Question about 1995 Jeep Wrangler

1 Answer

Jeep will crank but not turn over without gas and rough idleing

My 98 jeep wrangler 4x4 will not turn over unless I give it gas. It cranks just fine. Also, once I have it running it is idleing rough in neutral and reverse. Im not sure what to do. I just had the transmition rebuilt and a new engine put in. i have heard that it could be the AIC, the fuel pump, or the coil. i dont know what to look at first.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 52 Answers

Have your injectors, injector pump, fuel pump and filter checked. if you have a new motor, definitely check the fuel filter. Also, you could have a relay or sensor, have a tech put a diagnostic machine on it to check your electrical system.

Posted on Apr 13, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

A rough running Jeep wrangler


cranks ok> / not stated, and is 100% #1 key fact.
ill guess (daft) it cranks OK.
so check fluid levels(oil tops list )
then fuses.we test them.
then scan it.
all modern cars same. deal.

if it dont crank, "my starter is silent or just clicks)
then that be a horse of a different color.
dead battery ? charge system failure,
starter bad?
PRNDL (p/n switches bad )try cranking in neutral yet
my wrangler is 6 speed stick with a clutch switch
that too, is different.
even green battery lugs,.got those?

will not crank
or cranks perfect but will not start
which is it??????????????????????????/

Jan 14, 2016 | 2003 Jeep Wrangler

1 Answer

My 95 Wrangler wont start when the engine is cold. it will crank but not start unless you give it gas. It starts fine when its hot (90 degrees) outside or i've already started and drove it that day, but in...


i was told that if the jeep all of a sudden didnt start on its own without giving it gas, then next time you start it hold the pedal all the way to the floor and it resets something in the computer and sets you back to normal.

Sep 04, 2010 | 1995 Jeep Wrangler

1 Answer

93 wrangler 2.5 will crank but won't start. I pour gas down the #1 cylinder and put the plug back in and it will crank for about 8 seconds then sputter to life and idle and run fine. Shut it off and try to...


Yes...check the pump, filter and output. Also check the ballast resistor for the pump. Stop pouring fuel into the cylinder...instead, use carb cleaner and spray into throttle body (excess fuel in one cyl will contaminate your engine oil). If it runs normally after you get it started likely the pump is good (unless you have problems at high rpm's under power) Regulator is likely good as well...default is to more fuel not less.

Oct 07, 2009 | 1994 Jeep Wrangler

1 Answer

Crank, no start 98 wrangler 2.5l


crank sensor likely-may be distributor sensor but my 98 sport was crank sensor situated in bell housing timed by flywheel

Sep 15, 2009 | 1997 Jeep Wrangler

1 Answer

92 cherokee laredo 4x4 started squealing relized it was harmonic balencer replaced that plus belt now it has trouble starting if I hold peddle to floor it will start and run rough for about 1 minute then...


may not have any thing to do with what u replaced ,,,unless the harmonic balance has relutor on back side ,and wassnt lined up with crank shaft sensor/and it would have damaged harmonic reluctor and sensor

Jul 05, 2009 | 1992 Jeep Cherokee Sport

2 Answers

'03 Jeep Liberty starts weakly and needs gas pedal to idle


Turning over is what the starter does to the engine ...you can turn an engine over with no spark plugs in it...but you can't start it. Turning over is cranking .....the starter turns (cranks) the engine over (comes from when you had to put a crank in the front of the engine and crank it.)
Does it crank normally but has trouble starting???????

Jun 27, 2009 | 2003 Jeep Liberty

1 Answer

2.5l 4cyl engine


check to see if you have any codes come auto zone can do this for free if you do not have a reader..sound like a tps (throttle position sensor)

Sep 25, 2008 | 1997 Jeep Wrangler

2 Answers

Idles rough with engine


1. idles didn’t adjust right.
2. check the timing
3. check your fire order
4. check your distributor cap. Maybe it is leaking

Jul 06, 2008 | 1999 Jeep Cherokee

1 Answer

Cranks but won't start


Try holding your gas pedal all the way down while starting.

Jun 15, 2008 | 2001 Jeep Wrangler

Not finding what you are looking for?
1995 Jeep Wrangler Logo

267 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...