Cant find the third hook for middle seat belt in the back seat

i think my new 2012 toyota corolla back seat seat belt are put in incorrectly from factory.

the right belt clip buckle clip says"Center" when it should be right, and the center is the right. so when i buckle the back seat belts they are kinds crossing each other . Why ? any suggesions?

Hi.

The inertia reel has not been mounted properly. Replacing Toyota belts is quite tricky. Follow the step by step procedure illustrated in manual below. Belts are included in seat removal procedure (clearly do not remove seat). Check chapter starting at page 183/184 in manual below.

Please refer to pages from 184 onward in this service manual.

Regards.

Ginko.

There are supposed to be three locks. It is common for seats like this for the lock to fall to the back or under side of the seat. Try taking the bench cushion off and see if you can find it. Did you buy this car used? if so and you cant find the seat belt take it to them. It is supposed to be there

it should be tucked between the seat cushion and back rest,slide your hand down and pull it up..

You have to unbolt the seat and then you can change the belt

there is a belt tensioner near the back of the engine, you need a 19mm wrench to loosing the tension and remove teh belt

You have a problem with the pass seat belt or the wiring to it.P/T stands for pretensioner. when the air bag deploys the seat belts tighten.
Be carful with the seat belt it contains an explosive.

Sounds like a mechanicel problem in the belt box. Do you have a guarantee for that car?

A new one is in order.

it has a belt