Question about 1994 Mercedes-Benz E-Class

1 Answer

1999 Mercedes e-320 water pump

I changed water pump on 1999 Mercedes e320 sedan V-6,
Now the Heater does not get hot , still cold air coming out,
When I touch the top hose from radiator seems to be empty, I have poued 2- anti freeze in the resevoir,
Is there a relive valve for bleeding the air out of the system?
Any suggestions?

Posted by on

  • Mike Butler
    Mike Butler May 11, 2010

    You did have your heater on (not defrost) while running engine and adding coolant right?

  • Mike Butler
    Mike Butler May 11, 2010

    Can you see a cap to remove on your radiator itself?

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Mercedes-Benz Master
  • 3,433 Answers

Good morning;
does this critter have a radiator fill w/cap? I've run accross som large Sotrd trucks that don't.
Well, anyway, it soesn't make sense you would need to fill the radiator via the resenoir. That is only good for short pressure relief and cook down vacuum recovery of coolant. 60/40 is the mix ratio. If it hs a resevoir it should have a radiator cap.The air in system will purge itself as it starts to circulatte cioolant. turn heater off till your system is full, then on when engine reaches operating temp. then if needed top iff coolant. Leave radiator cap off while waiting for coolant to start circulating. When thermostat opens out comes the air. Then put coolant mix in reservoir to fill line. check for leaks and all hose clamps are tight and you should be set, Good luck - Ned

Posted on May 11, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I check the oil on my Mercedes Benz 1999 e 320 6 cyl engine?


Open the bonnet, At the front of the engine slightly to the right of centre there should be a RED looped handle dipstick. Pull that out, it should have a min and max level mark on it.

http://www.benzworld.org/forums/sale-wanted-trade-giveaway/1625861-fs-1999-mercedes-e320-w210-wagon.html

May 17, 2016 | Cars & Trucks

1 Answer

Mercedes Benz E320 heater not blowing hot air


heater control valve is bad and needs to be replaced.

Jan 26, 2014 | Mercedes-Benz E320 Cars & Trucks

2 Answers

1999 chevy silverado heater fan only blows cold air , both coolant lines in are hot


I like that you were knowledgeable to check both coolant lines tells me you are getting hot coolant through the heater core next thing to check will be the blend door on the inside of your vehicle. The blend door is a door that switches from cold air duct to heater duct depending on what you are using at the time. If it is stuck on the cold air duct you will not get any heat sometimes these doors are vacuum actuated and sometimes they are electrically actuated most the time you are able to see the movement of the motor from inside if you don't see any movement but you hear it move chances are it is the door blend I hope this helps.

Jan 10, 2013 | 1999 Chevrolet Silverado 1500

1 Answer

How do i change the air filter in my mercedes e-320 sedan?


Remove the air intake tubes on the left and right sides. Pull up the complete air filter housing off of the rubber mounts. Turn the air filter housing upside down and there will be 4 - T20 torx head screws on each sides. Unscrew these torx screws to gain access to the filter. Install new air filters and put housing back on in reverse order. Please remember to rate this solution. Thanks!

Feb 05, 2011 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

1 Answer

How to replace an engine belt on an 1995


I have two Mercedes - one is 2000 E320 Wagon; other is 1999 E320 Sedan.

I replaced the serpentine belt on my 2000 Wagon today at 92,000 miles. I found that the Motorcraft JK6-947 could be purchased on Ebay for $12.99 plus $6.20 shipping. The old belt was a Goodyear Gatorback 4060940. My 1999 sedan has a Mercedes Benz 011 997 97 92 6K2390 EM7117 Gates belt made in Spain.

Here are the details of replacing the belt.

On the 2000 E320, a 17 mm bolt just under the belt going to the tension pulley will release the belt tension when turned counterclockwise. Removal of the belt was easy after using a 17 mm deep socket wrench similar to a spark plug socket. I made turning the bolt very easy by slipping a 4' pipe over the socket wrench handle. It is advisable to put the new belt LAST on the idler pulley that contacts the belt only on the smooth side.

You do not need todisturb theButton Torx bolt in the center of the tension pully.

The 1999 E320 uses a 15 mm bolt in the CENTER of the tension pulley. Otherwise the installation is the same as the 2000 E320.

Jan 19, 2011 | 1995 Mercedes-Benz E-Class

1 Answer

Drivers side air conditioning is warm, passenger side is cold on my 1999 E320 what do I do?


sounds like itslo on freon or has a temp door actuator stuck prob. just lo on freon

Aug 05, 2009 | 2005 Mercedes-Benz Mercedes Benz E320 Cdi

2 Answers

My Mercedes Benz 1998 E320 AC is cooling on one side only


most likely u have a defective air temp control blend door actruator problem or the blend door is warped and stuck..

Jun 26, 2009 | Mercedes-Benz E320 Cars & Trucks

1 Answer

1999 Mercedes e-320 Heater (blows cold air)


Hi there,
firstly why did you replace the water pump, would i be correct in thinking that it broke, if so, when you took it out was there damage to the impellor, usually there is and these bits of debris have to be retreived. the hot air in your car comes from a heater matrix that is seperate to the main radiator the cause of your problem could be explained by loose debris blocking the heater matrix inlet, also that debris could fall back down and destroy the impellor on the new pump.
If the impellor completely broke up then it will be debris in the system this should be fixed asap to safeguard the new pump.

Apr 13, 2009 | 1999 Mercedes-Benz E-Class

1 Answer

Heater is blowing cold air 1999 dodge stratus


A heater blowing cold air can be a few things. have all of these things check for proper operation to find the source of the problem.
1. Coolant level
2. Thermostat
3. Water Pump
4. Heater control valve
5. Make sure that the heater control doors are closing when you switch from hot to cold.
6.Last but not least if the climatic controls are electric it maybe at fault.
Good Luck

Dec 09, 2008 | 1999 Dodge Stratus

Not finding what you are looking for?
1994 Mercedes-Benz E-Class Logo

263 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76109 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...