Question about 2000 Isuzu Rodeo

1 Answer

Car turns over but will not run.

There was too much oil in the engine.oil was all over the spark plugs.I drained the oil and changed the plugs and wires it still just turns over but will not run.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 295 Answers

I had a simular problem.
I chekced the timing of the engine. The timng belt skipped time. The engine oil pump is not in time with the engine causing the spark plugs to foul out

Posted on Apr 13, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have water in my carborater now its not running well


First drain the fuel tank , fuel lines and drain the oil while its draining , put a fan on the wiring and dry it out. Take the plugs out of the engine and turn the motor over this will force any water that's left in the cylinder out .Water that's got in to anyother parts of the engine will come out with oil Add oil to the engine and turn it over again ,without the plugs in .Let it sit for 5 minutes .then check the oil to see if there's water in it ( If there is it will look like a white milky substance ) if there is u need to drain it and start all over again u will have to keep doin this untill there is no white in the oil . Now once u have done this re-install spark plug,add the gas , then try to re start . If it starts. Leave it to run for a good few mins BUT don't rev it .
After it runs for a few mins turn it off re-drain the oil and change the filter .run again for few mins, turn off check the oil again for. A milky colour if there's none yippy uv done it if it dosent start u need professional help good luck

Jul 07, 2014 | Cars & Trucks

1 Answer

What is causing engine to shake when i put in drive? Has no power when i give it gas


Could be many things. Sounds like its not firing on all cylinders. Open your hood and run the car after dark, look under hood and look for sparks from your plug wires. Sparks will indicate bad wires. There are many causes for your car to run poorly. It could be a bad coil or plugs ,sticky valves to burnt valves. Bad gas, water in gas, ect. My daughter had a problem that sounds similar, it turned out thatfor her last oil change at Walmart they only added 5qts of oil without draining it first. 1.5 gallons over full of oil caused engine to fight against itself to run. She was lucky it didn't destroy the engine and every gasket in it.

Jun 01, 2014 | 1997 Lexus LX 450

1 Answer

2003 ZX2 oil in plugs


it means the oil is going past the oil rings on your piston .three things can do that .you have used the wrong oil. use 20/40 for older cars .the piston rings are sticking in the pistons.or crankcase back pressure .in which clean your breather system. but you cant clean it to you remove the oil.remove all the spark plugs .turn over the engine the oil if there will come out of the holes.spray carb cleaner in the holes only a small amount .clean and refill the spark plugs.start your engine lit it tick over.if running put an engine flush in the engine on tick over about 15 min then drain it refill with 20/40 oil .

May 13, 2013 | 2003 Ford ZX2

1 Answer

Oil change 1994 Cadillac Eldorado


well let me see you have 4.6L engine you need 7.5 quarts of oil with new oil filter.to do the oil change you need large drain pan and oil filter wrench and a metric wrench to remove oil drain plug you need a funnel also.you need first start engine let it run for 5 minutes to warm up thin out the oil so it will flow better.once engine warm up.turn off the engine.open you hood.now safely raise support vechicle on jack stands make sure vechicle parked on solid level ground.place large drain pan under oil pan remove oil drain plug you need a 15m wrench remove drain plug let all old oil drain out until you see slow drip then reinstall oil drain plug dont over tighten drain bolt.then place drain pan under the oil filter then remove oil filter using oil filter wrench or large channel lock pliers.once you remove oil filter wipe oil filter seal surface with clean paper towel.take new oil filter add oil to new filter then install new oil filter hand tight take filter wrench turn oil filter one half more turn dont over tighten will damage oil filter seal.make sure oil pan drain plug is in place. then lower vechicle. remove oil filler cap on the valve cover add new oil to the engine using a funnel to keep from spilling oil all over the valve cover and exhaust manifold.add all 7.5 quarts to oil crank case wait until oil settle down in crank case check oil dip stick oil level should be at the full mark on oil dip stick.dont over fill crank case.once you finished oil level correct crank engine check for oil leaks at oil filter and oil drain plug. if engine running okay you see no oil warning lights you ready wheel and deal.

Nov 20, 2011 | 1994 Cadillac Eldorado

1 Answer

EZGO 4 stroke petrol engined golf cart how do you service it


Change air filter, oil, spark plug, cable to battery, When changing the oil, there is no need for a new filter. Just wash the old one with carb clean. Held in by 3 small bolts beside the drain plug. Check the rear end oil (90 weight) use the upper plug. Fill till it runs out. Grease the front end. Change the fuel filter. Drain the carb if it is going to sit thru the winter.

Oct 07, 2011 | 1995 Volkswagen Golf

1 Answer

What parts do i needed for a tune up on a kia 2004 saoda


write down the manufacture date the vin number engine type and capacity eg1.5,1.8,2.0 armed with this info head down to your parts shop you will need. oil correct grade for your car 5litres will be more than enough or just right for 4 cyl. oil filter spark plugs some cars use irridium or platinum with some cars these do have standard equivilant that are cheeper fuel filter air filter a can of throttle body cleaner to clean the throttle body jack up the car sit it on stands never trust a jack remove the drain plug from the sump drain the oil into suitable dish or container and dispose of it responsibly replace the sump plug and tighten it firm locate and remove oil filter fit new filter spin it on then tighten by hand half a turn locate and change fuel filter dont forget to inspect filters for leaks when service is finished add new oil to correct level start engine run til oil light has gone out swich off recheck oil level remove spark plug leads mark them or do one at atime change spark plug put leads back on open air box remove old filter loosen clamp on air intake where it fits on to engine at throttle body move out of the way hold butterfly open and spray with cleaner to remove built up deposits a small bottle brush is good to get inside refit the air intake pipe and filter the cleaner will make the engine run a bit rough you may have to wind it a bit to start it it will clear itself after running for a short time be shaw to refit any plugs or connectors and pipes

Apr 06, 2011 | 2004 Kia Sedona

2 Answers

Changed spark plugs and one old one covered with oil. What is the problem?


