Question about 2001 Chrysler Town & Country

1 Answer

1997 Mercury Villager - Odometer is irratic between zero and the speed I am driving at. If I am using cruise control, the cc disengages. Would this problem possibly be the cable, a sensor or an internal tranny problem?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 4,369 Answers

Need more info, but you have a vehicle speed sensor in the transmission that sends an electrical signal to your speedometer.
Your speedo the transforms the signal and sends it to the tachometer and the engine control computer (PCM).
There is no cable for the speedo in this van.
The speed sensor is very hard to remove due to corrosion, but you can clean the two terminals on the sensor to see if that fixes it.
The VSS is on top of the trans, drivers side, rear. Acesss from above or below.
Push release cilp and lift up on the conector. Clean with product from radio shack.

more help here
http://autos.groups.yahoo.com/group/villagerquest/1997 Mercury Villager - Odometer is irratic - f9ce2d2.gif

Posted on Apr 12, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Cruise control notworking on a 2002 F150


cruise controls are controlled by the following switches and sensors
1 the switch itself
2-- the clutch pedal sensor or the VSS in the auto transmission
3 the brake sensor ---4-- the gear change switch or selector
5-- the engine speed sensor ( tacho)
6-- the road speed (VSS )
if 1 or a combination is not working or is outside parameters , the cruise control will not switch on
the road speed in a manual is set at around 20 mph and any less will not engage cruise control(CC)
changing gears in a manual will disengage CC
touching the clutch pedal will not allow engagement or will disengage CC
for some sensors run the fault codes

Nov 05, 2015 | 2002 Ford F150 Regular Cab

1 Answer

97 mercury villager p1400 code.stumble when I exellarate..? Stumped. ....


Possible Causes
  • EGR/EVAP solenoid connector is damaged (check pins for damage, moisture)
  • EGR/EVAP solenoid control circuit open or shorted to ground
  • EGR/EVAP solenoid has failed
  • PCM has failed
Setting Conditions:
Engine running at Cruise speed under light engine load; and the PCM detected an unexpected voltage on the EGR/EVAP solenoid control circuit.

Sett

Jun 13, 2015 | 1997 Mercury Villager

1 Answer

2002 mercury villager estate cruise control won't work ,hasn't worked since i got it


there is a cruise control module under the hood on the drivers side fender

Feb 06, 2013 | Cars & Trucks

1 Answer

2000 mercury villager, runs a fast idle. whether cold or warm the idle remains at a high idle speed, it even pulls with the brake applied.


Could be a vac leak, or a dirty throttle body, or a faulty idle air control valve. The computer controls idle speed by regulating the amount of air into the intake. Could also be something pulling on the throttle cable such as the cruise control.

Sep 28, 2012 | 2000 Mercury Villager

1 Answer

I had my 1995 mercury villager worcked on and now the cruse controll wont work,the light comes on but when you push the buttons on the streen whell the light on the dash it just blenks but wont kick in...


check for clean connection at vehicle speed sesnor on top rear of trans. 2 pin connector.
does speedo and odometer work?

yahoo group for villager quest owners

Jul 16, 2011 | 1995 Mercury Villager

1 Answer

Speedometer, odometer, and cruise quit working


clean the 2 wire connector on the speed sensor on top of trans, driver side, rear of trans.

VSS is hard to remove in rust climates so hope it's the connector.

go here too

http://groups.yahoo.com/group/villagerquest/

could be speedo gear attached to VSS.

Jan 02, 2011 | 1997 Mercury Villager

1 Answer

98 Honda Accord odometer, speedometer and cruise control all died


check the fuse for the gauges and if not check speed sensor

Sep 22, 2009 | Honda Civic Cars & Trucks

2 Answers

1997 mercury villager with loss of power


2001 mercury villager engine looses power speedometer goes to zero<br /><br />

Aug 24, 2009 | Mercury Villager Cars & Trucks

1 Answer

Cruise Control on a 94 Mercury villager


sounds like vacuum line came off speed control servo or engine intake manifold.

http://groups.yahoo.com/group/villagerquest/

Apr 15, 2009 | 1995 Mercury Villager

Not finding what you are looking for?
2001 Chrysler Town & Country Logo

Related Topics:

748 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...