seated, push the two angled tabs down, locking the assembly in place.

Oct 15, 2009 | 2004 GMC Envoy

2 Answers

How do I replace headlamp bulb?


Some imports require the entire light assembly to be removed in order to replace headlamps. Look to see if there are angled rods on the back side of the light assembly. If so, see if the can be pulled straight up towards the hood of the car. When they are released the headlight will be able to come forward. Good luck. Hope this helps.

Apr 25, 2009 | Hyundai Motor 2004 Accent

1 Answer

How to relace headlight bulb for 99 model clk320


There is a cover on the back of the assembly to access the bulbs. The assembly does not need to come off.

Mar 31, 2009 | 1999 Mercedes-Benz CLK

2 Answers

Headlight repair on 2003 Mercedes Benz E320


how do you change left low beam bulb on 2003 mercedes e320

Mar 15, 2009 | 2003 Mercedes-Benz E-Class

Not finding what you are looking for?
1999 Mercedes-Benz CLK Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...