Question about 2001 Chrysler Voyager

1 Answer

2002 chry. Voyger has front end knocking noise when going over bumps.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Expert
  • 50 Answers

Get someone to help you with this: Reach behind the front wheel just rearward of the strut and you'll find a vertical rod that bolts to the strut just below the spring perch and the other end goes to the sway bar. Hold it and get someone to rock the van as hard as they can. There's and astronomically good chance you'll feel a popping in this rod. If you do, you need to replace it. It's called a sway bar link. You'll need 2 of them and the sway bar bushings as well. Spray the nuts on the links down real good with wd40. Hold the back side with a pair of channel locks to keep the ball joints in them from turning. I take the top nuts off first, then the sway bar bushings so I can move that thing around to gain access to the bottom nuts. Then put them back in reverse order. Remember this, if you do it, no matter what anyone tells you, DO NOT lubricate the sway bar bushings. After the first rain, they'll start squeaking and they'll NEVER stop. They are supposed to go on dry.

Posted on Apr 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Knocking Noise from Front End Toyota Corolla 2004


Ensure the wheel nuts and Axle nuts are properly torqued to the specification. Lift up the front wheels, place supports under the car and do the following:
- Sit if front of right wheel, slightly move it right and left and feel any abnormal noise if coming out of it. If click-click or Tuck-Tuck sound is observed it could be due to the excessive play in the tie rod end, rack end, ball joint wheel bearing or U joint. Next hold the Tire with your one hand at the top and with other hand at the bottom. Shake the Tire inside out and feel any noise or play. If play is observed, it could be the worn out ball joint or the wheel bearing. Now hit the Tire at the top with rubber hammer and observe any rattling noise coming from near the center of the wheel. If you could listen to the extra noise it could be due to the dried up caliper pins. Grease the pins with graphite grease. If all is found fine, similarly check the left wheel and repair as necessary.

Sep 15, 2013 | Toyota Corolla Cars & Trucks

1 Answer

Chevy cobalt noise knocking in front end when you turn the steering wheel from left to right. Also knocking noise over bumps.


Hello and welcome. this noise is normally caused by a noisey steering I-shaft. there is a steering shaft that goes in between the steering column and the steering gear. this shaft has a slip joint that becomes noisey. all you need to do is lube the i-shaft with some special lube and you will be good to go

Sep 30, 2010 | 2006 Chevrolet Cobalt

2 Answers

Front driver side suspension knock over bumps


See if you can bounce car and replicate the noise. If you can, you should be able to find it, and put your hand on it. Stabilizer bushing are a place to look, both at the lower a arm and on the frame. If you narrow it down to the strut, it will need to be replaced. The front trans mount also goes bad, try putting it in drive with your foot on the brake and give it some gas and see if the engine moves an excessive amount.

Nov 23, 2009 | 1992 Buick Regal

1 Answer

Knock front end


CV axle time.

Jun 09, 2009 | 1997 Ford Escort

1 Answer

Knocking noise in front end


IT COULD EITHER BE THE ANTI ROLL BAR BUSHES OR ANTI ROLL BAR LINKS AS THESE ARE DIFFICULT TO DETECT WHEN VEHICLE IS JACKED UP

Mar 13, 2009 | 1991 Mitsubishi 3000GT

2 Answers

2002 325i Knocking noise front suspension


This noise is likely caused by swaybar end-link joints. Newer cars use solid rods with ball and socket joints, to connect the ends of the swaybar to the frame. These ball and socket joints at the end of these rods, create an amazingly noticeable and annoying noise in the car when you go over the slightest bump. There is no way to test these things unless you disconnect one end and check to see how tight the ball is in the socket just by wigging the with your hands. If they move around at all without pressure, they are no good. Go to ebay and search "bmw endlinks " for a picture.


Mar 12, 2009 | 2001 BMW 325

Not finding what you are looking for?
2001 Chrysler Voyager Logo

569 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...