- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
to know for sure a raitator tester would find a leak for you it goes on where your cap is you pump it up and it shows a gauge for the lbs if the pressure goes down there's a leak and with alot of pressure it will make a sound of where it's coming from. good luck hope i helped
The radiator tanks develope cracks in the base and leak under pressure, to replace remove plastic cover across body under windscreen to get access to tank then removal is easy you might have to remove plastic inside mudguard
The water (coolant) in the expansion tank will rise and fall with the engine temperature. What the expansion tank does is collect and return coolant to and from the engine. When the engine warms up the coolant gets hot, builds up pressure and opens up the radiator cap. The coolant then goes into the expansion tank. Now when the engine cools down the pressure drops in the cooling system and the pressure drop (vacuum) pulls the coolant back into the engine via the radiator cap. The radiator cap allows the cooling system to build up pressure and by doing so increases the boiling point of the coolant, but when that pressure exceeds the caps rating the cap opens and the coolant goes to the expansion valve. The cap has another part to it that when the engine cools down and a partial vacuum is created in the cooling system a "valve" in the radiator cap opens and allows the coolant to be drawn back into the engine. I would look at your radiator cap to see if any gunk or build up is on it, and check the rubber gaskets for cracks. It's easiest just to replace the cap because they are inexpensive and easy to replace (2-10 dollars). The expansion tank should have two hoses on it. The one on the bottom comes from the radiator and the one on the top (possibly part of filler cap) runs down and is open to the ground. That way if it is overfilled or becomes overfilled it will slowly leak onto the ground. When and if you change your radiator cap, make sure the engine is cooled down, remove cap and start engine and turn heater to full blast, full heat. Leave the cap off and let it run until engine warmed up. This should burp out any air pockets that may have happened when coolant was changed. Also top off the coolant in the radiator while it is running. Hope this helps and good luck
there can be a yellow light in the cluster that looks like a small radiator or box with waves inside of it to indicate water. This light means that the coolant level sensor has detected a low coolant level. Typically the expansion tanks inside of these cars will crack from heat and age. A simple diagnosis is to check your coolant level and top it off. Do not forget to bleed it by unscrewing the bleeder screw found on the upper radiator hose while filling up the reservoir found on the right hand side of the radiator. once the coolant has been filled, tighten the bleeder screw back down but be careful not to over tighten. and finally screw on the expansion tank cap. run the vehicle to operating temperature and use a flashlight to inspect the engine bay for leaks. If there is a leak, it will need to be repaired. possible leaks are a cracked expansion tank, leaking radiator hoses, or a leaking water pump or thermostat.