If you notice smoke when you first start the engine, it may be that the rings are worn,or the valve guides in the heads are worn, and the valve seals may have failed. Also the oil may be cavitating in the valve covers, and not running down to the pan, as the engine is running.The oil drain holes may be plugged up from sludge! And the pcv valve may be plugged! Verry high mileage,not enough oil changes?

Sep 09, 2010 | 1997 Lincoln Town Car

2 Answers

How often should I change the Transmission fluid, normal driving ? Thank you Gary


It's listed in your owner's manual. Schedule A is normal driving conditions.
SCHEDULE "A"
7,500 miles (12 000km) or at 6 months
- Change engine oil.
- Replace engine oil filter.

15,000 miles (24 000km) or at 12 months
- Change engine oil.
- Replace engine oil filter.

22,500 miles (36 000km) or at 18 months
- Change engine oil.
- Replace engine oil filter.
- Inspect front wheel bearings.
- Inspect brake linings.

30,000 miles (48 000km) or at 24 months
- Change engine oil.
- Replace engine oil filter.
- Replace engine air cleaner filter.
- Replace spark plugs.
- Drain and refill automatic transmission fluid and filter (4.7L).

37,500 miles (60 000km) or at 30 months
- Change engine oil.
- Replace engine oil filter.
- Drain and refill automatic transmission fluid and filter (5.2L/5.9L).
- Drain and refill transfer case fluid.

45,000 miles (72 000km) or at 36 months
- Change engine oil.
- Replace engine oil filter.
- Inspect front wheel bearings.
- Inspect brake linings.
- Flush and replace engine coolant at 36 months, regardless of mileage.

52,500 miles (84 000km) or at 42 months
- Change engine oil.
- Replace engine oil filter.
- Flush and replace engine coolant if not done at 46 months.

60,000 miles (96 000km) or at 48 months
- Change engine oil.
- Replace engine oil filter.
- Replace engine air cleaner filter.
- Replace ignition cables (5.2L/5.9L).
- Inspect PCV valve, replace as necessary.
- Replace spark plugs.
- Inspect auto tension drive belt and replace as necessary (5.2L/5.9L).
- Drain and refill automatic transmission fluid (4.7L).

67,500 miles (108 000km) or at 54 months
- Change engine oil.
- Replace engine oil filter.
- Inspect front wheel bearings.
- Inspect brake linings.

75,000 miles (120 000km) or at 60 months
- Change engine oil.
- Replace engine oil filter.
- Drain and refill automatic transmission fluid and filter (5.2L/5.9L).
- Drain and refill transfer case.
- Flush and replace engine coolant if it has been 30,000miles (48 000km) or 24 months since last change.
- Inspect auto tension drive belt and replace if required.

82,500 miles (132 000km) or at 66 months
- Change engine oil.
- Replace engine oil filter.
- Flush and replace engine coolant if it has been 30,000miles (48 000km) or 24 months since last change.

90,000 miles (144 000km) or at 72 months
- Change engine oil.
- Replace engine oil filter.
- Replace engine air cleaner filter.
- Replace spark plugs.
- Inspect front wheel bearings.
- Inspect brake linings.
- Inspect auto tension drive belt and replace as necessary.
- Drain and refill automatic transmission fluid (4.7L).

97,500 miles (156 000km) or at 78 months
- Change engine oil.
- Replace engine oil filter.

105,000 miles (168 000km) or at 84 months
- Change engine oil.
- Replace engine oil filter.
- Flush and replace engine coolant if it has been 30,000 miles (48 000km) or 24 months since last change.
- Inspect auto tension drive belt and replace if required.

112,500 miles (181 000km) or at 90 months
- Change engine oil.
- Replace engine oil filter.
- Drain and refill automatic transmission fluid and filter (5.2L/5.9L).
- Inspect front wheel bearings.
- Inspect brake linings.
- Flush and replace engine coolant if it has been 30,000 miles (48 000km) or 24 months since last change.

120,000 miles (192 000km) or at 96 months
- Change engine oil.
- Replace engine oil filter.
- Replace engine air cleaner filter.
- Replace ignition cables (5.2L/5.9L).
- Inspect PCV valve, replace as necessary.
- Replace spark plugs.
- Inspect auto tension drive belt and replace as necessary.
- Drain and refill automatic transmission fluid (4.7L).

Thanks for using FixYa -a 4 THUMBS rating is appreciated for answering your FREE question.

Sep 05, 2010 | 2001 Dodge Durango

2 Answers

How do you change the oil filter on a Hyundai Accent 1998/99?


Replace the oil filter after draining the old oil, and" BEFORE "adding new fresh oil, otherwise you'll be dump all that fresh oil, on the ground,while you "TRY to get the new filter installed.

Step 1 Remove drain plug,Drain oil into drain pan
Step 2 Remove oil filter
Step 3 Reinstall drain plug,qnce oil has drained.
Step 4 Fill new filter with oil,lube seal on filter.
Step 5 Install new filter, Add fresh oil to proper level.replace filler cap
Step 6 Run engine check for leaks.
Happy motoring!

May 23, 2008 | 1999 Hyundai Accent

Not finding what you are looking for?
2000 Isuzu Rodeo Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14384 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...