Question about Nissan Pickup

1 Answer

1995 Nissan XE Pickup Transmission Problems-PLEASE HELP

My 1995 Nissan xe pickup (4 cyl-5 speed,200k)has had a metal-to-metal sound from the trans for a couple months with the clutch in or out,less in 4th gear. Yesterday, it started to grind for a second as it went into 4th gear then 4th went out completely (4th is like neutral), then a bug single puff of smoke (with a poofing sound) came up through the shifter boot. I made it home but the clutch felt funny. At first (until yesterdy) I just thought the release bearing was going out but now I think it may be worse.Any ideas what may have happened? Please help, I need my truck to get to work. Thank you very much. Lee

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Your luck as with mine is not good. thought I had a bad bearing, after droping the tranny and seperating the housing, I have a broken counter shaft. after looking for another with no luck, the tranny shop informed me that was common for these transmissions. parts are expensive, to rebuild would cost aprox.$800.00 or more. the main cause is the front bearing is supported in alum. causing shaft to move which first takes out the bearing, then the strain snaps the shaft. taking out all gears except 4th and only moves while in 4 wheel drive.

Posted on Nov 23, 2009

  • Tony Frederick Feb 21, 2011

    I have the exact same problem

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the back up switch located on the transmission on 95 nissan xe-v6 4wd. Pick-up


Amy, Could not find your exact truck or transmission, the links have pictures etc, to show what the sensor looks like and approximate location where sensor will be screwed into transmission.

"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."

nissan xterra frontier reverse light sensor back up lamp switch replacement

2001 nissan frontier reverse light switch Google Search

http://www.autopartswarehouse.com/sku/Nissan/Pickup/Beck_Arnley/Back_Up_Light_Switch/1995/XE/6_Cyl_3-dot-0L/201-1668.html

Jun 09, 2016 | Nissan Cars & Trucks

1 Answer

I need parts for a 2007 Nissian Frontier. What other years are compatiable with a 2007?


Depending on the sub-model, 2005 - 2012 versions *can* fit. Look for yours in the list below:

  • Fit note: Crew Cab Pickup, Extended Cab Pickup
This product fits the following Nissan Frontier submodels
  • 2013-2013: Desert Runner; 6 Cyl 4.0L;
  • 2011-2013: S; 4 Cyl 2.5L;
  • 2011-2013: SL; 6 Cyl 4.0L;
  • 2011-2013: SV; 4 Cyl 2.5L;
  • 2011-2013: SV; 6 Cyl 4.0L;
  • 2009-2013: PRO-4X; 6 Cyl 4.0L;
  • 2011-2012: S; 6 Cyl 4.0L;
  • 2008-2010: SE; 4 Cyl 2.5L;
  • 2005-2010: LE; 6 Cyl 4.0L;
  • 2005-2010: SE; 6 Cyl 4.0L;
  • 2005-2010: XE; 4 Cyl 2.5L;
  • 2005-2008: Nismo Off-Road; 6 Cyl 4.0L;
When calling to inquire or order - tell them the year, make, model (S, SL, SV, LE, SE, XE, etc.) Cab type (crew, extended, etc.) before paying. Have a look at the link below.

2005 2012 Nissan Frontier Tail Light Replacement Driver Side...

May 13, 2014 | 2007 Nissan Frontier SE Crew Cab

2 Answers

My 1995 Nissan pickup xe truck when I put it in drive it will not shift out of first and once I get to the speed of 25 miles a hr. it shifts into neutral until it goes down to appx. 15 mph then it kicks...


V6 or I4 engine? xe = i4?
bad tranny.?
low or too high ATF levels.
clogged bottom filter before pump, (shifts hot?)
RE4 trans is 4speed electronic
RL4 xxx trans is manual only
this side of your tranny has a tag is it RL/RE4 or or 3speed.

3 speed or 4 speed the FSM show four A/T used then .
there are 5 tranny total then ,4 AT (1 m/t)
on car diagnosis varies greatly by type.
fluid checks (if electronic the Tcm blink codes (DTCS)
pressure checks. for weak pump.
that stall rpm tests.
here is one used on your car
http://www.bulkpart.com/Merchant2/graphics/Catalog-pdf/RE4R01A.pdf

Oct 16, 2013 | 1995 Nissan Pickup

1 Answer

How to drain fuel tank on 1995 Nissan pickup


you need to drop and remove tank away from vechicle where you can drain it completely.

Mar 28, 2013 | 1995 Nissan Pickup

1 Answer

How do i replace a thermostat on a 96 nissan xe pickup?


It is located at the enine end of the lower radiator hose inside the metal piece atttached to the engine. the metal piece has 3 bolts to take off that attach it to the engine. I took off the fan and fan shroud for easy access. this is fora 95 xe 4 cylinder.

Dec 11, 2010 | 1996 Nissan Pickup

1 Answer

I have a 2wd 95 Nissan XE 4 cyl pickup and i am having problems starting the truck. when i turn the key it ticks then slowly turns over. sometimes this ticks only happen briefly other times in will take...


You need to pull out the starter and take it to your local auto parts store for testing - I suspect your armature in your starter is worn and causing your issue. This is a replaceable part and, depending on your skill level, you may be able to do it yourself. If your starter is not too expensive it may be feasible to just replace it as your brushes in the starter are probably worn too.

Nov 24, 2010 | 1995 Nissan Pickup

1 Answer

How do you remove the door panel of a 1995 Nissan XE Pickup


Not sure about the 95, but to remove it on my 94 i just pulled on once corner till the fastener poped out, then worked slowly around removing each fastener. Be careful as the the door pannel is quite flimsy but if the 95 is the same as the 94 it should be fairly easy to remove.

May 18, 2009 | 1991 Nissan Sentra 2 Door

1 Answer

MY 1997 NISSAN XE 2.4 LITER, 4 CYLINDER, 5-SPEED STANDARD 2WD TRUCK WILL NOT GO IN REVERSE WITH VEHICLE BEING STILL WITHOUT KNOCKING IT IN GREAR WITH YOUR FIST BUT IT WILL GO IN GEAR IF YOU ARE COASTING...


With the vehicle sitting still, ease the clutch out just a little bit while trying to engage reverse. If it pops in, even with a little grinding, it seems the bearings on the counter shaft may be a little stiff. Have you checked the level of the gear lube in the transmission?

Jul 28, 2008 | 1995 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

907 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75117 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...